HP D7171A - NetServer - LPr User manual
HP NetServer LH 3
with
NetRAID-3Si (HP Rack Storage/12 and /8)
Cluster Configuration Guide
29 March 2000
(see Version History at the end of this document)
Introduction
This document defines the supported HP NetServer LH3 configurations with HP Rack Storage/12s and /8s
and Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide
maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is
prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can
result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and
therefore will not be supported by HP.
What’s Defined in Cluster
•Cluster
•SPUs
•Local and Shared Storage
•Intra-cluster and Client LANs
•Shared Storage Cabling
Cluster
Type of SPUs HP NetServer LH 3
Each node must be the same model SPU, but may have different size main
memory, cache, and CPU clock speeds.
Installation Pedestal or racked
Number of nodes 2
Shared Storage HP Rack Storage/12 or Rack Storage/8 with HP NetRAID-3Si controller and
HP disks. See Shared Storage below.
LANs:
Client LAN Any NIC that is HP and Microsoft approved. See Client LAN below.
Intra-cluster
(Heartbeat) LAN HP D5013A/B with crossover cable. See Intra-cluster LAN below.
Power source Direct from power mains, power conditioner or uninterruptible power supply
(UPS) using any power conditioner or UPS.
2
System software:
Navigator version L.15.15 or later (350-450 MHz with 40 MB/Sec SCSI controller board)
L.16.00 or later (400 or 450 MHz with 80 MB/Sec SCSI controller board)
L.16.05 or later (500, 550, 600 MHz with 40 MB/Sec SCSI controller board)
Operating System Microsoft Windows NT Server 4.0, Enterprise Edition
Service pack SP4 or later
SPU
Model HP NetServer LH3
Clock speed 350, 400, 450 MHz with Rack Storage/12 D5989A
400, 450, 500, 550, 600 MHz with Rack Storage/12 D5989B
No. of CPUs 2
BIOS version 4.06.28PL or later (350-450 MHz with Rack Storage/12 D5989A)
4.06.14PL or later (400 or 450 MHz with Rack Storage/12 D5989B)
4.06.33PL or later (400, 450, 500, 550, 600 with Rack Storage/12 D5989B
CPU cache Any size
RAM 128 MB minimum. Must be HP.
No. of power supplies 2 required, 3 for redundancy
Local storage Internal or external, using any controller except embedded RAID or a
NetRAID-3Si. Must use HP disks. See
Local Storage below.
I/O slots: P7 – P8 Shared storage controller
P1 – Intra-cluster (Heartbeat) LAN
P2 – Client LAN
All others – Any other plug-in cards.
Storage
Local
Controller and Cabinets
(physical drive location) May use Embedded SCSI, NetRAID 1, NetRAID-1Si or NetRAID 3 in
PCI slot P8 for internal storage or with a Rack Storage/8, otherwise any
controller listed on the HP Tested Products List.
May not use Embedded RAID or NeRAID-3Si for internal storage or
external with a Rack Storage/12.
Disk drives (hot swap
or fixed) HP only
SCSI bus Any HP cables that meet SCSI specifications and any SCSI bus speed.
SCSI IDs Any
Shared
Controller
Model HP NetRAID-3Si Adapter D5955A
No. of controllers 1
Firmware W.01.20
BIOS B.01.10
Driver 2.22
NetRAID Assistant A.01.15 or later
SPU I/O slot P7 - P8
SCSI ID 6, 7
Channels 0, 1, 2
3
RAID level 1, 5, 10, 50
Logical disks 1 per RAID array
8 maximum per NetRAID-3Si adapter
Configuration
options: Cluster mode on
Cache write-policy to Write thru
Set bus speed for Rack Storage/8 to Ultra
Set any other options as you prefer
Cabinet
RAID arrays A RAID array (logical disk) must be composed of all the same disk model
(i.e., part number and suffix). Different size or speed disks are not
allowed in the same RAID array. Any combination of disk models is
allowed on a SCSI channel and in a cluster.
Number and mix of
cabinets 1 – 3, any mix of RackStorage/12s and Rack Storage/8s.
Rack Storage/12:
Model D5989A and 1 D6025A for each Rack Storage/12 (350-450 MHz, Nova 1)
D5989B and 1 D6025B for each Rack Storage/12 (400-450 MHz, Nova 2)
Disk drives: HP 4.2 GB Ultra SCSI Disk Module D6104A
HP 9.1 GB Ultra SCSI Disk Module D6106A
HP 9.1 GB (10k rpm) Ultra SCSI Disk Module D6107A
HP 18.2 GB Ultra SCSI Disk Module D6108A
HP 18.2 GB (7200 rpm) Low Profile Ultra SCSI Disk Module D7174A
HP 36.4 GB (10k rpm) Ultra SCSI Disk Module D8210A
Cables Any 2 HP LVD SCSI cables from the following list:
1 meter D7131A
2.5 meter D6020A
5 meter D6982A
10 meter D6983A
Rack Storage/8:
Model D4902A
Disk drives: HP 4.2 GB Ultra SCSI Disk Module D3583C
HP 4.2 GB (10k rpm) Ultra SCSI Disk Module D4903A
HP 9.1 GB Ultra SCSI Disk Module D4289A
HP 9.1 GB (10k rpm) Ultra SCSI Disk Module D6019A
HP 18.2 GB Ultra SCSI Disk Module D5039A
NOTE All disks in a Rack Storage/8 must be the same speed.
Cables HP D5957A Cluster Adapter (2 required per HP Rack Storage/8)
NOTE If both channels 0 and 2 of the NetRAID Adapter are used, then
cable D7131A must be used with Cluster Adapter D5957A on both
channels.
4
LANs
Intra-cluster (Heartbeat) LAN Client LAN
LAN connection HP D5954A crossover cable or any
equivalent. Any LAN
The intra-cluster LAN may only be
used for cluster node
communication via a crossover
cable. It may not be used for client
communication.
NIC:
Model HP D5013A/B (10/100TX PCI) Any that is on both the HP
Tested Products List and the
Microsoft Hardware
Compatibility List.
Driver 3.00.06.004 or later Any driver
If the NIC used is the same as
the Intra-cluster LAN, then the
Client LAN must use the same
driver as the Intra-cluster LAN.
No. of NICs 1 1 minimum
SPU I\O slot P1 P2
5
Shared Storage Cabling
This part of the guide defines the allowable cabling configurations for clusters using the HP NetServer
LH 3 and HP Rack Storage/12s and /8s. Only these cabling configurations and cables are supported.
HP Microsoft Cluster using the HP Rack Storage/12
6
HP Microsoft Cluster using the HP Rack Storage/8
7
HP Microsoft Cluster Server Power Cabling
(Rack Storage/12 shown. Rack Storage/8 is the same except for the rear view)
8
Version History
29 March 2000 Added support for NetRAID-1Si as a local storage controller.
18 January 2000 Added 500, 550, and 600 MHz SPUs for use with Rack Storage/12 D5989B
(80 MB/Sec SCSI bus).
9 September 1999 Added 36.4 GB drive for shared storage and for added RS/12 D5989B and
1 D6025B (80 MB/Sec SCSI bus) for 400-450 MHz.
26 July 1999 Corrected inconsistency in document. Under Shared Storage changed "P3"
to "P7-P8" for the SPU I/O slot.
14 July 1999 Revised the No. of Power Supplies specification from "2 - 3" to "2 required,
3 for redundancy." Revised the ac power cabling diagram to depict
applying HP NetServer power from separate power circuits.
25 May 1999 Added two 18.2 GB disk drives for use with the Rack Storage/12. These
are the D7031A HH 10K rpm disk drive and the D7174A low profile 7200
rpm drive.
3 May 1999 Initial release.
Other manuals for D7171A - NetServer - LPr
117
This manual suits for next models
14
Table of contents
Other HP Server manuals
HP
HP T5145 - Thin Client - Tower User manual
HP
HP ProLiant MicroServer Gen8 User manual
HP
HP ProLiant DL360 Generation9 User instructions
HP
HP ProLiant SL390s G7 2U Manual
HP
HP ProLiant SL165z - G6 Server User manual
HP
HP t5325 - Thin Client Operating and maintenance manual
HP
HP PROLIANT DL160 G5 User instructions
HP
HP ProLiant BL490c Generation 7 (G7) User instructions
HP
HP D7171A - NetServer - LPr User manual
HP
HP ProLiant DL320 G6 Server User manual
HP
HP D7171A - NetServer - LPr User manual
HP
HP BL35p - ProLiant - 2 GB RAM User manual
HP
HP Integrity rx4640 Installation and operation manual
HP
HP Tc4100 - Server - 256 MB RAM Instruction Manual
HP
HP LC2000r - NetServer - 128 MB RAM Service manual
HP
HP t5745 - Thin Client User instructions
HP
HP 117755-003 - ProSignia - 740 User manual
HP
HP ProLiant BL40p Manual
HP
HP T5125 - Compaq Thin Client Owner's manual
HP
HP Apollo 4200 Gen9 Assembly instructions
