DO NOT REMOVE END CAPS WITH A
SCREWDRIVER!
For Snap Cap End Caps
For Standard End Caps
3. Remove inner end cap by inserting the frame at an angle into the inner end cap about 1".
Pull gently towards you to remove. Remove spacer.
1. Remove roller from frame. Pull frame out from inner end cap until a snap is heard, or lightly tap outside rim
of end cap with hammer. Use extreme caution - do not hit black ring on frame.
2. Remove roller cover from frame. Remove spacer
from frame.
First Determine if your PAINTSTICK or
PAINTSTICK EZ-TWIST came with or without
a snap cap frame:
A. WITHOUT snap cap frame – Standard
B. WITH snap cap frame
4. Remove outer end cap by inserting the frame inside the roller cover at a slight angle. Gently push to snap
off the outer end cap from the frame.
5. Discard old end caps. Using petroleum jelly,
lubricate outer and inner end caps. Assemble
roller cover.
6. If the fit is loose apply tape to the circumference
of the end caps to prevent paint from leaking
during operation. See picture for the correct
placement of the tape. Masking tape or plumbers
tape work well.
7. Put roller cover back onto frame until a snap
is heard.
Consult PaintStick or PaintStick EZ-Twist
instruction manual for further information.
A
B
Check out the collection of brushes, rollers & trays we offer.
