Electrolux 6000 Operating instructions

Essentia

Suggested for you

For more Accessories & Consumables

please look at our Catalogues or contact

our Electrolux Service Partner.

Line 6000

Tumble Dryers

every

months

6Check the drain and the

drain pipe are not obstructed

(for heat pump models)

every

months

5Check that the air intake is

not obstructed by dirt and

clean it if necessary

daily

4Check that the door gaskets

are clean and not damaged

every

months

7Clean the surface of the drum with

citric acid and, if necessary, an

abrasive sponge making sure that

any recidues are taken oﬀ

daily

2Clean the ﬁlter by removing the lint.

During intensive use, even after

every cycle

per

1week

3When the notiﬁcation is displayed,

check that the second lint ﬁlter is clean

(remove the lint) and not damaged

daily

1Remove any lint around

the machine

0W1Y2F

Stainless Steel

Trolley BV-220 /

BV-131lt

0W1XFY

Canvas Trolley

RV-74 - 200 lt

0W21DK

Soft Care

sheets to soften

and scent your

laundry, 30 pcs

0W21DH

Dryer balls

2 pieces

0W1Y2C

Bulk Transport

Cart HV-52

0HM803

Brush with

chain - 850mm

Cleaning external surfaces

Wash the external surfaces with warm, soapy water. Avoid using detergents containing abrasive substances, steel wool, brushes or

steel scrapers. Rinse with a damp cloth and dry carefully. Avoid using chlorine or ammonia-based products. Clean the control panel

with a soft cloth dampened with water and, if necessary with neutral detergent. Do not wash the equipment with direct or high pressure

jets of water. With the aim of reducing the emission of polluting substances into the atmosphere, it is advisable to clean the equipment

(externally and, when neccessary, internally) with products that have a biodegradability exceeding 90%. Electrolux Professional

strongly recommends to use Electrolux Professional approved cleaning agents, rinse and descaling agents to obtain better results

and maintain product eﬃciency over time. Damages caused by cleaning, as a consequence of use of not approved cleaning agents,

rinse and descaling, will be excluded by the warranty.

The operations described must be performed wearing the needed Personal Protection Equipment. Refer to the User Manual.

05UMW04___ENG00L6

User maintenance guide

Planned Maintenance Programmes

In order to ensure the safety and performance of your equipment,

it is recommended that regular service is undertaken every

12 months by Electrolux Professional authorised engineers

in accordance with the manufacturer recommendations.

Please contact your local Electrolux Professional Service

Centre for further details of service agreements available.

2020-04-02

Anomaly Description Instructions to User

12:1 Machine indicates that Inlet air over heat protection

has cut out Switch off power to the machine and contact authorized service

12:2 Machine indicates that Outlet air over heat protection

has cut out Push the control knob to restart the program

12:8

(for condense

models)

Machine indicates that condense water tank has

not been drained within set time

1. Turn the machine off and on again. Condensate pump will start

2. If water is coming out of the condensate drain hose, it might be

partly blocked. Contact authorized service

3. If the pump is running and no water coming out the drain is

blocked. Contact authorized service

12:11 (for models

with RMC system)

Machine indicates garment is not dry within max drying

time (RMC)

1. Check that the dryer is not overloaded

2. Open the door to reset the error message

12:12 (for models

with RMC)

Machine indicates garment is not dry within max drying

time (AUTOSTOP)

1. Check that the dryer is not overloaded

2. Check that the garments are not loaded too wet after extraction)

3. Open the door to reset the error message

12:13 (for models

with RMC)

Machine indicates garment is not dry within max drying

time (TIME) Open the door to reset error message

12:14

(for gas models)

Machine indicates flame sensor is not detecting gas

flame within set time

Reset the error message by a short push on the control knob

Check the gas supply

12:15 Machine indicates vacuum switch is not activated

within set time

Check that machine is not overloaded

Check that Doors are closed and seals are in good order

Press the control knob to clear error message and restart program

12:18 Machine indicates vacuum switch has deactivated

several times during program run

Redistribute the load in the drum

Press control knob to clear message and restart the program

12:19 (Heat Pump

models) Machine indicates blocked air flow in heat pump unit Clean lint filter

Press control knob to clear message and restart the program

12:253 Machine indicates that Jumper 1 is missing Press control knob to clear message and restart the program

17:20 (Heat Pump

models) Machine indicates critical error in heat pump unit Switch off power to the machine for 5 minutes and then on again

Try to start a new program

17:21 (Heat Pump

models) Machine indicates internal error in heat pump unit Switch off power to the machine for 5 minutes and then on again

Try to start a new program after HP initializing has finished

20:1 Machine indicates drum motor is overheated Wait 30 minutes to allow the motor to cool down

Press the control knob to clear error message

30:1 Machine indicates fan motor overheated Wait 30 minutes to allow the motor to cool down

Press the control knob to clear error message

Essentia

Other manuals for 6000

Other Electrolux Dryer manuals

Electrolux

Electrolux EDI 96150 W User manual

Electrolux

Electrolux T5130 User manual

Electrolux

Electrolux EDP2074GDW User manual

Electrolux

Electrolux EDS7051 User manual

Electrolux

Electrolux TW L4 E User manual

Electrolux

Electrolux DC6-8HP Q Series User manual

Electrolux

Electrolux EDC 77550W User manual

Electrolux

Electrolux EDC78550W User manual

Electrolux

Electrolux EW9H3866MB User manual

Electrolux

Electrolux FER641FS User manual

Electrolux

Electrolux EW6C527G2 User manual

Electrolux

Electrolux EDE421E User manual

Electrolux

Electrolux EDV854N3SB User manual

Electrolux

Electrolux EDE1074PDW User manual

Electrolux

Electrolux Affinity Assembly instructions

Electrolux

Electrolux EDE 36150W User manual

Electrolux

Electrolux Tumble dryer User manual

Electrolux

Electrolux TWL3E300 User manual

Electrolux

Electrolux EW8H2966IR User manual

Electrolux

Electrolux EIMGD60JMB0 User manual

Electrolux

Electrolux 864512 User manual

Electrolux

Electrolux EDS805JQWA User manual

Electrolux

Electrolux EDC 3150 User manual

Electrolux

Electrolux EDE 425 M Quick guide

Popular Dryer manuals by other brands

Bosch

Bosch WTA79200GB Installation and operating instructions

Amana

Amana W10233410A Use and care guide

Miele

Miele TWH 780 WP operating instructions

Asko

Asko T760 user guide

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Original instructions

Bosch

Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Operation and installation

Beko

Beko DS8433RX1M user manual

Dawlance

Dawlance Spinner DS 6000 C owner's manual

AEG

AEG TR838P4OB user manual

Indesit

Indesit IDV 75 instruction manual

Infiniton

Infiniton SD-DG85C manual

BOMANN

BOMANN WT 5019 instruction manual

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Installation

Asko

Asko T793C operating instructions

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer installation instructions

Frigidaire

Frigidaire CAQE7077KW0 use & care

Bosch

Bosch WTX8HKM9SN User manual and installation instructions