Eaton Advantage CLMT1307 User manual
Measure distance between
release bearing and clutch
brake.
If measurement is not
between 0.490" and 0.560",
reset clutch. Go to step 2.
Tool Part Code:
RR1005CL
1
Release
Bearing Clutch
Brake
Correct distance =
0.490"- 0.560"
Use tool during resetting
procedure to move cam
to New position.
User Guide
Eaton
Solo Advantage®Heavy-Duty
Clutch Reset Tool
CLMT1307
February 2012
Copyright Eaton Corporation, 2012.
Eaton hereby grant their customers,
vendors, or distributors permission
to freely copy, reproduce and/or
distribute this document in printed
format. It may be copied only in
its entirety without any changes or
modifications. THIS INFORMATION
IS NOT INTENDED FOR SALE OR
RESALE, AND THIS NOTICE MUST
REMAIN ON ALL COPIES.
Note: Features and specifications
listed in this document are subject to
change without notice and represent
the maximum capabilities of the
software and products with all options
installed. Although every attempt has
been made to ensure the accuracy of
information contained within, Eaton
makes no representation about the
completeness, correctness or accuracy
and assumes no responsibility for
any errors or omissions. Features and
functionality may vary depending on
selected options.
For spec’ing or service assistance,
call 1-800-826-HELP (4357) or visit
www.eaton.com/roadranger.
In Mexico, call 001-800-826-4357.
Eaton Corporation
Vehicle Group
P.O. Box 4013
Kalamazoo, MI 49003 USA
800-826-HELP (4357)
www.eaton.com/roadranger
Printed in USA
Roadranger: Eaton and trusted partners
providing the best products and services in the
industry, ensuring more time on the road.
Have assistant
hold clutch
pedal down.
Install and tighten 4 shipping bolts
(7/16" x 14 x 1-3/4 UNC) to remove
gap between sleeve and pin.
Release clutch
pedal.
Remove 4 shipping bolts.
Push pedal down
and squeeze clutch
brake 5 times to
reposition bearing.
Position tool:
•Through access panel
•Under release bearing
•Threaded bolt in cam
slot
Use tool to move cam
to New position.
3
If cam does not move, loosen transmission
and install 1/2" spacers between clutch
housing and engine housing to increase
stroke.
With spacers in place:
•Have assistant hold clutch
pedal down
•Use tool to move cam to
New position
•Release clutch pedal
Remove spacers and torque
transmission mounting bolts.
6
7
8
Verify reset. Go to step 1.
10
9
4
5
Before
Shipping
Bolt
Gap
No
Gap
Sleeve
Pin
Access
Panel
After
Hold
5x
Release
2
Other Eaton Tools manuals
