DT Research DT363GL Assembly instructions
Rugged Handheld Tablet
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
Copyright © 2021, DT Research, Inc. All Rights Reserved. BOG082321 DT363GL/ 363Q ENG LT
INTRODUCTION
Thank you for acquiring the DT363GL/ 363Q, part of DT Research’s line of Rugged
Tablets. Featuring a slim yet robust enclosure, the DT363GL/ 363Q with 6” TFT
display is powered by the Intel® Pentium® Silver quad-core or Qualcomm octa-core
processor, offering optimal combinations of performance and power savings. The
DT363GL/ 363Q is available with Microsoft® Windows® or Android operating system.
The software operating system features web browser, client/ server computing
software, media player, accessories, and applications support.
PACKAGE CONTENTS
• One DT363GL/ 363Q
• One Baery Pack
• AC-DC Power Adapter
• Basic Operaon Guide
* The actual package contents may vary depending on the conguraon acquired.
DT363GL/ 363Q
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in
a residenal installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in
conjuncon with any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
Button Functions
BUTTON ACTION
Power Buon
Trigger Buons
Baery Latch
USB Type-C Port (power input)
SIM Card Reader (363Q)
SD Card Reader (363Q only)
Smart Card Reader (DT363GL only)
SIM Card Reader (DT363GL)
Speaker
Microphone
Barcode Scanner (oponal)
Front Camera (oponal)
Back Camera (oponal)
NFC/UHF RFID Reader (oponal)
1
2
3
C
D
E
B
A
2
PRECAUTIONS
• Always exercise care when operang and handling the DT363GL/ 363Q
• Do not disassemble any poron of the DT363GL/ 363Q, as this will void any
product warranty.
• Do not use any power adapter or charging cradle other than the one provided with
the tablet or acquired from the manufacturer or its partners.
• In the unlikely event that abnormal noise, strange odor, or smoke is present,
immediately power down the DT363GL/ 363Q and disconnect all power sources.
Please report the problem to your device provider immediately.
The DT363GL/ 363Q
A
B C
D IE J
G
K FH 1 32
F
G
H
I
J
K
Foldable
Antenna
3
OPERATION
Powering ON and OFF
To acvate DT363GL/ 363Q, push and quickly release the Power Buon. The display
will come on in a few seconds. To put the DT363GL/ 363Q in standby mode, push and
quickly release the Power Buon. To turn the DT363GL/ 363Q o for extended storage,
power o safely using any soware funcon that “shuts down computer” provided in
the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power - please use
the AC-DC adapter with the DT363GL/ 363Q when seng up for the rst me to
fully charge the baery pack.
NOTE:
To conserve power, push and quick release the Power Buon to put the tablet in
standby mode while not in use. Pushing briey on the same buon will wake up
the system.
NOTE:
When the baery pack is charging, the blue-colored Baery LED should blink
slowly. If plugging in the AC-DC adapter does not trigger this blinking acvity
and the LED stays dark, the baery pack(s) may have been drained substanally.
Unplug/ replug the AC-DC adapter to the DT363GL/ 363Q a few mes to
acvate the charging process.
NOTE:
For DT363GL, avoid using the Power Buon (“hold 4+ seconds” feature) to turn
o the tablet—this form of hardware shutdown is intended to be a means of
recovery from lockups, and not as normal operaon.
5
UHF RFID Reader:
The oponal UHF RFID reader supports EPC Gen2V2 and ISO 18000-63 standard. To
develop an applicaon to use the UHF RFID reader, contact your device provider for a
UHF RFID reader API package.
Data Capture Module Operation Guide
If your DT363GL/ 363Q comes with a RFID Reader, refer to the steps below to congure
the sengs.
NOTE:
To ensure opmal system performance, turn on only the symbologies you are going
to use.
4
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed aer a launch sequence of several seconds. The wireless
LAN connecon may take 10-15 seconds to be established.
Wireless Networking
Wireless LAN
The DT363GL/ 363Q is oen delivered with an embedded (user-inaccessible)
802.11ac LAN adapter equipped with a hidden custom antenna.
• Through the support of typical WLAN adapters, the DT363GL/ 363Q should be
able to detect all 802.11 access points in the vicinity for you to select the access
point of your choice for connecon.
• The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT363GL/ 363Q
and the access points have to match. The SSID is case-sensive and it is recom-
mended that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves)
for secure access.
• When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
• Refer to the access point operang manuals for seng up the 802.11 access
points.
Bluetooth
The Bluetooth conguraon applicaon is enabled from the Windows System Tray
or from the Android Sengs APP. Follow the instrucons and opons provided
within the applicaon to congure and invoke Bluetooth connecvity with the
corresponding peripherals.
7
6
Installing the SIM Card on DT363Q
1. Make sure the tablet is completely powered o.
2. Open the top cover, then gently insert the SIM card into the appropriate slot.
3. Close the top cover.
Removing the SIM Card from the DT363GL/ 363Q
Gently push the SIM card in and quickly release. The card will parally eject and can
now be pulled out.
For More Support
Users can download the Tablet Modules Basic Operaon Guides from the DT Research
website.
If your DT363GL/ 363Q comes with a 4G LTE module, refer to the steps below to
install the SIM card.
Installing the SIM Card on DT363GL
1. Make sure the tablet is completely powered o.
2. Remove the two screws, remove the cover, then gently insert the SIM card.
3. Posion the cover over the card slot, aach both screws.
This manual suits for next models
1
Other DT Research Tablet manuals
DT Research
DT Research DT315CT Assembly instructions
DT Research
DT Research DT311Y Assembly instructions
DT Research
DT Research DT395GS Assembly instructions
DT Research
DT Research DT310CR Assembly instructions
DT Research
DT Research 340Q Assembly instructions
DT Research
DT Research 373T/MD Assembly instructions
DT Research
DT Research DT361AM Assembly instructions
DT Research
DT Research DT340T Assembly instructions
DT Research
DT Research DT301Y Assembly instructions
DT Research
DT Research DT520 Assembly instructions
DT Research
DT Research 311Q Assembly instructions
DT Research
DT Research 302MD Assembly instructions
DT Research
DT Research DT395BT Assembly instructions
DT Research
DT Research DT315CT Assembly instructions
DT Research
DT Research DT311C Assembly instructions
DT Research
DT Research DT311Y Assembly instructions
DT Research
DT Research 502T Assembly instructions
DT Research
DT Research 306Q Assembly instructions
DT Research
DT Research DT365 Assembly instructions
DT Research
DT Research DT301NV Assembly instructions
Popular Tablet manuals by other brands
Laser
Laser MID-1060 Quick operation guide
MUNBYN
MUNBYN IRT09J Easy setup guide
Motorola
Motorola MC3090R - Win CE 5.0 Professional 520 MHz quick start guide
Dell
Dell Latitude ST Setup and features information
Lenovo
Lenovo IdeaTab S6000L Hardware Maintenance Manual
Venturer
Venturer WT9L11 quick start guide
