Dimplex BF42ST-230 Operation manual

INSTALLATION & USERS GUIDE

FOR THE

ELECTRIC INSERT FIREPLACE

MODELS: BF42ST-230/BF42DX-230

7206010100 rev00

QUICK REFERENCE GUIDE

FOR THE DIMPLEX ELECTRIC FIREPLACE

1. Prior to the first use of the fireplace verify the following:

•Are the circuit breakers for the fireplace on?

•Are the light bulbs in your fireplace loose? (to check, follow the instruc-

tions for replacing the light bulbs under the maintenance section of this

manual)

2. The heater on your fireplace may emit a slight, harmless odor when first used.

This odor is a normal condition caused by the initial heating of internal heater

parts and will not occur again.

3. The information regarding the model of your fireplace can be found on the

rating plate located on the top or the back of the fireplace.

4. If you have any technical questions, questions regarding the operation of your

fireplace, or require service for your fireplace contact DIMPLEX customer

service.

IMPORTANT INSTRUCTIONS

PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE

When using electrical appliances, basic precautions should always be followed to reduce

the risk of fire, electric shock, and injury to persons, including the following:

1. Read all instructions before using this fireplace.

2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot

surfaces. The trim around the heater outlet becomes hot during heater operation. Keep combustible

materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from

the front of the unit.

3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever

the fireplace is left operating and unattended.

4. Always unplug the fireplace when not in use.

5. Do not operate any fireplace with a damaged cord or plug, or if the heater has malfunctioned, or if the

fireplace has been dropped or damaged in any manner. Contact an authorized service facility for

examination, electrical or mechanical adjustments or repair.

6. Do not use outdoors.

7. This fireplace is not intended for use in bathrooms, laundry areas and similar indoor locations.

8. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange

cord away from traffic area and where it will not be tripped over.

9. To disconnect the fireplace, turn the controls off, then remove the plug from the socket outlet.

10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an

electric shock or fire, or damage to the heater.

11. To prevent a possible fire, do not block air intake or exhaust in any manner.

12. All electrical heaters have hot and arcing or sparking parts inside. Do not use in areas where gaso-

line, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable

vapors.

13. Do not modify this fireplace. Use it only as described in this manual. Any other use not recom-

mended by the manufacturer may cause fire, electric shock or injury to persons.

14. Avoid the use of an extension cord. Extension cords may overheat and cause a risk of fire. If you

must use an extension cord, the cord must be a 3 core type and rated no less than 13 amps.

15. Do not burn wood or other materials in this fireplace.

16. Do not strike fireplace glass.

17. Always use a certified electrician should new circuits or socket outlets be required.

18. Always use properly grounded, fused and polarized socket outlets.

19. Disconnect all power supply before performing any cleaning, maintenance or relocation of the fire-

place.

20. When transporting or storing the fireplace and cord, keep in a dry place, free from excessive vibration

and store so as to avoid damage.

21. Young children should be supervised to ensure that they do not play with the appliance.

22. The appliance is not intended for use by young children or infirmed persons without supervision.

23. The appliance must be postioned so that the plug is accessible.

24. If the supply cord is damaged, it must be replaced by the manufacturer, or its service agent, or a

qualified person in order to avoid a hazard.

25. Do not use this fireplace in the immediate surroundings of a bath, shower or swimming pool.

26. Do not locate the heater immediately below a fixed socket-outlet.

NOTE: Procedures and techniques that are considered important enough to emphasize.

CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment.

WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire,

serious injury, illness or death.

86.3

INSTALLATION

NOTE: To prevent personal injury always use a licensed electrician to install new outlets or

circuits.

1. Select a suitable location that is not susceptible to moisture and is away from drapes,

furniture and high traffic.

2. For ease of electrical connections you may wish to locate the fireplace near an exist-

ing power supply outlet. Ensure that the socket outlet will be accessible after installa-

tion of the fireplace.

3. Plan your electric power supply. A 10 amp, 240 volt circuit is required. A dedicated

circuit is preferred but not essential in all cases. A dedicated circuit will be required if

after installation, the circuit breaker or fuse trips. Additional appliances may exceed

the current rating of the circuit breaker or fuse.

4. Assemble a surround mantle and place it in the desired location.

5. Remove the fireplace unit from the package.

6. Set the unit in front of the mantle opening. Plug the power supply cord into the socket

outlet.

7. Push the fireplace into the surround mantle unitil the trim is flush with the mantle

surface, and centered within the opening.

DIMENSIONS IN CENTIMETERS

113.5

117

107

VIEWING

AREA

71 152.4

107107

38.1

40.6

83.8

57.9

FIGURE 2

REMOTECONTROL

The fireplace is supplied with a radio frequency remote

control. This remote control has a range of approxi-

mately 50ft. (15.25m), it does not have to be pointed at

the fireplace and can pass through most obstacles

(including walls).

Remote Control Initialization

This procedure is required every time there is a loss of

power to the remote control in the fireplace (i.e. power

failure, breaker tripped, main power switch is turned off)

1. Ensure that power is supplied through main service

panel.

2. Locate manual controls refer to FIGURE 2.

3. Activate main power switch, red indicator lights 1 will

flash.

4. Press button located on the remote control

transmitter (FIGURE 1). This will synchronize the

remote control transmitter and receiver.

Remote Control Usage

The remote control operates the fireplace levels se-

quentially. The level is increased every time the

button on the transmitter is pressed. The fireplace can

be turned off at any point by pressing the button on

the remote control transmitter.

Level 1: The flame effect is turned on and the first red

indicator light flashes momentarily.

Level 2: The flame effect remains on, the heater is

activated to the low heat setting, and the first and sec-

ond red indicator lights flash momentarily.

Level 3: The flame effect remains on, the heater is set

to the high heat setting, and all three red indicator lights

flash momentarily.

MANUALCONTROLS

The fireplace can also be controlled in a similar

manner to the remote control with switches located

on the fireplace

MODELSWITHREMOTECONTROL

Main power switch

Main power switch, supplies power to the

remote control receiving unit. When placed

in the on position level 1 indicator will flash.

Heater control switch

Operates fireplace in the same manner as the

remote control transmitter. Pressing the left side of

this switch has the same effect as the but-

ton on the remote control and the right side has the

same effect as the button of the remote control.

Pressing once to the left activates Level 1, twice

activates Level 2, three times activates Level 3.

Pressing to the right turns the fireplace off.

MODELSWITHOUTREMOTECONTROL

Main power switch

Main on/off switch activates flame effect.

Heater Hi/Low switch

Operates heater selection. Postion ( I ) activates

low heat (1 KW) setting. Postion ( II ) activates high

heat (2 KW) setting. Centre postion turns heat

OFF.

MAINTENANCE

Lamp Replacement

The lamps need to be replaced when you notice a dark section of the flame. There are

four lamps under the log set which generate the flames and embers.

It is a good idea to replace all of the lamps at one time if they are close to the end

of their rated life. Group replacement will reduce the number of times you need to open

the unit to replace the lamps.

Warning:

Disconnect the power before attempting any maintenance or cleaning to reduce the risk

of fire, electric shock or injury to persons.

Warning:

Allow at least 10 minutes for the lamps and heater to cool before attempting any main-

tenance or cleaning.

Bulb Requirements

Quantity 4 clear chandelier or candelabra lamps with an E-14 socket base, 60 watt

rating.

CAUTION DO NOT EXCEED 60 WATTS PER LAMP

TO REPLACE LAMPS

1. Open the steel curtains.

2. Remove the log grate retaining screws and remove the log grate.

3. Pull the rear edge of the log set forward by grasping the ember bed by the sides

(handle the log set only by the ember bed and not the logs) and pulling firmly until

the rear tab pops out from under the back ledge, then lift out.

4. Examine to determine which lamps require replacement.

5. Unscrew lamp counter clockwise.

6. Insert new lamp screwing clockwise.

7. Replace the log set by inserting the front edge, pushing the back down until the

rear tab snaps under the back ledge and the logs are resting against the mirror.

8. Replace log grate.

WARRANTY

Dimplex Electric Fireplaces are tested and inspected prior to shipment and are guaran-

teed from defect to the purchaser of each new product. Any part which proves to be

defective in material or workmanship under normal use within on year will be repaired

or replaced without charge.* The Company will not be responsible for any expense

incurred for installation, removal from service, or transportation costs. Any such defect

should be brought to the attention of the Dealer where the product was purchased and

is authorized to repair or replace within the terms of this warranty.

The Company’s only obligation under this warranty will be at its sole option to repair or

replace any part proving defective or to refund the purchase price thereof.

The owner/user assumes all other risks, if any, including the risk of any direct, indirect

or consequential loss or damage arising out of the use of or inability to use the product.

The warranty will not apply if, in the sole judgment of the Company, damage or failure

has resulted from accident, alteration, misuse, abuse, incorrect installation, or operation

on an incorrect power source.

The foregoing is in lieu of all other warranties expressed, implied, or statutory, and the

Company neither assumes, nor authorizes any person to assume for it any other obli-

gation, or liability in connection with said product.

*Lamps are not covered in the warranty.

SERVICE

Dimplex requires that all electric fireplace products are to be field serviced whenever

possible. Dimplex electric fireplaces are covered by a free in home service for the

period that the fireplace is under warranty. For service call your local Dimplex dealer.

TheproductcomplieswiththeEuropeanSafetyStandardEN60335-2-30andtheEuropeanStandardforElectro-

magnetic Compatibilty (EMC) EN55014, EN6055-2 and EN60555-3 which cover the essential requirements of

EEG Directives 73/23 and 89/336.

This manual suits for next models

Table of contents

Other Dimplex Indoor Fireplace manuals

Dimplex

Dimplex Ignite 60 User manual

Dimplex

Dimplex X-XLF5017-XD User manual

Dimplex

Dimplex DF2608 User manual

Dimplex

Dimplex 3 Step E User manual

Dimplex

Dimplex Elda Fire ELD20 User manual

Dimplex

Dimplex DF3033ST User manual

Dimplex

Dimplex purifire DF3220 Sseries User manual

Dimplex

Dimplex SWM4820 User manual

Dimplex

Dimplex RONDO User manual

Dimplex

Dimplex DF2624L-EUE User manual

Dimplex

Dimplex XLF60 User manual

Dimplex

Dimplex BLF50 User manual

Dimplex

Dimplex Revillusion RBF30 User manual

Dimplex

Dimplex Brayford BFD20E Instruction Manual

Dimplex

Dimplex DFOP25 User manual

Dimplex

Dimplex DNV20CH Manual

Dimplex

Dimplex 26" Quick start guide

Dimplex

Dimplex ORVIETO MCFP15O User manual

Dimplex

Dimplex Anthony User manual

Dimplex

Dimplex Optiflame Toluca Deluxe TLC20LX Instruction Manual

Dimplex

Dimplex DF2600L User manual

Dimplex

Dimplex Opti-V User manual

Dimplex

Dimplex Optiflame Electric Fireplace User manual

Dimplex

Dimplex GDS28G8-1802W User manual

Popular Indoor Fireplace manuals by other brands

Brigantia

Brigantia 35-DVRS31N-2 User's installation, operation and maintenance manual

Nordpeis

Nordpeis Bergen Installation and user manual

Superior

Superior BCT2536TMN Installation and operation instructions

Quadra-Fire

Quadra-Fire 5100I-GD-B owner's manual

Renaissance

Renaissance RUMFORD 1000 user manual

Lacunza

Lacunza IV-800 Instruction book

Baxi

Baxi 940 Installer and owner guide

Dru

Dru Maestro 60/2 Tall RCH installation manual

Diamond Fireglass

Diamond Fireglass SS-O22 General assembly, installation, and operation instructions

HearthStone

HearthStone Windsor Bay 8830 Owner's manual and installation guide

Napoleon

Napoleon ASCENT B42 quick start guide

Enviro

Enviro E33GI owner's manual

Smeg

Smeg L30 FABE Installation & user's instructions

KEDDY

KEDDY K700 Installation instructions care and firing instructions

Godin

Godin 3451 manual

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Installation and operation instructions

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 operating manual

Desa

Desa CCFPDFT Owner's operating & installation manual