Da-Lite Cosmopolitan Electrol User manual

INSTRUCTION BOOK FOR

Tensioned Large

Cosmopolitan®Electrol®

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of ire, electric shock, or

injury to persons.

Carefully unpack screen and remove outer wrapping from case.

The slat retainer screws must be removed before installation. Use supplied 1/8" nex key to remove silver shipping brackets attached

to slat and screen case. Orient the case with the slat down and then remove the screws. The case must remain in that orientation

throughout the installation process to avoid fabric damage.

The Tensioned Large Cosmopolitan® Electrol® comes with brackets to allow for wall mount or ceiling mount installations.

Procedures for each method are as follows::

Wall Mount

1. The wall mount bracket should be fastened to wall studs or

some reinforcement within the wall. Concrete or brick walls

require special fasteners and anchors.

2. The wall bracket has holes spaced at 16" and 24" to align with

most wall studs.

3. The bracket must be level and plumb.

4. Keep in mind you will need at least 23/4" between the ceiling

and the top of the wall mount bracket to be able to position

the case on the bracket.

5. Mount the screen case on the wall bracket as shown in

igure 1. Be sure the case is fully seated on the bracket.

Tighten the stop screws against the wall bracket.

Ceiling Mount

1. Be sure the ceiling has adequate reinforcement to attach the

screen brackets.

2. Attach the ceiling brackets to the wall mount bracket using

the supplied 5/16" x 3/4" bolts, washers and nuts.

3. Position the ceiling bracket assembly on the ceiling and

attach with 5/16" bolts (not supplied). The bolts should be

long enough to pass through the drywall or ceiling tile and

penetrate at least 11/2" into the reinforcement in the ceiling.

4. Mount the screen on the wall bracket as shown in igure 2. Be

sure the case is fully seated on the bracket. Tighten the stop

screws against the wall bracket.

Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. No further

adjustment is necessary.

CAUTION: Contact Da-Lite at 8006223737 or 5742678101 if screen motor needs adjustment.

ATTENTION:Contactez Da-Lite au 8006223737 ou au 5742678101 au cas le moteur de l'écran a besoin d'être ajusté.

Installation

Screen Adjustment

1 ⅛"

Case Hook

Viewing Surface

(Audience Side)

Figure 2

Figure 1

Viewing Surface

(Audience Side)

Case Hook

Wall Mount

Bracket

Stop Screw

Ceiling Mount

Bracket

⁄ x ¾" Bolt

Nut and Lock

Washer

Wall Mount

Bracket

Stop Screw

Tensioned Large Cosmopolitan®Electrol®Installation For Screens

Without A Built-In Low Voltage Control

Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of

the screen case.

See wiring diagram below for wire connections.

NOTE: This screen can only be controlled by a single 120VAC or 240VAC wall switch. To use multiple switches, an optional low voltage control

must be used.

240 VOLT WIRING DIAGRAM FOR STANDARD WALL SWITCH:

Da-Lite ofers two styles of 240 volt wall switches for standard operation.

Please see wiring diagram in wall switch boxes included with screen.

This Switch Can Not

be used with LVC.

120V Wiring Diagram

For Standard Wall Switch

SPDT Switch with

Center Of

AC (Common)

AC Hot 120VAC 60HZ 1 AMP

Black/Yellow

Black

Red

White

Red (Up)

Black (Down)

Junction Box

Located In Left Endcap

White

Red

Black

Green

Motor

NOTE: A single switch cannot be used

to operate more than one screen.

Contact the factory for further

information.

Of

Down

RJ45

Receptacle

RJ22

Output

RJ22

Inputs

Up (Dry Contact)

Down (Dry Contact)

Common (Both)

Bus (Bus)

5V (Bus)

STOP

DOWN

BUS

COM

Front of

Wall Switch

Bus

STOP

DOWN

BUS

COM

Led

Up Limit

Tactile Button

Down Limit

Tactile Button

Back of

Wall Switch

Installation For 120V Screens

RJ22 Pin-Outs (Tab Is Facing Up)

Standard RJ22 can be used in place of RJ14 cable

Bus (RP Data)

+12V

RQ Clock

RQ Data

+5V

Ground

Yellow

Green

Red

Black

White

Blue

RJ45 Pin-Outs (Tab Is Facing Up)

+12V

Manual 2

Ground

Manual 1

RQ Clock

Bus (RP Data)

RQ Data

+5V

Blue

Green

Yellow

Red

Black

Orange

Purple

Brown

120V Wiring Diagram

3-conductor 2024 gauge wire can be used in place of the

supplied RJ14 cable to connect the wall switch. Connect the

BUS terminals on the wall switch to the corresponding BUS

terminals on the splitter board.

IMPORTANT NOTE: The wall switch is REQUIRED to make any

limit switch adjustments, EVEN if a third party control system is

used. Therefore, it is advised to wire the switch or provide a

3-conductor connection that is accessible.

STOP

DOWN

BUS

COM

Power Input 120VAC / 60Hz

Green (Ground)

(Ground–Must be Connected

to Building Ground)

Black

(Hot)

White

(Common)

Power

Wire

Data

Cable

RJ45 Jack

RJ22 Jack

(Connection to

Wall Switch)

RJ22

Jack

RJ14 Pin-Outs (Tab Is Facing Up)

Supplied RJ14 cable

Bus (RP Data)

RQ Data

+5V

Ground

White

Green

Red

Black

240V Wiring Diagram

IMPORTANT NOTE: The wall switch is REQUIRED to make

any limit switch adjustments, EVEN if a third party control

system is used. Therefore, it is advised to wire the switch

or provide a 4-conductor connection that is accessible.

Installation for 220/240V Screens

ILT RJ9 Pin-Outs (Tab Is Facing Up)

Ground Common

IR or Up

+5V

Data or Down

Red

Green

White

Black

UP DN

+5V

COM

STOP

DOWN

GND

+5V

3POSITION

SWITCH RJ9

RJ9RJ9

Motor

Front of Wall

Switch

Splitter

Dry Contacts

Back of

Wall Switch

Green

Brown (Hot)

Blue (Common)

NOTE: Ground–Must be

Connected to Building

Ground

Ground to Case

Green

Power Input

240VAC / 50Hz

Troubleshooting

Symptom Cause Solution

Screen will not operate.

Motor does not hum.

Blown fuse. Replace fuse.

Tripped circuit breaker. Reset circuit breaker.

No power to operating switch

or junction.

Check above. Tighten all loose wire connections.

Correct any improper connections.

Down Position

Check for power across black and white leads.

Up Position

Check for power across red and white leads.

Power at junction box

Thermal overload tripped. Let motor cool down for 15 minutes. Try again.

Broken wire in the “down” or “up” position. Check for continuity. Cut o old splice and reconnect.

Defective motor, limit switch or capacitor. Replace motor assembly. NOTE: Motor is a sealed assembly.

Capacitor burned out. Replace motor assembly.

Incorrect stopping position in

downward direction.

Lost roller wrap. See instructions below.

“Down” limit switch out of adjustment. Contact Da-Lite at 8006223737 or 5742678101.

Incorrect stopping position in

upward direction.

Lost roller wrap. See instructions below.

“Up” limit switch out of adjustment. Contact Da-Lite at 8006223737 or 5742678101..

Noise.

NOTE: Screen will operate

with a low pitched hum.

Gear noise. Replace motor assembly.

Coasting. Defective brake. Replace motor assembly.

Visit www.da-lite.com/products/product_videos.php to ind

installation and troubleshooting videos and tutorials. You will also

ind a link to Live Chat for interactive support and you can

(800) 6223737 or (574) 2678101 with any troubleshooting

questions.

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS

Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in

materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly

operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the

factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered

with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.

Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,

transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.

To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,

or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives

you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED

BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION

OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137,

Warsaw, IN 465810137, (574) 2678101, (800) 6223737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS

WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

98770

A Milestone AV Technologies Brand

3100 North Detroit Street

Warsaw, Indiana 46582

P: 574.267.8101 or 800.622.3737

F: 574.267.7804 or 877.325.4832

E: info@da-lite.com

www.da-lite.com

DL–0179 (Rev. 1) 07.14

Other manuals for Cosmopolitan Electrol

This manual suits for next models

Table of contents

Other Da-Lite Projection Screen manuals

Da-Lite

Da-Lite Tensioned Contour Electrol 38798LC User manual

Da-Lite

Da-Lite IDEA Panoramic User manual

Da-Lite

Da-Lite Picture King User manual

Da-Lite

Da-Lite LARGE ADVANTAGE DELUXE ELECTROL User manual

Da-Lite

Da-Lite DESIGNER DA-TAB ELECTROL User manual

Da-Lite

Da-Lite Horizon Electrol User manual

Da-Lite

Da-Lite Da-Snap 79982 User manual

Da-Lite

Da-Lite DESIGNER CONTOUR MANUAL User manual

Da-Lite

Da-Lite Large Dual Masking Electrol User manual

Da-Lite

Da-Lite Da-Snap 74610 User manual

Da-Lite

Da-Lite DIRECTOR ELECTROL User manual

Da-Lite

Da-Lite Fast-Fold User manual

Da-Lite

Da-Lite Tensioned Director Electrol User manual

Da-Lite

Da-Lite senIor electrol User manual

Da-Lite

Da-Lite TENSIONED LARGE COSMOPOLITAN ELECTROL User manual

Da-Lite

Da-Lite ADVANTAGE ELECTROL User manual

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL User manual

Da-Lite

Da-Lite PERM WALL FRAME User manual

Da-Lite

Da-Lite Versatol User manual

Da-Lite

Da-Lite Viewshare tensioned Advantage Electrol User manual

Da-Lite

Da-Lite 79982 User manual

Da-Lite

Da-Lite STUDIO ELECTROL User manual

Da-Lite

Da-Lite DELUXE MODEL B User manual

Da-Lite

Da-Lite IDEA Screen User manual

Popular Projection Screen manuals by other brands

FART PRODUKT

FART PRODUKT Standard SCREEN Installation instruction

Draper

Draper E Series Installation & operating instructions

Elite Screens

Elite Screens Elite Tripod Series user guide

Laarhoven

Laarhoven Companion II General assembly instructions

Renogy

Renogy RMS-LFPS-US manual

Samsung

Samsung S*H65* user manual

FONESTAR

FONESTAR PPTR-43100-FA quick start guide

Slide Clear

Slide Clear Varro XL installation instructions

Elite Screens

Elite Screens M85XWS1-SRM manual

OS РХ-090Н user manual

Niko

Niko 10-845 Product information

Speaka Professional

Speaka Professional 2357532 Important information

Sima

Sima XL-72 instruction manual

Jasic

Jasic EVO 2.0 ET-200P Fitting instructions

Elite Screens

Elite Screens Starling 2 Series user guide

InFocus

InFocus SC-WALL GRY-92H Instruction guide

Barco

Barco OverView MVL-615 Brochure & specs

Draper

Draper Envoy Installation & operating instructions