Program it (create a playlist, up to 9 songs)
1. In CD mode: Load a disc and press STOP. Press PROG and enter the first track number.
Press PROG again to confirm. Enter the second number and follow the same procedure to set your playlist.
2. Play the list: When the list is completed press PLAY to confirm and listen to the music.
Loop it (play a section of a song)
In CD/MP3 mode:
1. Press A-B button once to set In (Start) point.
2. Press A-B button again to set Out (End) point.
Care & Maintenance
Compact discs:
1. Treat disc carefully holding it by its edges.
2. Clean with a soft, dry cloth. Wipe from
the center to the outer edge of the disc.
Do not wipe in circular direction.
3. Do not stick or write anything
on either side of the disc.
Control it
7
Tune it (choose radio stations)
6
8
10
9
Select it (choose mode)
Press SOURCE button on the main unit
or on the Remote Control to switch
between the available modes.
4
Bluetooth USB AUXFMCD
Set it up
Connect the speakers to the unit:
Connect each speaker cable to the respective SPEAKER port.
Connect the Antenna cable:
Connect the Antenna cable to the ANTENNA FM input port.
Connect the unit to the outlet:
Connect the mains plug into the electrical outlet.
1Install Batteries:
Slide out cover and place 2 AAA type
batteries (not inluded) with polarities as
shown below.
Pair it (wireless connection)
You can pair 3D-HIFI360 with any Bluetooth®enabled device (phone, tablet etc).
2
1. Press the SOURCE button to select BT
(Bluetooth Mode). The indication on the LED
Display flashes continuously and the device
automatically searches for available
Bluetooth devices.
2. On your device,
turn BLUETOOTH on
and make it discoverable.
Search for 3D-HIFI360 and
select it.
3. The indication stops flashing.
The devices are now paired.
3D-HIFI360
* In case of an old Bluetooth version (below v3.0)
you might be asked for a code. Please enter “0000”.
PAI R
Eject
Open compact disc tray
Numeric Keypad
Select track number
GoTo
Enter FM Frequency
Next Track
Play
Previous Track
Stop
Pause
Pause the music
CD/USB
Select CD or USB mode
Source
Switch between all modes
Random
Play tracks in random order
Search
Auto tunning (FM Radio)
FF -/+
Manual tunning (Radio stations)
Reset
Back to factory deafult options
BT
Select Bluetooth mode
Treble -/+
Treble adjustment
Bass -/+
Bass adjustment
Prog
Create a playlist (up to 9 tracks)
Intro
Play the 10 first seconds of
each track on the disk. Press
again to cancel the function Pair
Search for Bluetooth devices
Memory
Preset a radio station
Repeat
Press 1 time: Repeat only one track
Press 2nd time: Repeat all tracks
Press 3rd time: Stop Repeat function
A-B
Loop a section of a song
CH -/+
Select Next/Previous Radio station
VOL -/+
Adjust Volume level
EQ
Rock/Jazz/Pop/Flat
Mute
Mute the sound
Rewind
Forward
ON/OFF
Use it (wired connection)
1. LINE IN: Connect both Left & Right channels to your device Output
2. USB: Play songs directly from your USB flash drive
3. Headphones: Connect to the headphone Output of your device
31. LINE IN 2. USB port 3. Headphones
3.5mm
REMOVE USB:
In order to safely eject
the USB flash drive,
change the SOURCE
before removing it.
�
Preset it (up to 40 radio stations)
5
Unit:
1. To prevent shock hazard
disconnect from the AC power
source when cleaning the device.
2. Clean with a dry cloth.
A dump cloth may be used on
the front panel.
1. In FM mode:
Press GOTO
2. On LED display:
3. Num. Keypad:
Enter FM frequency
4. Goto Frequency:
Press PLAY
5. Once tuned:
Press MEMORY
6. Set Position:
Press CH-/+
INFO:
To select a radio station
press a key (1-10) on the
Remote Control.
To select a station from
number 11 to 40, press
10+ and enter the desired
number of the station.
PAI R
In FM mode:
Press FF-/+
a. In FM mode: Press
Search on Remote Control
b. In FM mode: Press
PLAY/PAUSE on the main unit
MANUAL AUTO AUTO
Press A-B:
1x= set START point
2x= set END point
The specific part of the song
will be played repeatedly.
