Cisco SE-CL-L3 User manual

Cisco Application Services Engine Hardware Installation Guide

First Published: 2019-10-15

Americas Headquarters

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

http://www.cisco.com

Tel: 408 526-4000

800 553-NETS (6387)

Fax: 408 527-0883

CONTENTS

Overview 1

CHAPTER 1

Overview 1

External Features 1

Serviceable Component Locations 4

Summary of Server Features 6

Installing the Server 9

CHAPTER 2

Preparing for Installation 9

Installation Warnings and Guidelines 9

Rack Requirements 11

Installing the Server in a Rack 12

Installing the Cable Management Arm (Optional) 14

Reversing the Cable Management Arm (Optional) 15

Initial Server Setup 16

Connecting to the Server Locally For Setup 17

Connecting to the Server Remotely For Setup 18

Updating the BIOS and Cisco IMC Firmware 19

Accessing the System BIOS 19

Smart Access Serial 20

Maintaining the Server 21

CHAPTER 3

Status LEDs and Buttons 21

Front-Panel LEDs 21

Rear-Panel LEDs 24

Internal Diagnostic LEDs 25

Preparing For Component Installation 26

Cisco Application Services Engine Hardware Installation Guide

iii

Required Equipment For Service Procedures 26

Shutting Down and Removing Power From the Server 27

Shutting Down Using the Power Button 27

Shutting Down Using The Cisco IMC GUI 27

Shutting Down Using The Cisco IMC CLI 28

Removing the Server Top Cover 28

Serial Number Location 29

Hot Swap vs Hot Plug 29

Removing and Replacing Components 30

Serviceable Component Locations 30

Replacing SAS/SATA Hard Drives or Solid State Drives 32

SAS/SATA Drive Population Guidelines 32

4K Sector Format SAS/SATA Drives Considerations 33

Replacing a SAS/SATA Drive 33

Replacing a Front-Loading NVMe SSD 34

Front-Loading NVMe SSD Population Guidelines 34

Front-Loading NVME SSD Requirements and Restrictions 35

Enabling Hot-Plug Support in the System BIOS 35

Replacing a Front-Loading NVMe SSD 36

Installing a PCIe Cable For Front-Loading NVMe SSDs 37

Replacing Fan Modules 38

Replacing CPUs and Heatsinks 39

CPU Configuration Rules 39

Tools Required For CPU Replacement 39

Replacing a CPU and Heatsink 40

Moving an M5 Generation CPU 46

Replacing Memory DIMMs 51

DIMM Population Rules and Memory Performance Guidelines 51

Replacing DIMMs 53

Replacing a Mini-Storage Module 53

Replacing a Mini-Storage Module Carrier 54

Replacing an M.2 SSD in a Mini-Storage Carrier For M.2 55

Replacing an Internal USB Drive 56

Replacing a USB Drive 56

Cisco Application Services Engine Hardware Installation Guide

Contents

Enabling or Disabling the Internal USB Port 57

Replacing the RTC Battery 58

Replacing Power Supplies 59

Replacing AC Power Supplies 59

Replacing a PCIe Card 60

PCIe Slot Specifications 60

Replacing a PCIe Card 61

Cisco Virtual Interface Card (VIC) Considerations 64

Replacing an mLOM Card 65

Replacing an mRAID Riser (Riser 3) 66

Replacing a SAS Storage Controller Card (RAID or HBA) in Riser 3 68

Storage Controller Card Firmware Compatibility 68

Replacing a SAS Storage Controller Card (RAID or HBA) 69

Replacing a Boot-Optimized M.2 RAID Controller Module 70

Cisco Boot-Optimized M.2 RAID Controller Considerations 70

Replacing a Cisco Boot-Optimized M.2 RAID Controller 71

Replacing the Supercap (RAID Backup) 73

Replacing a SATA Interposer Card 75

Replacing a Chassis Intrusion Switch 76

Installing a Trusted Platform Module (TPM) 77

TPM Considerations 77

Service Headers and Jumpers 78

Using the Clear CMOS Header (J38, Pins 9 - 10) 79

Using the BIOS Recovery Header (J38, Pins 11 - 12) 80

Procedure 1: Reboot With recovery.cap File 80

Procedure 2: Use BIOS Recovery Header and bios.cap Recovery File 81

Using the Clear Password Header (J38, Pins 13 - 14) 81

Using the Boot Alternate Cisco IMC Image Header (J39, Pins 1 - 2) 82

Using the Reset Cisco IMC Password to Default Header (J39, Pins 3 - 4) 83

Using the Reset Cisco IMC to Defaults Header (J39, Pins 5 - 6) 84

Server Specifications 85

APPENDIX A

Server Specifications 85

Physical Specifications 85

Cisco Application Services Engine Hardware Installation Guide

Contents

Environmental Specifications 85

Power Specifications 86

1050 W AC Power Supply 86

Power Cord Specifications 87

Storage Controller Considerations 91

APPENDIX B

Supported Storage Controllers and Cables 91

Storage Controller Card Firmware Compatibility 92

RAID Backup (Supercap) 92

Write-Cache Policy for Cisco 12G SAS Modular RAID Controller 92

Mixing Drive Types in RAID Groups 93

RAID Controller Migration 93

Storage Controller and Backplane Connectors 94

Embedded SATA RAID Controller 96

Embbeded SATA RAID Requirements 97

Embedded SATA RAID Controller Considerations 97

Embedded SATA RAID: Two SATA Controllers 98

Enabling SATA Mode For the Embedded Controllers 98

Accessing the Software RAID Configuration Utility 99

For More RAID Utility Information 99

Cisco Application Services Engine Hardware Installation Guide

Contents

CHAPTER 1

Overview

•Overview, on page 1

•External Features, on page 1

•Serviceable Component Locations, on page 4

•Summary of Server Features, on page 6

Overview

Cisco Application Services Engine provides a common platform for deploying Cisco Data Center applications.

These applications provide real time analytics, visibility and assurance for policy and infrastructure.

The Cisco Application Services Engine server is required for installing and hosting the Cisco Application

Services Engine application.

The server is orderable in the following version:

• SE-CL-L3 — Small form-factor (SFF) drives, with 10-drive backplane. Supports up to 10 2.5-inch

SAS/SATA drives. Drive bays 1 and 2 support NVMe SSDs.

The Cisco Application Services Engine software is pre-installed on the server. It is detected after the server

is connected, installed and powered on. Cisco Application Services Engine app allows you to fully enable the

capabilities of the Cisco Application Services Engine.

Cisco Application Services Engine app can be downloaded from the Cisco DC App Center. See the Cisco

Application Services Engine for more information on downloading and using the app.

Note

External Features

This topic shows the external features of the server versions.

Cisco SE-CL-L3 (SFF Drives) Front Panel Features

The following figure shows the front panel features of the small form-factor drive versions of the server.

For definitions of LED states, see Front-Panel LEDs, on page 21.

Cisco Application Services Engine Hardware Installation Guide

Figure 1: Cisco SE-CL-L3 (SFF Drives) Front Panel

Fan status LED7Drive bays 1 – 10 support SAS/SATA hard disk

drives (HDDs) and solid state drives (SSDs)

Network link activity LED8• SE-CL-L3 : Drive bays 1 and 2 support

NVMe PCIe SSDs.

Temperature status LED9Power button/power status LED3

Pull-out asset tag10Unit identification button/LED4

KVM connector

(used with KVM cable that provides one DB-15

VGA, one DB-9 serial, and two USB connectors)

11System status LED5

-Power supply status LED6

SE-CL-L3 (LFF Drives) Front Panel Features

The following figure shows the front panel features of the large form-factor drive version of the server.

For definitions of LED states, see Front-Panel LEDs, on page 21.

Cisco Application Services Engine Hardware Installation Guide

Overview

External Features

Figure 2: SE-CL-L3 (LFF Drives) Front Panel

Temperature status LED7Drive bays 1 – 4 support SAS/SATA HDDs and

SSDs

Power supply status LED8Drive bays 1 and 2 support NVMe PCIe SSDs.

A size-converter drive sled is required if 2.5-inch

SSDs are used.

Network link activity LED9Power button/power status LED3

KVM connector

(used with KVM cable that provides one DB-15

VGA, one DB-9 serial, and two USB connectors)

10Unit identification button/LED4

Pull-out asset tag11System health LED5

-Fan status LED6

SE-CL-L3 Rear Panel Features

The rear panel features are the same for all versions of the server.

For definitions of LED states, see Rear-Panel LEDs, on page 24.

Cisco Application Services Engine Hardware Installation Guide

Overview

External Features

Figure 3: SE-CL-L3 Rear Panel

Rear unit identification button/LED7Modular LAN-on-motherboard (mLOM) card bay

(x16 PCIe lane)

Power supplies (two, redundant as 1+1)8USB 3.0 ports (two)2

PCIe riser 2/slot 2 (x16 lane)

Includes PCIe cable connectors for front-loading

NVMe SSDs (x8 lane)

9Dual 1-Gb/10-Gb Ethernet ports (LAN1 and

LAN2)

The dual LAN ports can support 1 Gbps and 10

Gbps, depending on the link partner capability.

PCIe riser 1/slot 1 (x16 lane)10VGA video port (DB-15 connector)4

Threaded holes for dual-hole grounding lug111-Gb Ethernet dedicated management port5

-Serial port (RJ-45 connector)6

Serviceable Component Locations

This topic shows the locations of the field-replaceable components and service-related items. The view in the

following figure shows the server with the top cover removed.

Cisco Application Services Engine Hardware Installation Guide

Overview

Serviceable Component Locations

Table of contents

Other Cisco Server manuals

Cisco

Cisco UCS 5100 Manual

Cisco

Cisco UCS C200 Installation and maintenance instructions

Cisco

Cisco CPS-UCS-2RU-K9 User manual

Cisco

Cisco 700 series Installation and operation manual

Cisco

Cisco UCS E Series Manual

Cisco

Cisco UCS C220 M3 Installation and operation manual

Cisco

Cisco S195 User manual

Cisco

Cisco C880 M5 User manual

Cisco

Cisco UCS C220 M5SX User manual

Cisco

Cisco UCS C240 M4 Installation and maintenance instructions

Cisco

Cisco UCS C480 M5 Installation and maintenance instructions

Cisco

Cisco Sourcefire Defense Center 750 User manual

Cisco

Cisco UCS C210 Installation and maintenance instructions

Cisco

Cisco Firepower 2100 Series Manual

Cisco

Cisco UCS C220 M3 Installation and maintenance instructions

Cisco

Cisco UCS C240 M4 Installation and maintenance instructions

Cisco

Cisco UCS C200 Manual

Cisco

Cisco TelePresence User manual

Cisco

Cisco UCS B440 M2 User manual

Cisco

Cisco UCS 6500 Series User manual

Cisco

Cisco UCS C22 Installation and maintenance instructions

Cisco

Cisco UCS B200 M4 User manual

Cisco

Cisco UCS C240 M3 User manual

Cisco

Cisco UCS 5100 User manual

Popular Server manuals by other brands

HP AlphaServer ES47 Cli reference manual

Dell

Dell PowerEdge R410 Getting started

PowerNAS

PowerNAS CMA quick start guide

Supero

Supero FatTwin F617R3-FT user manual

MSI

MSI P1-109N-L70 user manual

Dell

Dell PowerEdge XE9640 Installation and service manual

Dell

Dell PS4100 Hardware

EtroVISION

EtroVISION EV3151 user manual

NEC

NEC Express5800/T110j System configuration guide

HP ProLiant Gen9 user guide

Compaq

Compaq ProLiant 3000 Maintenance and service guide

Dell

Dell PowerEdge 3YPMN Getting started guide

iRobo

iRobo IPC2U user manual

Nortel

Nortel 1000 Con?guration guide user manual

Asus

Asus AP7500 Hardware reference guide

Avid Technology

Avid Technology AirSpeed 5000 manual

HP Integrity rx2600 overview

Milestone

Milestone Husky IVO 350T Getting started