Bosch Radion B810 User manual

RADION receiver SD

B810

en Installation manual

RADION receiver SD Table of contents | en 3

Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834

Table of contents

1Introduction 6

1.1 About documentation 7

1.2 Bosch Security Systems, Inc. product manufacturing

dates

2General installation 8

2.1 Installation workflow 9

2.2 Unpacking information 9

2.3 Wall tamper switch installation 10

2.4 Magnet cover installation 11

2.5 Complete installation 11

2.6 Maintenance 11

3RADION receiver SD 13

3.1 Check-in interval and power level for RADION devices 13

3.2 Certifications and approvals 14

3.3 UL product requirements 18

3.4 Installation 22

3.4.1 Configuration 22

3.4.2 Base installation 24

3.4.3 Wiring considerations 25

3.4.4 Programming wireless points in the control panel 26

3.4.5 Enroll point RF ID for wireless points (Auto-learn mode) 29

3.4.6 Walk test (for motion detectors) 30

3.4.7 Signal level and margin 31

3.4.8 Complete the installation 33

3.4.9 B810 system test 33

3.5 External LED states 33

3.5.1 LEDs 35

3.6 Specifications 37

3.6.1 Battery requirements 37

4RADION repeater 41

4.1 Installation considerations 42

4.2 Wiring considerations 42

4.3 Specifications 42

4.4 LEDs 44

4en | Table of contents RADION receiver SD

2020.05 | 13 | F.01U.261.834 Bosch Security Systems B.V.

5RADION glassbreak 46

5.1 Installation considerations 47

5.2 Testing 48

5.3 Low battery 51

5.4 Wall Tamper Tab 51

5.5 Maintenance 51

6RADION TriTech 52

6.1 Mounting height and range adjustment 53

6.2 Sensitivity settings 54

6.3 Walk testing 54

7RADION PIR 57

7.1 Walk testing 58

8RADION PIR C 60

8.1 Walk testing 61

9RADION smoke RFSM2 63

10 RADION CO 64

11 RADION heat 65

12 RADION smoke 66

12.1 Battery replacement 68

12.2 Smoke test 68

12.3 Sensitivity test 68

12.4 Test/Silence button 69

12.5 LED 70

12.6 Clean the detector and replace the optical chamber 70

13 RADION contact SM 72

13.1 Installation considerations 73

14 RADION contact RM 75

14.1 Installation considerations 76

15 RADION specialty 77

15.1 Applications for this product 78

15.2 Installation consideration 79

16 RADION universal transmitter 80

16.1 Installation considerations 81

16.2 Reed switch settings 83

17 RADION keyfob 84

RADION receiver SD Table of contents | en 5

Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834

17.1 RADION keyfob FB 86

17.2 RADION keyfob TB 87

18 RADION panic FP 89

19 Appendices 91

6en | Introduction RADION receiver SD

2020.05 | 13 | F.01U.261.834 Bosch Security Systems B.V.

1 Introduction

This document contains the basic information that a trained

installer needs to install the RADION system. It supplements the

documents listed inside the packaging (graphical installation

guides).

This reference guide contains:

– A description of the general installation procedure.

– Device-specific installation procedures.

– Specification information.

How to use this document

The information contained in this document is constructed in a

manner that is systematic and sequential for the installer on a

“point of need” basis. The following represents a basic outline

of that information;

– Chapter 1 (this chapter) – introductory information and

how to use this document.

– Chapter 2 – basic RADION system-wide general installation

information and workflow check list.

– Chapter 3 – RADION receiver-specific installation

information.

– Remaining chapters – RADION device-specific installation

information.

– Appendix – description of various icons and symbols used

within the RADION documentation.

Icons and symbols

When you see the following logo in the RADION graphical

installation guides listed in Table 3.1, refer to the appropriate

section in this document.

RADION receiver SD Introduction | en 7

Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834

Additional icons and symbols, which appear in the RADION

graphical installation guides, are explained in the appendix

section of this guide. Refer to the

Appendices, page 91

for

more information.

1.1 About documentation

This document is the intellectual property of Bosch Security

Trademarks

All hardware and software product names used in this document

are likely to be registered trademarks and must be treated

accordingly.

1.2 Bosch Security Systems, Inc. product

manufacturing dates

Use the serial number located on the product label and refer to

the Bosch Security Systems, Inc. website at http://

www.boschsecurity.com/datecodes/.

8en | General installation RADION receiver SD

2020.05 | 13 | F.01U.261.834 Bosch Security Systems B.V.

2 General installation

Phases of installation

The installation of the RADION system is achieved by following

the sequential process as defined in this chapter. Overall, there

are four main phases;

– Planning

– Physical installation of the devices

– System enrollment/configuration

– System testing (walk test, pattern test)

It is essential that these steps or phases are adhered to in the

order mentioned above for proper functionality and operation.

When installing a RADION system, you must plan your

installation based on the control panel and RADION device

specifications, and the radio-frequency signal strength (RFSS)

between devices, receivers, and control panels.

Installation considerations

– RADION devices are intended only for indoor, dry

applications.

– Mount RADION devices on flat, rigid surfaces. Some devices

can be optionally corner mounted as indicated in the

installation instructions.

– Avoid mounting RADION devices in areas with large,

metallic objects, electrical panels, or electric motors. They

might reduce the radio-frequency (RF) range of a RADION

device.

– Avoid installing the devices where excessive humidity,

moisture, or temperatures outside of the acceptable

operating range exist.

– Wire all objects according to their specifications.

– RADION devices use batteries of varying types. When

installing batteries, observe safety and polarity

recommendations as indicated in the documentation for

those products.

RADION receiver SD General installation | en 9

Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834

2.1 Installation workflow

To install, configure, and test the system, use the workflow

below and follow in sequential order, from top to bottom,

checking each box as you complete a step.

Notice!

Always power down the control panel when connecting

modules, or other wiring. Power down the control panel by

unplugging the transformer and disconnecting the battery

Plan the installation of the RADION system

Install the RADION components (refer to the graphical

installation guides and this system reference guide for details)

Program wireless points in the control panel

Enroll point RF ID for wireless points

Verify LED responses on devices

Perform a local walk test for installed detectors

Review signal strength and margin of each point

Complete the installation

2.2 Unpacking information

When unpacking the receiver, repeater, or bill trap device, it is

important to remove the cardboard insert as illustrated below;

10 en | General installation RADION receiver SD

2020.05 | 13 | F.01U.261.834 Bosch Security Systems B.V.

Figure2.1: Insert for the receiver and repeater

Figure2.2: Insert for the bill trap

2.3 Wall tamper switch installation

RADION transmitter devices contain a feature that activates the

wall tamper switch located on the base of the device. In order to

properly install the device, you must consider the following:

– To properly install a device with active wall tamper

functionality, insert a screw in the designated screw slot

location.

– Failure to insert a screw into the wall tamper slot prevents

the wall tamper feature from generating a tamper signal

when the transmitter is pulled away from a wall.

Other manuals for Radion B810

This manual suits for next models

Table of contents

Popular Receiver manuals by other brands

Garmin

Garmin GA 23 Owner's manual and reference guide

Aiphone

Aiphone PS-12F instructions

IMES

IMES TCS-01CA-PMI Original Operating Instruction

BWI Eagle

BWI Eagle AIR-EAGLE SR Product information bulletin

AMIMON

AMIMON AMN12310 WHDI datasheet

Dual

Dual DMCPA79BT Installation & owner's manual

Sound Associates

Sound Associates SA652P Operation manual

Sherwood

Sherwood NewCastle R-772 Service manual

Audio

Audio A10-RX Series user guide

AllSee

AllSee PushShare PSRV1.1 user manual

DEMAG

DEMAG DRC-DR D2 operating instructions

Teleco

Teleco TVRCL868A02 manual

Kramer

Kramer 631R user manual

Xpress

Xpress xmc10 installation guide

JVC

JVC KD-MR1BTS instruction manual

Omega Engineering

Omega Engineering UWTC-REC3 user guide

e-survey

e-survey E300 Pro user manual

Dish Network

Dish Network Satellite Television user guide