Black Box LT0009A User manual
FEBRUARY 1997
LT0009A
LT0009A-UTP
Lobe Access Unit
CUSTOMER SUPPORT INFORMATION
Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX
FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
1
LOBE ACCESS UNIT
TRADEMARKS USED IN THIS MANUAL
IBM is a registered trademark of IBM Corporation.
All applied-for and registered trademarks are the
property of their respective owners.
2
LOBE ACCESS UNIT
DECLARATION OF CONFORMITY
The products listed in this manual conform to the following standard(s) or
other normative document(s):
EMC: EN 55022 (1994): Limits and methods of measurement of radio
disturbance characteristics of information technology equipment.
EN 50082-1 (1992): Electromagnetic compatibility—Generic
immunity standard for residential, commercial, and light
industry.
Supplementary Information: The products herewith comply with the
requirements of the EMC Directive 89/336/EEC. The products were tested
in a typical configuration.
3
LOBE ACCESS UNIT
FEDERAL COMMUNICATIONS COMMISSION
AND
INDUSTRY CANADA
RADIO FREQUENCY INTERFERENCE STATEMENTS
This equipment generates, uses, and can radiate radio frequency energy
and if not installed and used properly, that is, in strict accordance with the
manufacturer’s instructions, may cause interference to radio
communication. It has been tested and found to comply with the limits for a
Class A computing device in accordance with the specifications in Subpart J
of Part 15 of FCC rules, which are designed to provide reasonable
protection against such interference when the equipment is operated in a
commercial environment. Operation of this equipment in a residential area
is likely to cause interference, in which case the user at his own expense will
be required to take whatever measures may be necessary to correct the
interference.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This digital apparatus does not exceed the Class A limits for radio noise emission
from digital apparatus set out in the Radio Interference Regulation of Industry
Canada.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de classe A prescrites dans le Règlement
sur le brouillage radioélectrique publié par industrie Canada.
4
LOBE ACCESS UNIT
NORMAS OFICIALES MEXICANAS (NOM)
ELECTRICAL SAFETY STATEMENT
INSTRUCCIONES DE SEGURIDAD
1. Todas las instrucciones de seguridad y operación deberán ser leídas
antes de que el aparato eléctrico sea operado.
2. Las instrucciones de seguridad y operación deberán ser guardadas
para referencia futura.
3. Todas las advertencias en el aparato eléctrico y en sus instrucciones
de operación deben ser respetadas.
4. Todas las instrucciones de operación y uso deben ser seguidas.
5. El aparato eléctrico no deberá ser usado cerca del agua—por
ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de
una alberca, etc..
6. El aparato eléctrico debe ser usado únicamente con carritos o
pedestales que sean recomendados por el fabricante.
7. El aparato eléctrico debe ser montado a la pared o al techo sólo
como sea recomendado por el fabricante.
8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico
más allá a lo descrito en las instrucciones de operación. Todo otro
servicio deberá ser referido a personal de servicio calificado.
9. El aparato eléctrico debe ser situado de tal manera que su posición
no interfiera su uso. La colocación del aparato eléctrico sobre una
cama, sofá, alfombra o superficie similar puede bloquea la
ventilación, no se debe colocar en libreros o gabinetes que impidan
el flujo de aire por los orificios de ventilación.
10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de
5
LOBE ACCESS UNIT
calor como radiadores, registros de calor, estufas u otros aparatos
(incluyendo amplificadores) que producen calor.
11. El aparato eléctrico deberá ser connectado a una fuente de poder
sólo del tipo descrito en el instructivo de operación, o como se
indique en el aparato.
12. Precaución debe ser tomada de tal manera que la tierra fisica y la
polarización del equipo no sea eliminada.
13. Los cables de la fuente de poder deben ser guiados de tal manera
que no sean pisados ni pellizcados por objetos colocados sobre o
contra ellos, poniendo particular atención a los contactos y
receptáculos donde salen del aparato.
14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las
recomendaciones del fabricante.
15. En caso de existir, una antena externa deberá ser localizada lejos de
las lineas de energia.
16. El cable de corriente deberá ser desconectado del cuando el equipo
no sea usado por un largo periodo de tiempo.
17. Cuidado debe ser tomado de tal manera que objectos liquidos no
sean derramados sobre la cubierta u orificios de ventilación.
18. Servicio por personal calificado deberá ser provisto cuando:
A: El cable de poder o el contacto ha sido dañado; u
B: Objectos han caído o líquido ha sido derramado dentro del
aparato; o
C: El aparato ha sido expuesto a la lluvia; o
D: El aparato parece no operar normalmente o muestra un cambio
en su desempeño; o
E: El aparato ha sido tirado o su cubierta ha sido dañada.
6
LOBE ACCESS UNIT
Operating Voltage — 4.5 ±0.7 volts
Operating Current — 1.0 mA @ 5 VDC
Resistance TX to RX — 4.8 ±0.2 kΩ
Insertion Time — 5 seconds
Removal Time — 50 to 200 msec
Insertion Loss (Maximum) —
0.5–4 MHz 4–16 MHz 16–32 MHz
SUB TX to SUB RX 0.65 dB 1.3 dB 2.6 dB
MAIN RX to SUB RX 0.85 dB 1.8 dB 3.7 dB
SUB TX to MAIN TX 0.85 dB 1.8 dB 3.7 dB
Crosstalk (Maximum) —
10 KHz 0.5–4 MHz 4–16 MHz
SUB TX to SUB RX 55 dB 43 dB 37 dB
SUB WRAP to MAIN 50 dB 40 dB 35 dB
Return Loss (Minimum) —
1–6 MHz 6–12 MHz 12–24 MHz
20 dB 14 dB 11 dB
1. Specifications
7
LOBE ACCESS UNIT
Common Mode Rejection (Minimum) —
1–6 MHz 6–12 MHz 12–24 MHz
40 dB 28 dB 25 dB
Electrical Connectors — LT0009A: MAIN:
(1) DB9 female; SUB-1
through -4: (1) DB9
male each; LT0009A-
UTP: MAIN: (1) RJ-45
female; SUB-1 through
-4: (1) RJ-45 female each
Indicators — (4) Red LEDs; lobe
activity
MTBF — 98,398 hours
Certification — CE
Operating
Temperature — 32 to 122°F (0 to 50°C)
Relative Humidity
Tolerance — 10 to 90%,
noncondensing
Size — 1.4"H x 4.4"W x 7.3"D
(3.6 x 11.2 x 18.5 cm)
Weight — 0.8 lb. (0.4 kg)
8
LOBE ACCESS UNIT
2.1 Description
The Lobe Access Units are lobe extenders that
quadruple the lobe capacity of the standard Token
Ring MAU. The Lobe Access Unit increases the
flexibility of the Token Ring network by enabling its
topology to be expanded in a more cost-effective way.
It is especially designed to eliminate the need for an
additional MAU in situations where extra lobes are
needed. By using Lobe Access Units to add
workstations to the ring in place of extra lobe
cabling, overall design costs are reduced.
Connect four workstations to a single lobe with the
Lobe Access Unit. Or, an internal switch enables the
Lobe Access Unit to operate as a standalone access
unit. (See Figure 2-1.)
The LT0009A has five ports, each using DB9
connectors. The MAIN port is female, and the four
sub-ports are male. The LT0009A-UTP also has five
ports, but these use RJ-45 connectors. All five ports
are female.
2. Introduction
9
LOBE ACCESS UNIT
To ensure proper operation, you’ll need to use an
initialization tool (our part number LT037) during
the initial setup. This will need to be ordered
separately.
The Lobe Access Unit is small, lightweight, and easy
to install. No strapping adjustments or external
power supply are required.
Figure 2-1. Use as a standalone unit or connect
four workstations to a single lobe.
Standalone operation
Lobe Access
Unit Lobe Access
Unit
MAU
4 workstations connected
to a single lobe
Other manuals for LT0009A
1
This manual suits for next models
1
Table of contents
Other Black Box Network Hardware manuals
Black Box
Black Box Veri-NAC LVN5600A User manual
Black Box
Black Box Multi Quick Check RJ-11 User manual
Black Box
Black Box Veri-NAC Manual
Black Box
Black Box MX550A User manual
Black Box
Black Box JPM260 User manual
Black Box
Black Box MT190A User manual
Black Box
Black Box ME0005A-10BT User manual
Black Box
Black Box AC1003A User manual
Black Box
Black Box IC448A User manual
Black Box
Black Box JPM440A User manual
Black Box
Black Box 5000 series User manual
Black Box
Black Box AC504A User manual
Black Box
Black Box CMA005A User manual
Black Box
Black Box ServSwitch KV1081A User manual
Black Box
Black Box LrA502A-et-r5 User manual
Black Box
Black Box SW543A User manual
Black Box
Black Box SW1009A User manual
Black Box
Black Box COE-8I User manual
Black Box
Black Box LWS100AE User manual
Black Box
Black Box G.SHDSL NTU LB510A User manual
Popular Network Hardware manuals by other brands
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL product manual
B&B Electronics
B&B Electronics ZXT9-IO-222R2 product manual
Yudor
Yudor YDS-16 user manual
D-Link
D-Link ShareCenter DNS-320L datasheet
Samsung
Samsung ES1642dc Hardware user manual
Honeywell Home
Honeywell Home LTEM-PV Installation and setup guide
