BCM RX77Q User manual
User’s Manual V1.0
RX77Q
Intel® Q77 Micro ATX Motherboard (uATX) supports
2nd/3rd Gen. 22nm Intel® Core™ i7 / i5 / i3 Processors
ii
▍Preface
Copyright Notice
Copyright Notice
The material in this document is our intellectual property. We take every
care in the preparation of this document, but no guarantee is given as to the
correctness of its contents. Our products are under continual improvement
and we reserve the right to make changes without notice.
Trademarks
Trademarks
All trademarks are the properties of their respective owners.
￭Intel®is registered trademarks of Intel Corporation.
￭Windows®is registered trademarks of Microsoft Corporation.
￭AMI®is registered trademark of Advanced Micro Devices, Inc.
￭Realtek®is registered trademark of Realtek Semiconductor Corpora-
tion.
iii
RX77Q
Safety Instructions
Safety Instructions
￭Always read the safety instructions carefully.
￭Keep this User’s Manual for future reference.
￭Keep this equipment away from humidity.
￭Lay this equipment on a reliable flat surface before setting it up.
￭Make sure the voltage of the power source and adjust properly 110/220V
before connecting the equipment to the power inlet.
￭Place the power cord such a way that people can not step on it. Do not
place anything over the power cord.
￭Always Unplug the Power Cord before inserting any add-on card or mod-
ule.
￭All cautions and warnings on the equipment should be noted.
￭Never pour any liquid into the opening that could damage or cause electri-
cal shock.
￭If any of the following situations arises, get the equipment checked by ser-
vice personnel:
◯The power cord or plug is damaged.
◯Liquid has penetrated into the equipment.
◯The equipment has been exposed to moisture.
◯The equipment does not work well or you can not get it work according
to User’s Manual.
◯The equipment has dropped and damaged.
◯The equipment has obvious sign of breakage.
￭DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT UNCONDI-
TIONED, STORAGE TEMPERATURE ABOVE 80oC (176oF), IT MAY DAM-
AGE THE EQUIPMENT.
CAUTION
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer.
For better environmental protection, waste batteries should be
collected separately for recycling or special disposal.
iv
▍Preface
CE Conformity
CE Conformity
Hereby, we declare that this device is in compliance with the
essential safety requirements and other relevant provisions set
out in the European Directive.
FCC-B Radio Frequency Interference Statement
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the measures listed below:
￭Reorient or relocate the receiving antenna.
￭Increase the separation between the equipment and receiver.
￭Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
￭Consult the dealer or an experienced radio/television technician for help.
NOTICE 1
NOTICE 1
The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTICE 2
NOTICE 2
Shielded interface cables and AC power cord, if any, must be used in order to
comply with the emission limits.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference
that may cause undesired operation.
v
RX77Q
WEEE Statement
WEEE Statement
Under the European Union (“EU”) Directive on Waste Electrical and Elec-
tronic Equipment, Directive 2002/96/EC, which takes effect on August 13,
2005, products of “electrical and electronic equipment” cannot be discarded
as municipal waste anymore and manufacturers of covered electronic equip-
ment will be obligated to take back such products at the end of their useful life.
vi
▍Preface
ContentsContents
Copyright Notice .................................................................................ii
Trademarks .........................................................................................ii
Safety Instructions ............................................................................. iii
CE Conformity .................................................................................... iv
FCC-B Radio Frequency Interference Statement .............................. iv
WEEE Statement ................................................................................v
Chapter 1 Overview............................................................................... 1-1
Mainboard Specif cations ................................................................ 1-2
Mainboard Layout ........................................................................... 1-4
Block Diagram ................................................................................. 1-5
Chapter 2 Hardware Setup.................................................................... 2-1
Quick Components Guide ............................................................... 2-2
CPU (Central Processing Unit) ....................................................... 2-3
CPU & Cooler Installation .............................................................. 2-4
Memory ...........................................................................................2-6
Power Supply .................................................................................. 2-7
Back Panel I/O ................................................................................ 2-8
Connector ......................................................................................2-11
Jumper ..........................................................................................2-18
Slot ................................................................................................2-20
Chapter 3 BIOS Setup .......................................................................... 3-1
Entering Setup ................................................................................ 3-2
The Menu Bar ................................................................................. 3-4
Main .............................................................................................. 3-5
Advanced ....................................................................................... 3-7
Boot ............................................................................................. 3-13
Security ........................................................................................ 3-14
Chipset ......................................................................................... 3-16
Power ........................................................................................... 3-18
Exit ............................................................................................... 3-20
Chapter 1
Overview
Thank you for choosing the RX77Q, an excellent in-
dustrial computer board.
Based on the innovative Intel®Cougar Point chipset
for optimal system ef f ciency, the RX77Q accommo-
dates the Intel®Core i3/ i5/ i7/ Celeron processor
in socket LGA1 155 and supports up to four DDR3
1066/1333/1600 DIMM slots to provide the maxi-
mum of 32GB memory capacity.
In the advanced-level and mid-range market segment,
the RX77Q provides a high-performance solution for
today’s front-end and general purpose workstation, as
well as in the future.
▍2YHUYLHZ
Mainboard Specifi cationsMainboard Specifi cations
CPU
(Optional)
■,QWHO&RUHLLL&HOHURQSURFHVVRULQVRFNHW
/*$
Chipset ■,QWHO43&+
Memory ■''5',00VORWV
■6XSSRUWVWKHPD[LPXPRI*%
LAN ■*LJDELW)DVW(WKHUQHWE\,QWHO/ /0
*E(FRQWUROOHUV
SATA ■6$7$*EVSRUWVE\,QWHO&RXJDU3RLQW
■6$7$*EVSRUWVE\,QWHO&RXJDU3RLQW
RAID ■6$7$aVXSSRUW,QWHO5DSLG6WRUDJH7HFKQRORJ\
$+&,5$,'E\,QWHO&RXJDU3RLQW
Audio ■+'$&RGHFE\5HDOWHN$/&
■&RPSOLDQWZLWK$]DOLDVSHFV
Graphics ■6XSSRUWE\WKHLQVWDOOHGSURFHVVRU
Back Panel I/O ■36PRXVHSRUW
■36NH\ERDUGSRUW
■9*$SRUW
■'9,'SRUW
■VHULDOSRUW
■'LVSOD\SRUW
■*LJDELW/$1MDFNV
■86%SRUWV
■/LQH,QDXGLRMDFN
■/LQH2XWDXGLRMDFN
■0LF,QDXGLRMDFN
Onboard
Connectors/
Pinheaders
■86%SLQKHDGHUV
■DPSOLILHUSLQKHDGHU
■VHULDOSRUWFRQQHFWRUV
■*3,2SLQKHDGHU
■/9'6FRQQHFWRU
■IURQWDXGLRSLQKHDGHU
■FKDVVLVLQWUXVLRQSLQKHDGHU
■63',)SLQKHDGHU
1-3
RX77Q
Slot ■1 PCIe x16 slot (1st slot)
■1 PCIe x1 slot (2nd slot)
■1 PCIe x4 slot (3rd slot)
■1 PCI slot (4th slot)
■1 Mini-PCIe slot
Form Factor ■uATX: 244mm x 244mm
Environmental ■Operating Temperature: 0oC to 60oC
■Storage Temperature: -20oC to 80oC
■Humidity: 5% ~ 90% RH, Non-Condensing
1-4
Overview
▍
Mainboard Layout
Back Panel I/O
Serial Port
Connector
COM Power
Jumper
DIMM Slot
COM Power Jumper
Chassis Intrusion
Pinheader
Fan Power
Connector
Mini PCI-E Slot
LVDS Inverter Connector
Front Audio Pinheader
Clear CMOS
Jumper
LVDS Power
Jumper
AT/ATX Jumper
LVDS
Connector
Power Connector
Serial Port DVI-D Port
VGA Port
LAN Jack
USB 3�0
Port
Line-In Jack
Mic-In Jack
LAN Jack
Displayport
Mouse Port
Keyboard
Port
USB 3�0
Port
DVI-D Port
Line-Out Jack
Serial Port
Connector
Serial Port
Connector
Serial Port
Connector
Fan Power
Connector
COM Power
Jumper
COM Power
Jumper
24-pin Power
Connector
GPIO Pinheader
SATA
Connector
Front USB
Pinheader
Front Panel
Pinheader Parallel Port
Pinheader
Intel AMT ME
Jumper
S/PDIF
Pinheader
PCI-E
Slot
PCI
Slot
Audio
Amplier
Pinheader
CPU
Other manuals for RX77Q
1
Table of contents
Other BCM Motherboard manuals
