TL Electronic EmbeddedLine EL1092-Q User manual

6th /7th Gen. Intel®CoreTM

Fanless and

High Performance

Embedded PC

EL1092 M1

User Manual for

Embedded PC

EmbeddedLine EL44

TL Electronic GmbH

Bgm.-Gradl-Str. 1

85232 Bergkirchen-Feldgeding

Germany

Tel.: +49 (0)8131 33204-0

Fax: +49 (0)8131 33204-150

E-Mail: [email protected]

www.tl-electronic.de

EmbeddedLine EL1092-H (H110)

EL1092 6th / 7th Gen.

Intel® CoreTM Fanless and

High Performance Embedded PC

All trademarks and registered trademarks mentioned herein are the

property of their respective owners.

This manual is copyrighted in Mar. 2017. You may not reproduce or

transmit in any form or by any means, electronic, or mechanical,

including photocopying and recording.

DISCLAIMER

This user’s manual is meant to assist users in installing and setting up

the system. The information contained in this document is subject to

change without any notice.

CE NOTICE

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

FCC NOTICE

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

You are cautioned that any change or modifications to the equipment

not expressly approve by the party responsible for compliance could

void your authority to operate such equipment.

CAUTION: Danger of explosion may occur when the battery

is incorrectly replaced. Replace the battery only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s

instructions.

WARNING: Some internal parts of the system may have high

electrical voltage. We strongly recommend that only qualified

engineers are allowed to service and disassemble the

system. If any damages should occur on the system and are

caused by unauthorized servicing, it will not be covered by

the product warranty.

Contents

Revision History ............................................................................................ vii

1Introduction .........................................................................................1-1

1.1 About This Manual ..................................................................... 1-2

2Getting Started....................................................................................2-1

2.1 Package List ............................................................................... 2-2

2.2 System Overview ....................................................................... 2-3

2.2.1 Front View ........................................................................... 2-3

2.2.2 Rear View (For EL1092 Rx-x0x) ........................................ 2-4

2.2.3 Rear View (For EL1092 Rx-x1x) ........................................ 2-4

2.2.4 Top View ............................................................................. 2-5

2.2.5 Side View ............................................................................ 2-5

2.2.6 Quarter View ....................................................................... 2-6

2.3 System Specifications ................................................................ 2-7

2.4 Safety Precautions ..................................................................... 2-9

3System Configuration.........................................................................3-1

3.1 CONNECTOR & JUMPER QUICK REFERENCE TABLE ......... 3-2

3.2 Component Locations ................................................................ 3-4

3.2.1 Top View and Jumper Settings of EL1092 ........................ 3-4

3.2.2 Bottom View of EL1092 ..................................................... 3-6

3.3 How to Set Jumpers ................................................................... 3-7

3.4 Function Buttons and I/O Ports .................................................. 3-9

3.4.1 Power Button ...................................................................... 3-9

3.4.2 DC IN Port (For EL1092 Rx-x0x) ....................................... 3-9

3.4.3 DC IN 3 Pins Terminal Block (For EL1092 Rx-x1x) ......... 3-10

3.5 Setting Connectors and Jumpers ............................................. 3-11

3.5.1 COM Port .......................................................................... 3-11

3.5.2 COM1 Pin9 and COM2 PIN18 Definition Selection Guide3-14

3.5.3 LAN1, LAN2 Ports............................................................. 3-15

3.5.4 4 x 1 USB 3.0 Connectors ................................................ 3-17

3.5.5 Dual USB 2.0 (H110) / USB 3.0 Connectors (Q170) ........ 3-18

3.5.6 Digital Input/Output Connector (For EL1092 Rx-x1x)

(optional). .......................................................................... 3-19

3.5.7 Digital Input/Output Connector (For EL1092 Rx-x0x)

(optional). .......................................................................... 3-20

3.5.8 DVI-I Port .......................................................................... 3-21

3.5.9 HDMI Port Connector ....................................................... 3-22

3.5.10 HD Audio Connector ......................................................... 3-23

3.5.11 Mini PCI Express Slots ..................................................... 3-24

3.5.12 Serial ATA (SATA) 3.0 Connectors .................................... 3-26

3.5.13 SATA Power Connectors ................................................... 3-27

3.5.14 Power Input Connector ..................................................... 3-28

3.5.15 DC Power Input Connector ............................................... 3-28

3.5.16 DC Out Port (Front Panel) (optional) ................................ 3-29

3.5.17 Power Output Connector .................................................. 3-29

3.5.18 PCI Express Slot (x4) ....................................................... 3-30

3.5.19 I2C Wafer (optional) .......................................................... 3-31

3.5.20 Parallel Port (LPT) Connector (optional) .......................... 3-31

3.5.21 Power Button Connectors ................................................. 3-32

3.5.22 Rear Panel Power LED Connector ................................... 3-33

3.5.23 Rear Panel HDD LED Connector ..................................... 3-33

3.5.24 CompactFlash Card Connector ........................................ 3-34

3.5.25 SIM Card Slot .................................................................... 3-35

3.5.26 Hardware Power Failure Selection ................................... 3-35

iii

3.5.27 CFast Voltage Control Selection ....................................... 3-36

3.5.28 Low Pin Count (LPC) Connector ...................................... 3-36

3.5.29 Flash Descriptor Override Selection ................................. 3-37

3.5.30 VCCIO Voltage Selection .................................................. 3-37

3.5.31 BIOS Recovery Mode Selection ....................................... 3-38

3.5.32 Clear CMOS Data Selection ............................................. 3-38

4Software Utilities.................................................................................4-1

4.1 Introduction................................................................................. 4-2

4.2 Installing Intel® Chipset Software Installation Utility .................. 4-5

4.2.1 Introduction ......................................................................... 4-5

4.2.2 Intel® Chipset Software Installation Utility .......................... 4-5

4.3 Intel® Management Engine Components Installer Installation .. 4-6

4.4 Intel® USB 3.0 eXtensible Host Controller Utility ...................... 4-8

4.5 Installing RAID Driver Utility (Only for Q170, Optional) ............. 4-9

4.6 Installing Graphics Driver Utility ............................................... 4-11

4.7 Installing LAN Driver Utility ....................................................... 4-12

4.8 Installing Sound Driver Utility ................................................... 4-13

5BIOS SETUP ........................................................................................5-1

5.1 Introduction................................................................................. 5-2

5.2 Accessing Setup Utility ............................................................... 5-4

5.3 Main ............................................................................................ 5-7

5.4 Advanced ................................................................................... 5-9

5.4.1 Advanced - CPU Configuration ......................................... 5-10

5.4.2 Advanced - PCH-FW Configuration .................................. 5-12

5.4.3 Advanced – Trusted Computing ....................................... 5-13

5.4.4 Advanced – ACPI Settings ................................................ 5-14

5.4.5 Advanced – SATA Configuration ....................................... 5-15

5.4.6 Advanced – Hardware Monitor ......................................... 5-16

5.4.7 Advanced – F81866 Misc Configuration ........................... 5-17

5.4.8 Advanced – F81866 Super IO Configuration .................... 5-18

5.4.12 Advanced - Network Stack Configuration ......................... 5-26

5.4.13 Advanced – USB Configuration ........................................ 5-28

5.5 Chipset ..................................................................................... 5-29

5.5.1 Chipset – System Agent (SA) Configuration ..................... 5-30

5.5.1.1 Chipset – SA Configuration - Memory Configuration ..... 5-32

5.5.1.2 Chipset – System Agent (SA) Configuration – Graphics

Configuration .................................................................. 5-34

5.5.2 Chipset – PCH-IO Configuration ....................................... 5-36

5.5.2.1 Chipset – PCH-IO Configuration – PCI Express

Configuration .................................................................. 5-37

5.6 Security .................................................................................... 5-41

5.7 Boot .......................................................................................... 5-43

5.7.1 Boot – Network Device BBS Priorities .............................. 5-45

5.7.2 Boot – Hard Drive BBS Priorities ...................................... 5-46

5.7.3 Boot – CSM Configuration ................................................ 5-47

5.8 Save & Exit ............................................................................... 5-49

Appendix A System Diagrams....................................................... 1

EL1092 System Exploded Diagram ................................................................. 2

Appendix B Technical Summary................................................... 1

Interrupt Map ......................................................................................................... 2

I/O Map ................................................................................................................ 19

Memory Map ....................................................................................................... 20

Configuring WatchDog Timer ............................................................................ 22

Flash BIOS Update ............................................................................................ 24

List of Figures

Figure 3-1. Main Board Component Location (Top View) ................. 3-4

Figure 3-2. Main Board Component Location (Bottom View) ............ 3-6

Figure 5-1. Extensible Firmware Interface Diagram ......................... 5-2

Figure 5-2. POST Screen with AMI Logo.......................................... 5-4

vii

Revision History

The revision history of EL1092 User Manual is described below:

Version No.

Revision History

Date

Initial Release

2017/06

This manual suits for next models

Table of contents

Other TL Electronic Desktop manuals

TL Electronic

TL Electronic EL1083 User manual

Popular Desktop manuals by other brands

HP m9060n - Pavilion - Elite Quick setup

Asus

Asus E210 Series user guide

Dell

Dell Inspiron 600m quick start

Dell

Dell Inspiron 3662 Service manual

TotalFlow

TotalFlow uFLO user manual

HP Presario SV7000 - Desktop PC manual

HP ProDesk 400 G5 Maintenance and service guide

Logitech

Logitech MK320 quick start guide

Dell

Dell XPS 730 H2C Service manual

Sony

Sony Vaio Series operating instructions

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer quick start

Alto

Alto MD 250 instruction manual

Lenovo

Lenovo ThinkCentre Edge 72 Manual

Lenovo

Lenovo ThinkStation D20 Manual

Arbor Technology

Arbor Technology FPC-7800 Series user manual

Sony

Sony VAIO VGX-TP1 Series user guide

Asus

Asus Eee Box B204 user manual

Dell

Dell Optiplex 9010 All In One owner's manual