Sunlighten MPulse Discover User manual

ASSEMBLY INSTRUCTIONS

included in door handle

7x 2x 2x 2x

1 2 3 5 6 7

8x 5x 4x 1x 1x

M6x70

Allen wrench Philips Screw Driver

47x

M6x55

A B C D

1x Roof

1x Back Wall

1x Left Wall

1x Bench

1x Right Wall

1x Front Wall

2x Glass Doors

E1x Floor

UK ASSEMBLY INSTRUCTIONS Discover

1sunlighten.com.au

1sunlighten.com/gb-en

The ﬁrst step to installing your new sauna

will be to insert the legs underneath the

ﬂoor panel. The holes are already pre-drilled

so all you need are the bolts and the

Allen wrench . This is necessary to allow

air circulation to ﬂow underneath and

maintain the integrity of the unit. After legs are

in place, please turn ﬂoor panel 180° so the back

of the sauna connects with the back wall

as shown below.

STEP 1

Before you begin installing the walls, be sure you

have at least:

• 15cm between the back of the sauna and the

outlet wall.

•30 cm gap from the top of the sauna to the ceiling.

•Place the sauna next to the wall power outlet to

ensure you have access to the wall power socket

outlet to cut the power to the unit if required.

Unscrew the screws holding the ﬂoor covers at the

rear of the ﬂoor.Then remove the ﬂoor covers (take

care not to step on the electrical components).

Make sure the ﬂoor panel is placed on a surface that

is relatively smooth and perfectly level. Failure to do

so can cause the door to not close all the way in the

later steps.

In this step, make sure one person is holding the

wall while the other helps balance it and press it in

place.

STEP 2

PRE-STEPS

230 V, 4200 W

Requires hard-wired dedicated outlet.*

3m cord exists from back left of base.

6sunlighten.com.au

2sunlighten.com/gb-en

* Failure to do so will void your sauna's warranty

and customer will assume liability for any electrical

damages to the sauna itself or the residence/business

in which the sauna is installed.

See USER MANUAL

Unpack each wall segment from the shipping material, stage each

wall segment in the room you will be assembling the unit.

Remove the internal wooden heater frames during unpacking

of the wall segments, set these aside for installation after

the sauna is assembled.

Remove the small wooden wire covers at the base of each vertical

wall segment, set aside for placement after sauna is assembled.

Back of sauna

Front of sauna

Back of sauna

STEP 3 STEP 4

The front wall will be the last to install.

There will be wire connections that need to be made

at the base of each wall panel. These can be accessed

by small hatches on the walls (ﬂoor hatch for the

front). If a cable gets stuck in the ﬂoor it can be

accessed by removing the wood piece that covers

the powerbox.

A diagram showing the connection locations

can be found on STEP 8.

NOTE: If you ever have trouble getting

a U-clip to slide in, this can be resolved by

tapping it with a hammer.

The following walls will be inserted the same way

as STEP 2. Make sure the wires coming out from

the bottom hatches don’t pinch when you mount

the walls.

STEP 5

After you place each wall segement, please

use the U-clips and insert them in each

upper corner to hold the walls together.

6sunlighten.com.au

3sunlighten.com/gb-en

STEP 6

After all four U-clips are inserted

in the corners, the next step will be

to place the roof on top. The roof will also

reinforce the walls in position along with the clips.

NOTE: The roof may require some slight

manipulation to fall into place on top of

the wall panels.

STEP 7

6sunlighten.com.au

4sunlighten.com/gb-en

Lights, Blaupunkt/

Sound Therapy Receiver

D15

D16

D17

After the roof is placed, remove the dust covers.

There should be the connections to the lights and

speakers at the top front. Connect those so you

can turn on the lights and listen to sound.

• Connect 3-pin rectangular plug (D15 – two red,

one white) into E5.

• Connect E5 to SP-Amp.

• Connect D17 RCA plugs (one red and one white)

to left side of SP-Amp.

• Leave D16 cable 4-pin, white rectangular

connector and second D15 3-pin rectangular

connector unplugged unless you purchased the

Sound Therapy Kit.

• If Sound Therapy was purchased, plug D15 and

D16 into E8.

• Plug E8 into SS-Amp.

6sunlighten.com.au

5sunlighten.com/gb-en

STEP 8

Right Wall Heaters

Back Wall Heaters

Left Wall Heaters

6sunlighten.com.au

6sunlighten.com/gb-en

Front Wall Heaters,

Lights, Blaupunkt/

Sound Therapy Receiver,

Control Panel

The dust cover should be replaced to protect

the lights and speakers from dust and other

ﬂoating residue. As mentioned in STEP 5, there

are four connections to be made in each bottom

section of the walls. If you have not yet done so,

consult with the diagram at the bottom of this page.

After the four ﬂoor connections have been made,

replace the ﬂoor covers as mentioned in STEP 2,

then replace and install the bench . Make sure

the heater frames are not mounted, otherwise

they will prevent the bench from resting on the

supports. The large portion of the bench will go

in ﬁrst, on the back wall support. Last will be the

small part which rests on the cutout of the large

bench piece, as well as the support against the

right wall. There will be two screws to screw into

the two holes on the corner where the two door

thresholds meet.

Now, place the heater frames in their

respective locations. NOTE: Look at

the back of the heater frames

for the “This Side Up”

sticker for proper orientation.

STEP 9

After the bench is placed in the unit, the next step

will be inserting the left glass door . Please

ensure you have at least one other person to assist

with this step. Do not put the door handles on as that

will be done in a later step after the door has been

safely attached in this step.

The hinges can be secured following instructions

given on Step 10 below.

NOTE: You can use a paint stick to shim the glass

door at a desirable angel above the threshold as

you mount it.

STEP 10

Using the Allen wrench , you will tighten the

bolts into the hinges as the door is inserted.

Make sure the bolt is inserted ﬁrmly. Each hinge will

have four plastic gaskets. The door will be inserted

between the four gaskets.

Make sure the rough-texture side of the gasket is

against the glass door as your insert it. This will give

it the grip needed to hang it. Likewise, make sure the

gaskets touching the hinges also are doing so by the

rough side.

6sunlighten.com.au

7sunlighten.com/gb-en

STEP 11

The gaskets, bolts and washers , and

will come with the handles. The washers need to be

inserted into the door holes ﬁrst before the gaskets

go on and eventually the bolts. The rough side of the

gaskets must be facing the glass door. Be sure to

have a second person hold the handle in place while

the other inserts the bolt.

1 2 3

6sunlighten.com.au

8sunlighten.com/gb-en

CONGRATULATIONS, your sauna is now ready to enjoy!

If you have any queries, please call

Sunlighten Customer Support at 0330.808.1203.

10062023

Other manuals for mPulse Discover

Other Sunlighten Plumbing Product manuals

Sunlighten

Sunlighten Signature II User manual

Sunlighten

Sunlighten SIGNATURE EURO 1 User manual

Sunlighten

Sunlighten Amplify II User manual

Sunlighten

Sunlighten Signature IV User manual

Sunlighten

Sunlighten mPulse Aspire User manual

Sunlighten

Sunlighten Signature I User manual

Sunlighten

Sunlighten Signature I User manual

Sunlighten

Sunlighten Signature IV User manual

Sunlighten

Sunlighten ADA User manual

Sunlighten

Sunlighten mPulse cONQUER User manual

Sunlighten

Sunlighten Amplify III User manual

Sunlighten

Sunlighten Signature I User manual

Sunlighten

Sunlighten Solo System User manual

Sunlighten

Sunlighten mPulse Aspire User manual

Sunlighten

Sunlighten mPulse 3-in-1 Series User manual

Sunlighten

Sunlighten Amplify II User manual

Sunlighten

Sunlighten Solo System User manual

Sunlighten

Sunlighten Signature Series User manual

Sunlighten

Sunlighten Signature I User manual

Sunlighten

Sunlighten Solo System User manual

Sunlighten

Sunlighten mPulse eMPOWER User manual

Sunlighten

Sunlighten mPulse User manual

Sunlighten

Sunlighten mPulse Discover User manual

Sunlighten

Sunlighten mPulse 3-in-1 Series User manual

Popular Plumbing Product manuals by other brands

Weka

Weka 506.2020.00E ASSEMBLY, USER AND MAINTENANCE INSTRUCTIONS

Kohler

Kohler K-6228 Installation and care guide

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Operator's manual

American Standard

American Standard DetectLink 6072121 manual

Uponor

Uponor Contec TS Mounting instructions

Pfister

Pfister Selia 49-SL Quick installation guide

Fortis

Fortis VITRINA 6068700 quick start guide

Fortis

Fortis MILANO 78211JS installation instructions

Kohler

Kohler K-12183 Homeowner's guide

Maxxus

Maxxus MX-M206-01 instruction manual

Moen

Moen 5922 Series installation instructions

Viega

Viega Prevista Pure 8512 Instructions for use

Kohler

Kohler Centerset K-15240 Homeowner's guide

Viega

Viega Prevista Dry 8522.33 Instructions for use

Sanela

Sanela Lema SLP 59RB Instructions for use

Elkay

Elkay EDF15AC Installation, care & use manual

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Instructions for use/assembly instructions

baliv

baliv WT-140 manual