1
Precaution and Safety Guidelines
Please read this user’s manual thoroughly prior to use the unit for
its easy and convenient use.
Do not install the product in the following places: extremely low or high
temperature conditions; places exposed to rain, snow, or high
humidity; places containing or exposed to oil and gas; places exposed
to vibration and shock; places under direct sunlight or exposed to
outdoor weather conditions; places exposed to radio waves (RF) or near
to power lines. It may cause low performance or malfunction of the unit.
Do not disassemble the unit and do not insert any foreign objects inside
the unit. It may cause malfunction or damage to the unit.
To reduce the risk of fire or electric shock, please be careful on electric
shock when using the unit.
Please using only power supply units or equipment corresponding to the
unit in order to avoid any fire risk or or malfunction of the unit.
The optimum ambient temperature for the use of the Device is -10°C ~
50°C, and it needs to be careful when the Device is used for both inside
and outside the building.
Should be careful not to have the lines changed when connecting them.
When you connect the operating power line to the Camera, you should
confirm if the Camera uses AC or DC power, and for the case of DC
power then you should be careful not to have the polarity changed to
the wrong one (If you connect the AC Adapter to Transmitter, and
connect the DC Adapter to the Receiver, then it would cause a
breakdown).
Please turn on the switch for power supply after confirming the
insulation condition of the control cable connected from the outside.
Giving a strong vibration or impact to the Device could cause a
breakdown, therefore adequate precautions should be taken when
installing or using the Device.
Do not use the device when any smoke or smell is produced from the
unit. It may be subject to fire or electric shock. If any smoke or smell is
produced, please turn off the unit and remove the power cable
immediately, and contact your distributor to check the device properly.
If the power is not ON, please check whether the power cable is
connected correctly or not.
If the device is not working properly, please contact your distributor.
