Samsung SCC-C7478 User manual

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

SCC/SNC-C7478

Installation Guide

36x PTZ Dome Camera

Connection for power

RJ-45 Connection

7. Pull retractable safety cable

from bottom of camera and

insert into hook, inside upper

housing.

(figure 7a)

1. Remove junction box cover with supplied hex tool to view inner connection block.

(figure 1a)

Inner connection block exposes connections for power, video, alarm input/output as well

as dip switches for selecting camera ID, protocol, baud rate and termination.

(figure 1b)

See

manual for proper settings.

2. Attach wall mount to wall with supplied anchor bolts and make connections.

Inner Box connections

*Note for RS-485 Connection:

GVI uses solid colored wire to represent posi-

tive (+) and striped wire for negative(-) polar-

ity. Regardless of the wire color you choose

make sure polarity matches on oth ends of

the connection

Cable connection for dome. Connect

cable from mount into upper housing

Inside view of upper housing

3. Remove camera mechanism from upper housing.

(figure 3a)

4. Use Teflon tape (included) to wrap around pipe fitting.

(figure 4a)

5. Attach safety cable to neck of mount.

(figure 5a)

6. Attach other end of safety cable to housing

(figure 6a)

and now screw in upper

housing to mount pole, bring in cable from pole mount and attach.

(figure 6b)

afety cable to mount

Teflon tape for tight connection

afety cable to housing

Retractable safety cable

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

9. Attach fan and heater cables inside upper housing and attach dome cover safety

cable.

(figure 9a)

10. Return PTZ camera mechanism into upper housing by pressing the

two black handles until camera mechanism snaps into

place.

(figure 10a)

11. Close the dome cover by matching the arrow markers. Be sure internal

cabling does not obstruct camera’s movement.

12. Orientation of housing my be adjusted by rotating the ring on which the

safety cable is attached.

(figure 12a)

Completed mounted camera

Fan/heater cable

afety Cable

10a

12a

Remove plastic covering carefully and power dome with 24 VAC 2.5 amps

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

SNC-C7478 Setup Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

IP Setup Guide

36x PTZ IP Dome Camera

SNC-C7478

1. Plug the included cross-over cable into the RJ-45 jack located inside the

inner connection block.

(figure 1a)

2. Plug the other end of the cross-over cable into the RJ-45 jack on back of

your computer.

(figure 2a)

3. From included CD, run the application titled IPInstaller. This will open a

window and scan your computer to locate the default IP address and subnet

mask assigned to the IP dome.

(figure 3a)

4. Once camera has been identified within the window, you may view the default IP settings by first selecting

(clicking) the camera entry in the window, then choosing Manual Set in the lower right of the IPInstaller

window. Make note of the camera IP Address and the Subnet

Mask. You will refer to these in future steps.

(figure 4a)

After

these values have been viewed and written down, you may can-

cel from the Manual Setting window and you may exit the

IPInstaller.

5. Next you will need to set your computer with a static IP address

as well as set your Subnet Mask to the same value as the IP PTZ

Dome Camera. (Subnet Mask value from previous step)

6. From your computer’s Control Panel go to Network and Internet Connections. Enter Network Connections

so that you are able to view all available Network Connections. Your screen should look similar to the

figure below.

(figure 6a)

SNC-C7478 Setup Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

7. Double click on Local Area Connection to bring up the Local Area Connection Status

box.

(figure 7a)

Click Properties in the lower left corner to display Local Area Connection

Properties.

8. From the Local Area Connection Properties window, double click

Internet Protocol (TCP/IP) to display Internet Protocol (TCP/IP)

Properties.

(figure 8a)

9. Choose the option for Use the Following IP Address and type an

IP address that begins with 192.168.1. but use a number other

than the ending number assigned to the camera. (number must fall

between 1 and 255)

(figure 9a)

10. Type the subnet mask, this number must be the same as the

camera’s subnet mask, then choose OK at the bottom of the Inter-

net Protocol (TCP/IP) Properties box.

11. You may now close out of the Network Connections window.

12. After the above steps have been completed you may now use Microsoft’s Internet Explorer to enter the

camera’s setup menu.

13. Open an Internet Explorer window. In the address bar at the top of the window type HTTP:// followed by

the IP address assigned to your camera. (This value was obtained in step 4)

(figure 13a)

14. See users manual for full explanation of menus and

settings.

15. Once you have finished with camera setup and have

exited from browser, be sure to go back into your

network settings and return all of your settings to

normal.

Accessing the Camera Menu from Internet Explorer

13a

Other manuals for SCC-C7478

This manual suits for next models

Table of contents

Other Samsung Security Camera manuals

Samsung

Samsung SCC-B535x(S) User manual

Samsung

Samsung iPolis SNP-3371TH User manual

Samsung

Samsung SCC-B5344 User manual

Samsung

Samsung SDC-313 SERIES User manual

Samsung

Samsung SNZ-5200 User manual

Samsung

Samsung SCC-B5203(S)P User manual

Samsung

Samsung iPolis SNO-5080R User manual

Samsung

Samsung SIR-4250 User manual

Samsung

Samsung VG-STC3000 User manual

Samsung

Samsung SCC-B5393 User manual

Samsung

Samsung SCC-C7453P User manual

Samsung

Samsung SCP-3370TH User manual

Samsung

Samsung SCC-B5300(G)(P) User manual

Samsung

Samsung SHC-737 Series User manual

Samsung

Samsung SCB-2001 User manual

Samsung

Samsung SCC-B5367 User manual

Samsung

Samsung iPolis SNP-6200RH User manual

Samsung

Samsung iPolis SNV-1080R User manual

Samsung

Samsung iPolis SNO-5080R User manual

Samsung

Samsung Scc-C6475 User manual

Samsung

Samsung SCV-2081R User manual

Samsung

Samsung iPolis SNP-3302 User manual

Samsung

Samsung SDC-425N User manual

Samsung

Samsung SNP-6201 User manual

Popular Security Camera manuals by other brands

Okina USA

Okina USA SIR36-870VF650LP user manual

Divio

Divio NDR155PA user manual

Canon

Canon VB-C500D Specifications

Easy Access

Easy Access EasyGuard user manual

Vivotek

Vivotek FD9389-EHV-v2 Quick installation guide

TUYA

TUYA COSMO W2 manual

Eusso

Eusso UNC7500-IR Advanced installation guide

urmet domus

urmet domus 1096/204 user manual

VC VC20 series operating manual

Axis

Axis Q1614 installation guide

ieGeek

ieGeek DD201 manual

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Installation and user guide

Vicon

Vicon V662-D-1 Installation and operation guide

Grundig

Grundig GCH-K0274P owner's manual

Lorex

Lorex VANTAGE LBC7032 quick start guide

4xem

4xem WPT Specifications

Vitek

Vitek VTC-C544 Specifications

Lumens

Lumens VC-A50PNW installation guide