Prorack K111 User manual
K111
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 1 x 4 x 4 x 4
x 4 x 4 x 4
Revision No: 5C 1
Fitting Kit K111
MAX kgs (lbs)
W/P WHD
Peugeot
406 , 4dr Sedan 95-04 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan 95-04 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan 96-04 ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan 96-04 ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan Aug 96-Aug 04 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan Aug 96-Aug 04 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan Sep 96-Aug 04 AU 50 kgs (110 lbs) 50 kgs (110 lbs)
406 , 4dr Sedan Sep 96-Aug 04 AU 50 kgs (110 lbs) 50 kgs (110 lbs)
Ford
Escort , 5dr Hatch 90-99 AU 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 90-99 AU 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 90-99 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 90-99 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 90-99 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 90-99 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 91-99 ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
Escort , 5dr Hatch 91-99 ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
2
Fitting Kit EN
K111
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
3
Fitting Kit EN
K111
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment.
●Ensure each end of the crossbar is
adjusted equally.
4
Fitting Kit EN
K111
●Remove locking screw.
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Apply protective strip as shown.
Trim if required.
5
Fitting Kit EN
K111
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Fit rubber pad (supplied with crossbar) to
foot.
●Make sure the pad fits into the holes
underneath the foot.
6
Fitting Kit EN
K111
Fitment
●Pull back rubber seal to expose fixed points
on vehicle body.
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Please check the rear of this manual for
information relating specifically to your
vehicle.
●Press adjusting screw to adjust the leg
positions on the crossbar.
7
Fitting Kit EN
K111
●Tighten adjusting screw to 5 Nm (3.7 ft lb).
●Place clamp over the mounting hole
●Fit a fibre washer on each capscrew and
attach clamps to the vehicle body using the
capscrews.
●M6 = Ford
M8 = Peugeot
●Tighten locking screw on both legs evenly.
8
Fitting Kit EN
K111
●Refit rubber seal over the clamp.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9
Fitting Kit EN
K111
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Table of contents
Other Prorack Automobile Accessories manuals
Prorack
Prorack K600 User manual
Prorack
Prorack K309 User manual
Prorack
Prorack WHISPBAR S46 Operation and installation manual
Prorack
Prorack K094 User manual
Prorack
Prorack K802 User manual
Prorack
Prorack K420 User manual
Prorack
Prorack K075 User manual
Prorack
Prorack K1012 User manual
Prorack
Prorack K997W User manual
Prorack
Prorack K867 User manual
Prorack
Prorack K1222 User manual
Prorack
Prorack K153 User manual
Prorack
Prorack K465 User manual
Prorack
Prorack K511 User manual
Prorack
Prorack 8062003 User manual
Prorack
Prorack K040 User manual
Prorack
Prorack K595 User manual
Prorack
Prorack K525 Operation and installation manual
Prorack
Prorack K824W User manual
Prorack
Prorack K010 User manual
