- 2 -
When using an electrical device, basic safety precautions should always be
followed, including the following:
Read all instructions before using the PrintDry filament dryer (hereinafter
referred as the "dryer").
Always use a heat resistant surface.
DO NOT touch hot surfaces.
To protect against electrical hazards, DO NOT immerse cord, plugs, or the
dryer in water or any other liquid. DO NOT switch the dryer ON if surfaces
are wet.
Do not allow children to use this dryer, close supervision is necessary when
the dryer is used near children.
Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts.
DO NOT operate the dryer with a damaged cord or plug or after the dryer
malfunctions, or has been damaged in any manner. Return the dryer to the
manufacturer for examination, repair or adjustment. See Warranty section.
The use of accessories/attachments not recommended may cause hazards.
DO NOT use outdoors.
DO NOT let cord hang over edge of table or counter, or touch hot surfaces.
DO NOT place on or near a hot gas or electric burner, or in a heated oven.
DO NOT block the air vents.
DO NOT use for other purposes other than the intended use.
To disconnect, turn the power switch to ‘OFF’, then unplug from the wall
outlet.
DO NOT pour liquids into the dryer.
DO NOT operate near combustible or pressurized spray cans.
DO NOT use the dryer for longer than 40 continuous hours. After a
maximum of 40 hours in use, turn OFF the dryer, unplug and allow it to cool.
