PiXORD P606 User manual
P-606(W) Quick Guide
1. Hardware Connection
P-606(W) – Physical Overview
P-606(W) – Physical Connection
1. Prepare a PC with Ethernet link to the network
2. Connect LAN port (RJ45) of the camera to a network switch/hub
3. Connect power jack
4. Ensure the power adaptor specification matches the power system (110V or 220V) and
connect the adaptor to the outlet
5. Check LED status (Power/Network)
2. Software Installation
The following software is necessary for the proper display and use of the camera/video
server from the Web site. The software will be taken from the Software Package CD.
IP Installer
The IP Installer is used to locate and configure network cameras and video servers in the
LAN.
3. Network Configuration
Using IP Installer to Assign IP Address
1. Once IP Installer has been successfully installed on the PC, double click to run the
software.
2. Click the menu bar [Tool] > [Search Network Device] to search the device in the LAN.
3. Select device with the MAC Address corresponds to the camera that is to be configured.
4. Double click the item to open the Property Page or click the menu bar View > Property.
MAC Address
5. Modify the network settings of the camera.
6. After filling in the properties, click [Synchronize] button to complete the configuration
settings then click [OK] button to save in the PC.
Open the Web-based UI
1. To access the Web-based UI of the selected unit, run the View > Open Web on the menu
bar.
2. For first time user, there will be a prompt to install the ActiveX control. Confirm the
installation as it is required to view the video stream and some operations.
3. If the device has been configured correctly, the default Web browser will open to the
home page of the selected device.
* Username and password is required. (Default is admin / admin)
Verify and Complete the Installation from Your Browser
If not able to get the ActiveX download properly, user must temporarily lower your security
settings to perform a one-time-only installation of the ActiveX component onto your workstation,
as described below:
1. From the Tools menu, select [Internet Options] -> [Security] -> [Custom Level]
2. Set the security level to Low and click [OK].
3. Restore the security level after theActiveX installation.
Other manuals for P606
1
This manual suits for next models
1
Table of contents
Other PiXORD Security Camera manuals
PiXORD
PiXORD P-463 User manual
PiXORD
PiXORD PB670 User manual
PiXORD
PiXORD PD771 User manual
PiXORD
PiXORD PS760D User manual
PiXORD
PiXORD PB731P User manual
PiXORD
PiXORD PD636 User manual
PiXORD
PiXORD PD736 5MP User manual
PiXORD
PiXORD H.264 Series User manual
PiXORD
PiXORD 261 series User manual
PiXORD
PiXORD PD637 User manual
