oticon FittingLINK 3.0 User manual
Instructions for use
Wireless
accessories
Remote Control 3.0
Introduction to this booklet
This booklet guides you on how to use and maintain your new
Remote Control 3.0. Please read the booklet carefully including the
Warning section. This will help you get the most out of your new
remote control.
If you have further questions about using your remote control,
please contact your hearing care professional.
For your convenience this booklet contains a navigation bar to help
you navigate easily through the different sections.
About Startup Daily use Warnings More info
Intended use
Remote Control 3.0 is intended to assist users of wireless hearing aids
to control functionality provided by their hearing solution.
Remote Control 3.0 is intended to be used by children (> 36 months)
and adults together with their hearing solution.
Table of contents
About
Package contents 6
Product overview 7
Startup
Batteries 8
Insert batteries 9
Pairing the remote control with your hearing aids 11
Daily use
Operating range 14
Confirmations 15
Change programme 17
Adjust volume 18
Mute 19
Unmute 20
Strap hole 21
Taking care of your remote control 22
Warnings
Warnings 24
More info
International warranty 28
Technical information 29
6 7
About Startup Daily use Warnings More info
About
Package contents
You will find the following items in the package:
Product overview
This booklet
BatteriesRemote Control 3.0
Status light
Volume up
Battery cover
Strap hole
Volume down/
Mute
Programme
change
2 x AAAA
Instructions for use
Wireless
accessories
Remote Control3.0
8 9
Batteries
To activate the remote control you need to insert two AAAA
batteries into the battery compartment. See the “Insert batteries”
section.
Battery life will vary depending on the conditions of use. Standard
use requires battery replacement approximately once a year.
About Startup Daily use Warnings More info
Click
Gently remove the
battery cover.
Remove any used
batteries.
Place the new bat-
teries in the battery
compartment.
Make sure that
the “+” sign on the
battery matches
with the “+” sign in
the battery compart-
ment.
Insert the battery
cover at the top.
Then press the
battery cover down
gently until it clicks
into place.
1 Remove 2 Insert 3 Close
Insert batteries
+
Start up
10 11
Pairing the remote control with your hearing aids
The remote control is a personal device intended to be used with
one set of hearing aids. The remote control can operate up to two
hearing aids at a time after pairing.
Before the remote control can be used with your hearing aids, the
devices need to be paired.
You can choose to pair the remote control with either two hearing
aids at the same time or with one hearing aid at a time. You need to
repeat the pairing process if you choose to pair your hearing aids
one at a time.
In the instructions on the next page a set of hearing aids is being
paired with the remote control.
The battery cover should never be forced. If force is required to
click the battery cover into place, check the alignment and
reposition the cover so that it clicks easily into place.
About Startup Daily use Warnings More info
12 13
About Startup Daily use Warnings More info
3. Pair the remote control with the hearing aids
Press and hold all buttons for 5 sec-
onds. The status LED will flash green
twice.
The status LED will then glow green
for about 10 seconds to confirm the
remote is ready for pairing.
Ensure that you have good batteries
in the hearing aids.
Open the battery drawers of both
hearing aids. Wait about five seconds
and close the battery doors again.
Wait for about 10 seconds – until the
hearing aids are fully turned on and
the power-on-jingle has been played.
The hearing aids will remain in pairing
mode for 3 minutes.
1. Prepare remote control
for pairing
2. Put the hearing aids in
pairing mode
Place both hearing aids
within 20 centimetres
of the remote control.
Briefly press any key on
the remote control to
make it automatically
pair with the hearing
aids.
When pairing is com-
pleted, the status light
glows green for about
10 seconds.
14 15
Operating range
With the remote control you can operate your hearing aids from
a distance of up to 1.8 metres. A direct line of sight between the
remote control and your hearing aids is not required. If you have
paired two hearing aids to the remote control, both will be adjusted
at the same time.
Conrmations
Visible indications
The status light on the remote control will light up when a button is
pressed.
About Startup Daily use Warnings More info
Audible indications
You will hear a sound in your hearing aids which confirms the action
performed.
Up to 1.8 m
Daily use
16 17
About Startup Daily use Warnings More info
Battery low
If the batteries are running low the status light will blink rapidly
whenever a button is pressed. In this case replace the batteries at
your earliest convenience.
Change programme
The remote control can be used to change pro-
gramme if your hearing care professional has made
more than one programme available in your hearing
aids.
Shortly press the “•” button on the remote control
to go through the hearing aid programmes. Each
press will advance the hearing aids to the next
programme in the cycle.
IMPORTANT NOTICE
Please refer to your hearing aid’s “Instructions for Use” for details on
the functionality of your specific hearing aid solution.
Press to change
programme
18 19
About Startup Daily use Warnings More info
Adjust volume
With the remote control you can adjust the volume of your hearing
aids by using the volume control buttons.
You will hear a short confirmation in your hearing aids when you
turn the volume up or down.
Mute
Use the mute function if you need to silence the hearing aids while
wearing them. Press and hold the volume down button for ap-
proximately 2 seconds until the status light turns off, to mute the
hearing aids.
Press “+” to
increase volume
(louder sound) Press “–” to
decrease volume
(softer sound)
Press for approximately
2 seconds
Other manuals for FittingLINK 3.0
7
Table of contents
Other oticon Hearing Aid manuals
oticon
oticon EduMic User manual
oticon
oticon BTE 312 User manual
oticon
oticon Dual User manual
oticon
oticon Oticon Opn 1 miniRITE-T User manual
oticon
oticon miniBTE User manual
oticon
oticon ponto streamer User manual
oticon
oticon ConnectLine Streamer Pro 1.3A User manual
oticon
oticon connectline microphone User manual
oticon
oticon miniRITE R User manual
oticon
oticon STREAMER PRO User manual
oticon
oticon More Series User manual
oticon
oticon CIC P User manual
oticon
oticon minirite User manual
oticon
oticon OPN User manual
oticon
oticon BTE SP User manual
oticon
oticon Agil BTE 13 User manual
oticon
oticon OPN User manual
oticon
oticon Corda miniFit Configuration guide
oticon
oticon ConnectLine Manual
oticon
oticon Opn 1 miniRITE User manual
