Omega REC-12 Quick start guide

Table Of Contents

•••••••••••••••••••••••••••••••••

•••••••••••••••••••••••••••••••••••••••••••••••

System Overview 3

Transmitter Functions Reference Guide 4

Using The Valet /Override Switch 8

The Status Light 10

Visual Confirmations

•

Audible Confirmations

Starter Disable -OPTIONAL 12

Programmable Features 13

Changing The Programmable Features 17

Full System Reset 18

Programming Transmitters 18

Ordering Replacement Transmitters 19

Installation Considerations 20

Mounting components 20

Wiring Connections

Main 5pin harness

Secondary 7pin harness 22

Door Lock Connections 23

Driver's Door Priority Connection 27

REC-12 Wiring Overview 29

Programmable Features List 30

Congratulations on your purchase

aREC-12 Deluxe Keyless Entry

system by Omega Research &Development, Inc., aleader

vehicle security

and convenience systems since 1970. The REC-12 is avery flexible system

that provides many programmable features, when customized, can enhance

change the system's operation. These programmable features, and the method

to customize them, are described in this booklet so the system can be config-

ured to suit your individual needs. First, this booklet describes the basic opera-

tions

the system as configured with the factory default settings. Please read

this entire manual to familiarize yourself with the system's capabilities.

The

system

components

used

control

and

monitor

this

system:

The

Transmitter:

Each system comes with 2pre-learned controllers,

which are actually radio transmitters. This system can be operated by up to

4different transmitters. Each transmitter is embedded with aunique security

code and can only operate one system at atime*. It has 4buttons: a"LOCK"

button, an "UNLOCK" button, a"TRUNK" button, and a "

•••

"button which

operates an additional output

can be configured to activate PANIC mode.

*NOTE: an

optional

transmitter

that

allows

the

operation

separate

REC-12

systems

available

special

order. Please

contact

your

dealer

visit

the

replacement

transmitter

section

www.caralarm.com

for

ordering

information.

System Overview (cont'd)

<~.

;~.

The Valet/Override Switch: This switch can be used to temporarily

turn "off' certain automatic locking, anti-carjacking, and optional starter interrupt

operations ofthe system, should they be programmed to operate, by plac-

ing the system into "Valet Mode". If the optional starter interrupt is installed,

the ValeUOverride Switch can also be used,

conjunction with the vehicle's

ignition

key,

to perform a"System Override", allowing you to start the engine,

should the transmitter not be available. The ValeUOverride Switch is also used

to program features and transmitters.

The Status Light: This light shows the status

the system at a

glance, and its presence offers avisual deterrent to break-ins and theft. The

Status Light's operation is described on pages 10-11.

Transmitter Functions Reference Guide ,:;'

LOCK: Press and release the "LOCK" button.

•THE HORN WILL HONK ONCE

•THE LIGHTS WILL FLASH ONCE

•THE DOORS WILL LOCK

•THE OPTIONAL STARTER INTERRUPT WILLARM

UNLOCK: Press and release the "UNLOCK" button.

•THE HORN WILL HONK TWICE

•THE LIGHTS WILL FLASH TWICE THEN TURN ON

•THE DOORS WILL UNLOCK*

•THE OPTIONAL STARTER INTERRUPT WILL

DISARM

•

THE SYSTEM

CONFIGURED FOR DRIVER'S PRIORITY, ONLY THE

DRIVER'S DOOR WILL UNLOCK. PRESS A2ND TIME TO UNLOCK THE

OTHER DOORS.

TRUNK RELEASE: Press and hold the "TRUNK" button for 3seconds.

•THE HORN WILL HONK TWICE

•THE TRUNK WILL OPEN (IF CONNECTED)

•THE LIGHTS WILL FLASH TWICE THEN TURN ON

•THE DOORS WILL UNLOCK

•THE OPTIONAL STARTER INTERRUPT WILL

DISARM

ACTIVATE 3RD CHANNEL: Press and hold the "

•••

"button for 3seconds.

•THERE IS NO VISUAL

AUDIBLE INDICATION

FROM THIS SYSTEM. IF CONNECTED TO

OPTIONAL ACCESSORY, THAT ACCESSORY MAY

PROVIDE VISUAL/AUDIBLE CONFIRMATION UPON

ACTIVATION.

•

Transmitter Functions Reference Guide (cont'a)

PANIC: Press and hold the "LOCK" or "UNLOCK" button for 3seconds.

•THE SYSTEM WILL ARM OR DISARM

•THE HORN WILL HONK CONTINUOUSLY

•THE LIGHTS WILL FLASH CONTINUOUSLY

-OR-

ACTIVATE 4TH CHANNEL: Press and release the "LOCK" &"UNLOCK"

buttons simultaneously. Consult your installer about this optional feature.

•THERE IS NO VISUAL OR AUDIBLE INDICATION

FROM THIS SYSTEM. IF CONNECTED TO AN

OPTIONALACCESSORY, THAT ACCESSORY MAY

PROVIDE VISUAL/AUDIBLE CONFIRMATION WHEN

ACTIVATED.

ACTIVATE 5TH CHANNEL: Press and release the "TRUNK" & "

•••

"buttons

simultaneously. Consult your installer about this optional feature.

•THERE IS NO VISUAL OR AUDIBLE INDICATION

FROM THIS SYSTEM.

CONNECTED TO AN

OPTIONALACCESSORY, THAT ACCESSORY MAY

PROVIDE VISUAL/AUDIBLE CONFIRMATION WHEN

ACTIVATED.

ACTIVATE REMOTE ANTI-CARJACK: While the ignition

ON, press and

hold the "

•••

"button for 3seconds.

See programmable feature #10 about enabling this feature

•THERE

NO VISUAL OR AUDIBLE INDICATION

FROM THIS SYSTEM.

CONNECTED TO AN

OPTIONALACCESSORY, THAT ACCESSORY MAY

PROVIDE VISUAL/AUDIBLE CONFIRMATION WHEN

ACTIVATED.

•

Using

The Valet IOverride

Switch

':\~"

The

Valet/Override

Switch

can be used to place the system into Valet

Mode, which is used to stop or interrupt any automatic system functions which

may be programmed to operate. The Valet/Override Switch,

conjunction

with your ignition

key,

also permits

System

Override, which allows starting the

vehicle ifthe optional starter interrupt is installed, and the transmitter becomes

lost or damaged.

Valet Mode:

You

may activate the Valet Mode at any time by press-

ing and holding the Valet/Override Switch for 3seconds, unless the doors have

been locked by the transmitter (in which case the Status Indicator will be flash-

ing slowly). When the system enters Valet Mode, the Status Light will illuminate

solid steady Red. Ifthe REC-12

installed with audible confirmation, the sys-

tem will chirp twice when it enters Valet Mode. Remember to check the Status

Light -if it is not lighted or flashing fast, the system may be placed into Valet

Mode. Ifthe Status Light is

steady, the system is already

Valet Mode. If

it's flashing slowly, aSystem Override must first be performed (see next page).

While the system is

the Valet Mode, the Status Light will remain solid

Red (not flashing) at all times. Ifthe audible confirmation is connected, every

time the ignition switch is turned "off", the system will chirp once as areminder

this condition. Also, the transmitter will operate normally while the system

•

Valet Mode, Le., it will still lock and unlock the doors, and the transmitter's

"TRUNK"

and"

•••

"Buttons will still operate -but the optional Starter Disable

will not operate, and any programmed automatic functions are suspended.

exit Valet Mode simply press and release the Valet Switch at any

time; the Status Light will change from being on solid steady Red to being off.

System Override: Ifthe last system operation was locking the doors

by the

tran~mitter,

aSystem Override is required before then placing the

system into Valet Mode, or starting the engine if the optional Starter Disable is

installed.

obtain aSystem Override:

Step 1Enter the vehicle normally.

Step 2Using your

key,

turn the ignition "ON".

Step 3Within 5seconds, press and release the Valet Switch once. The Status

Light will turn off.

o•

The Status Light

~-:7:~'

The REC-12 includes aStatus Light to inform you

the system's op-

erational condition. If your system includes aStarter Disable circuit, it's condi-

tion is also reflected

this light's operation, along with any automatic features

which may have been programmed to operate.

Light Off-Ignition switch is "on"

the system is "at rest", or standby, await-

ing atransmitter command, and is also indicating that no automatic functions

are occurring or will occur.

Light On Solid Red -The system is

"Valet Mode".

Light Flashing Rapidly -An automatic function, such as automatic locking or

automatic starter disable, is in progress.

Light Flashing Slowly -This slow flashing will occurwhenever the transmitter

has been used to lock the doors, and also that the Starter Disable (if installed)

is engaged.

Light Flashes 1to 4Times after Ignition

"On"

-This is the number

oper-

ating transmitters stored

the system's memory. These indicators are part

the Automatic Transmitter Verification operation. This indicator will flash for 10

seconds after the vehicle's ignition is turned ON.

Other manuals for REC-12

Table of contents

Other Omega Car Alarm manuals

Omega

Omega Crime Guard 350i5 User manual

Omega

Omega Excalibur AL-1000SH User manual

Omega

Omega K9-Mundial Instruction Manual

Omega

Omega K9-150 Instruction Manual

Omega

Omega K9-Classic-E User manual

Omega

Omega Crime Guard 750i5 User manual

Omega

Omega Excalibur AL-1920-EDP User manual

Omega

Omega Crime Guard 850i4 User manual

Omega

Omega Excalibur AL-1810-EDP User manual

Omega

Omega Excalibur AL-1610-EDP User manual

Omega

Omega ClassicOne User manual

Omega

Omega AL-100-H User manual

Omega

Omega Freedom 400 User manual

Omega

Omega ECHO TOUCH Quick start guide

Omega

Omega Excalibur AL-1510-EDP User manual

Omega

Omega Excalibur Gold Series-1200atv User manual

Omega

Omega Freedom 500 User manual

Omega

Omega OL-BLADE-AL-CH6 User manual

Omega

Omega Excalibur AL-1500-EDP User manual

Omega

Omega Excalibur AL-1000ATV2 User manual

Omega

Omega Crime Guard 810i6 User manual

Omega

Omega RS-310-EDP User manual

Omega

Omega C-4SRS User manual

Omega

Omega Excalibur AL-1000-E User manual

Popular Car Alarm manuals by other brands

Clifford

Clifford 3606X owner's guide

Ultra Start

Ultra Start 2500M SERIES install guide

Ultra Start

Ultra Start 650 Series owner's manual

Audiovox

Audiovox Prestige Platinum+ APS-511C owner's manual

Sparkrite

Sparkrite SRA8 Guide

Viper

Viper 4708V owner's manual

Federal Signal Corporation

Federal Signal Corporation Pathfinder Siren Series Installation and maintenance manual

Falcon

Falcon Predator XL3 Installer manual

Audiovox

Audiovox Auto Security XR91 Programming guide

Clifford

Clifford Sabre II owner's manual

CrimeStopper

CrimeStopper CS-8717 Wiring diagram

Ultra Start

Ultra Start 450 SERIES install guide

Scytek electronic

Scytek electronic Vectra X3 product manual

Excalibur

Excalibur AL-1860-EDPB Operation guide

Clifford

Clifford CYBER 2 owner's manual

Gemini

Gemini 7057 user manual

FlashLogic

FlashLogic FLRSBA PRESTIGE Product guide

Magicar

Magicar FAI-440 manual