Nauticam TTL Flash Trigger User manual

Current as of 2016-05-11

26321

TTL Flash Trigger for Canon

Instruction Manual

OREWORD

Thank you for your purchase of a NAUTICAM product.

At NAUTICAM, we pride ourselves in the ability to recogni e the requirements

of professional as well as amateur underwater photographers and fulfill them

through the innovative designs of our products. We strive to achieve a high

level of user-friendliness by allowing stress-free installation and easy

operation of all important functions of the camera.

Please read this manual carefully before using the product, this will maximi e

its performance as well as its lifetime.

ARRANTY

All NAUTICAM Products are warranted against any material and

manufacturing defects for two years from the date of purchase for consumer

use.

This warranty only applies to products purchased from authori ed

NAUTICAM dealers and does not extend beyond the original retail purchaser.

To return your product for service, please contact your regional authori ed

service center(s). Please note that this warranty only applies when the product

is purchased in the territory where the service center is located.

NAUTICAM does not hold responsibility for damage, of any nature, to any

equipment used with and/or placed within our products.

NAUTICAM accepts no liability for any loss of captured images or the inability

to capture images even if it is due to the malfunctioning of our products.

Unauthori ed modifications and/or repairs of our products will automatically

invalidate the warranty.

RECAUTION

•Use only batteries approved for use in this product, do not mix old and new

batteries.

•Check the battery terminals before installing into the product.

•Remove batteries for storage, do not store the product in an environment

of high humidity.

•Do not leave the product in direct sunlight for prolonged periods.

•Keep out of reach of children, failure to do so could result in injury.

•Defective products should be shipped to our distributors for service,

unauthori ed disassembling and/or modifications could result in mal-

function.

DENTIFICATION OF

ART

ATTERIE

N TALLATION

Press and slide the battery compartment cover and open it as shown by the

arrows.

Install the battery. Make sure the +ve and –ve terminals are correctly oriented.

Then return the cover to its original position.

ONNECT TO THE

AMERA

CAUTION: Be sure to turn off the flash trigger before attaching or etaching.

Slip the flash trigger’s hotshoe connector into the camera’s hotshoe until it

cannot goes any further.

To remove the flash trigger, press and hold the release button and slide it out

from the camera.

--- continue on next page ---

On/off

button and power lamp

Release button

Battery

compartment cover

Locking pin

Flash head

Indicator

Press

and hold

Slide

Hotshoe

connector

Press

Current as of 2016-05-11

--- continued from front page ---

LA H

RIGGER

ETUP

Turning ON the Flash Trigger:

Press and hole the on/off button for at least 1 second to turn on the flash. The

power lamp turns on and flash recycling starts. Check that the indicator is lit,

when the indicator lights, you can shoot with the flash.

etting the Flash Functions by Camera Operation:

When the flash trigger is attached to an EOS DIGITAL camera with an external

flash control function, the following settings are available through camera

menu operations. See camera’s instruction manual for the setting method and

functions.

•Flash firing (Enable/ Disable)

•Flash function settings

-Flash mode (E-TTL II / Manual Flash)

-Shutter sync. (1

curtain/ 2

curtain)

-Flash exp. Comp

-E-TTL II (Evaluative / Average)

•Flash C.Fn settings

-Auto power off (Enabled/ Disabled)

CAUTION: The following settings are required to set

prior to close the housing and go underwater. Failure to

do so will result in not triggering the external strobes.

1. Disable the auto power off function for external speedlite

Go to “External Speedlite Control” under “SHOOT” menu, and scroll down to

“Flash C.Fn settings”.

Select “Disabled” for Auto power off setting.

2. Disable the auto power off function of camera

Go to “SET UP” menu and set “Auto power off” to “Disable”.

3. Install to the housing

With flash trigger attached, install the camera into the housing the same way

as described in the housing’s instruction manual. Make sure the flash trigger

is turned ON before closing the housing or going underwater.

TIP: To save the battery life of the flash trigger, turn on 30mins before ive.

4. Underwater Operation

Do not turn off the camera at any time during the dive, this will result in

turning off the flash trigger and will not be able to turn back on without

opening the housing.

Attention:

1. Disable auto power off function for

external speedlite.

2. Disable auto power off function of

camera.

3. Turn ON the flash trigger before

going underwater.

4. Do NOT turn off the camera during

dive.

PERATION

The TTL function of this flash trigger will be work in “P” Program AE, “Tv”

Shutter Priority AE, “Av” Aperture Priority AE and “M” Manual Exposure

camera modes.

PECIFICATION

Construction:

Body: PC+ABS

Dimensions:

Approx.

Weight:

Approx

g (w/ batteries installed)

Battery:

Canon NB

13L

x1pc

Operation:

TTL or Manual

Flash Capacity

Approx.

times

Compatible housings:

1DXII, 1DX, 5DSR, 5DMKIII, 6D, 7DMKII,

80D, 70D

Compatible strobes:

INON: Z240 type 4, D2000 type 4, S2000

Sea&Sea: YS-D2, YS-D1, YS-01

Press

Other Nauticam Camera Accessories manuals

Nauticam

Nauticam NA-TG6 User manual

Nauticam

Nauticam NA-Z7V User manual

Nauticam

Nauticam NA - R5C User manual

Nauticam

Nauticam NA - XT5 User manual

Nauticam

Nauticam 36072 User manual

Nauticam

Nauticam NA-5dsr User manual

Nauticam

Nauticam NA-NEX5R User manual

Nauticam

Nauticam 70 User manual

Nauticam

Nauticam NA-Z50 User manual

Nauticam

Nauticam PL1635-Z User manual

Nauticam

Nauticam C65-F User manual

Nauticam

Nauticam C100IS-F User manual

Nauticam

Nauticam 21120 User manual

Nauticam

Nauticam NA-EM1X User manual

Nauticam

Nauticam 21271 User manual

Nauticam

Nauticam 83222 User manual

Nauticam

Nauticam PS24105-Z User manual

Nauticam

Nauticam NA-GH2 User manual

Nauticam

Nauticam N120 User manual

Nauticam

Nauticam NA-XZ1 User manual

Nauticam

Nauticam O1250-Z User manual

Nauticam

Nauticam NA-A6700 User manual

Nauticam

Nauticam NA-EM10IV User manual

Nauticam

Nauticam P1442X-PZ User manual

Popular Camera Accessories manuals by other brands

Viltrox

Viltrox EF-NEX Mount instructions

Calumet

Calumet 7100 Series CK7114 operating instructions

Ropox

Ropox 4Single Series User manual and installation instructions

Cambo

Cambo Wide DS Digital Series Main operating instructions

Samsung

Samsung SHG-120 Specification sheet

Ryobi

Ryobi BPL-1820 Owner's operating manual

Aegis

Aegis ABL-36020P user manual

Pentax

Pentax Data Back Fc operating manual

Fantasea

Fantasea EyeGrabber F Series instruction manual

Honeywell

Honeywell HDZ20HD user manual

EGO

EGO BA1400T Operator's manual

Sima

Sima SRW-62 user guide

Shape

Shape A7SSMKIT Assembly manual

Slide Kamera

Slide Kamera HST-2 user manual

Power works

Power works 2902613 Original instructions

SES

SES SE-2047-2 user manual

Olympus

Olympus PT-EP05L instruction manual

Starlite

Starlite OctoDome nxt instructions