Maytag Neptune Series Installation guide

Maytag Neptune

27” Dryer

© Maytag Technical Training Services 2005 L2005-006

1

Slide 1

Maytag Neptune 27” Dryers

Premium – MAH9700 - Gas and Electric

Slope Front Console – Matches the 9700 and 8700 washers

Entry Level– MAH6700 - Gas and Electric

Flat Front Console- Stackable

Slide 2

Maytag Neptune 27” Dryer

2

Slide 3

Maytag Neptune Dryers MDE&MDG 9700

Features Features

Capacity (cu.ft) 7.3 Tumbler Stainless

Controls LED Drum Light 10 Watt 120VAC

Dryness Control Sensor Bars Drying Rack

Reversible Door with 15” glass

Degree of Dryness Selections 4 Point Suspension 4 rollers, 2 front , 2 rear

Damp Dry Adjustable Chime High, Low, Off

Less Dry Bower 180CFM

Normal Dry Venting Back, Sides, Bottom

More Dry Duct length 80 FT Maximum

Very Dry Color White

Very Dry

Dimensions

Temperature Selection Dryer Width 27”

Extra Low Dryer Depth 30.375”

Low Dryer Height 38”

Medium Weight 138 LBS.

Regular

Pedestal Riser 13” High

Base Cycle Selection (MAL 1800 AX*)

Regular

Wrinkle Control

Time Dry 0 - 99 Minutes MDE9700

Freshen Up Heating Element 5150 Watts

Delicates

Air Fluff

Wrinkle Release MDG9700 Electronic Ignition/ Safety Shutoff

Quick Dry Valve/Burner 22,000 BTU

Wrinkle Prevent

1

Slide 4 - Installation

Slide 5

The installation of the 27” gas and electric dryer is no different than current product.

Follow the Installation instructions shipped with the dryer and observe all codes.

Slide 6

Slide 7

Remove the screw securing

the electrical cover. Follow the

instructions included with the

dryer for installation of either a

3 or 4 wire power cord

2

Slide 8

Level the dryer front to back and side to side.

Failure to do so will cause excessive vibration. Don’t

drag the dryer across rough surfaces with leveling

legs extended. Damage to the legs could occur

Slide 9

Observe Vent Installation Warnings

Slide 10

Follow the information in the use and care manual and the warning labels on the dryer

concerning proper use of the dryer

3

Slide 11 - Door Reversal

Slide 12

Remove four

screws and

door strike

Remove two

screws securing

door hinge

Slide 13

Install the door

hinge on the

opposite side Install the door

strike and two

fill screws

4

Slide 14 - Door Service

Slide 15

Remove screws

around the perimeter

of inner panel

The gasket can be

changed at this point

The door

glass lifts out

Remove

inner panel

Slide 16

To remove the outer door

shield, release the locking

tabs as you force the shield

out of the door panel

Note: There was a change to the door @ series 11. The diameter of the door glass is 7mm

larger than series 10

This manual suits for next models

4

Table of contents

Other Maytag Dryer manuals

Popular Dryer manuals by other brands

Bosch

Bosch WTA79200GB Installation and operating instructions

Amana

Amana W10233410A Use and care guide

Miele

Miele TWH 780 WP operating instructions

Asko

Asko T760 user guide

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Original instructions

Bosch

Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Operation and installation

Electrolux

Electrolux EW2H328R2 user manual

Beko

Beko DS8433RX1M user manual

Dawlance

Dawlance Spinner DS 6000 C owner's manual

Electrolux

Electrolux TP5080TW user manual

AEG

AEG TR838P4OB user manual

Indesit

Indesit IDV 75 instruction manual

Infiniton

Infiniton SD-DG85C manual

BOMANN

BOMANN WT 5019 instruction manual

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Installation

Asko

Asko T793C operating instructions

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer installation instructions