Infinity INTERMEZZO 2.6 User manual

INTERMEZZO 2.6

POWERED LOUDSPEAKER

SERVICE MANUAL

Infinity Systems, Inc

250 Crossways Park Dr.

Woodbury, New York 797REV5 7/2004

CONTENTS

SPECIFICATIONS …….……………………………………………….3

DETAILED SPECIFICATIONS …………………….…………………4

CONTROLS and CONNECTIONS …………………….….…………6

OPERATION/SYSTEM AURAL SWEEP TEST………..…….……..8

SERVICE BULLETIN INF2000-05 ………….………………….…….9

SERVICE BULLETIN INF2002-04 ….………………….…………...10

TECH TIP INF2003-03………………………………………..………11

MECHANICAL/PACKAGING PARTS LIST…………………………12

EXPLODED VIEW ……………………………………….……………13

PACKAGING …………………………….………………………….…14

WIRING DIAGRAM/HI-PASS CROSSOVER SCHEMATIC…..….15

AMPLIFIER BLOCK DIAGRAM……..…………………….…………16

IM 2.6 ADJUST BIAS PROCEDURE…………….………….………17

ELECTRICAL PARTS LIST (120v)…………………….….…………18

ELECTRICAL PARTS LIST (230v)…………………….….…………26

INTEGRATED CIRCUIT DIAGRAMS ………………………………34

PRINTED CIRCUIT BOARD DIAGRAMS………………..…………35

SCHEMATICS …………………………………………………………39

Intermezzo 2.6

Specifications

Intermezzo 2.6

Detailed Specifications

Intermezzo 2.6

Detailed Specifications (Cont.)

Intermezzo 2.6

SYSTEM AURAL SWEEP TEST

Equipment needed:

lFunction/signal generator/sweep generator

lIntegrated Amplifier

lMultimeter

lSpeaker cables

General Sweep Function (UUT = Unit Under Test)

1. Turn the RABOS level control on the front of the UUT to “0”. Depress both “High-Pass Filter”

and “Placement” buttons on the rear faceplate.

2. Connect one pair of speaker cables to the input terminals on UUT. Cables should be connected

to an integrated amplifier fed by the signal generator.

3. Turn on signal generator and adjust so that speaker level output at the amplifier is 7.0V, 50 Hz.

4. Plug in and turn on UUT with the power switch; LED on the Level control should light – Red ini-

tially and Green after step #5 is followed.

5. Turn up the RABOS level control on the front of the UUT to “10”. (Maximum). Woofer should be

driving close to maximum excursion at this point.

Driver Function

1. Remove driver from cabinet; (See Page 10), detach + and - wire clips.

2. Check DC resistance of woofer; it should be 3.4 ohms ±10%.

3. Connect a pair of speaker cables to driver terminals. Cables should be connected to an

integrated amplifier fed by a signal generator. Turn on generator and adjust so that speaker level

output is 5.0V.

4. Sweep generator from 20Hz to 1kHz. Listen to driver for any rubbing, buzzing, or other unusual

noises.

The operation of the Intermezzo 2.6 loudspeaker system,and the proper settings for the Room

Adaptive Bass Opitmization System, or R.A.B.O.S., is thoroughly covered in the Owner’s guide, part

#335714-001.

For service purposes, the R.A.B.O.S. system is canceled when all three front panel controls (F) (L)

(W) are turned fully CW, and the Shelf/Stand Placement Selector switch should be set to the

“STAND” position.

The only other control of concern is the Main Level Control on the front panel, which operates like a

traditional potentiometer.

Operation

Left Right

Intermezzo 2.6

Service Bulletin

Service Bulletin INF2002-04 - February 2002 Warranty labor rate: MINOR repair

To: All Infinity Service Centers

Model: Intermezzo 2.6

Subject: No Output

In the event you receive an Intermezzo 2.6 loudspeaker with the complaint: “There is no output, and

the LED on the volume control does not light, red or green”, check the items listed below:

Check the 3A line fuse to make sure it’s not open. If open, replace with a 3A MDL (.25 x 1.25) slo-blo fuse,

Infinity part# 80126.

Locate R22 in the power supply section, as shown below.

If value of R22 is not 100k ohms ±5%, then replace R22 with a 1/2 Watt 100k ohm ±5%, resistor.

1) Remove the grille and side panel.

2) Extract (7) of the rubber grille retainers shown in the illustration; this can be accomplished by carefully pulling

them out of their cavities with long-nosed pliers or similar tool.

3) Remove the (7) Phillips screws that are now exposed.

4) Carefully lift the front baffle, with drivers, network, and RABOS controls attached, off the cabinet.

5) Remove the (8) Phillips screws at the rear of the enclosure, and push the amplifier assembly out the front.

6) Locate the power supply section and R22 from the illustrations below. Remove the black plastic guard from

the area of concern (loosen (2) Phillips screws). R22 can be checked in-circuit and should be:

100k ohms ±5%. If it is any other value, or open, replace with Infinity part# RC0082.

7) Replace the guard, the amplifier, reassemble and and test the loudspeaker.

Intermezzo 2.6

Other manuals for INTERMEZZO 2.6

Table of contents

Other Infinity Speakers manuals

Infinity

Infinity CLASSIA C255ES User manual

Infinity

Infinity kappa series 42.7i Manual

Infinity

Infinity ERS110 Assembly instructions

Infinity

Infinity PRIMUS P142 User manual

Infinity

Infinity CS 60 User manual

Infinity

Infinity ERS 110 User manual

Infinity

Infinity Primus 250 User manual

Infinity

Infinity ERS 110 User manual

Infinity

Infinity Interlude Series User manual

Infinity

Infinity 10.1t Tweeter Kappa Series User manual

Infinity

Infinity Total Solutions TSS-1200 User manual

Infinity

Infinity DPF-8000 User manual

Infinity

Infinity Kappa 10.5t User manual

Infinity

Infinity 1031t Service manual

Infinity

Infinity PHI 21 User manual

Infinity

Infinity Total Solutions TSS-SAT4000 User manual

Infinity

Infinity Minuette L-MPS User manual

Infinity

Infinity Total Solutions TSS-Center1100 User manual

Infinity

Infinity CS 60R User manual

Infinity

Infinity TSS-Sub1200 User manual

Infinity

Infinity SAT-750 User manual

Infinity

Infinity INTERLUDE IL10 User manual

Infinity

Infinity MARINE 612m User manual

Infinity

Infinity INTERLUDE IL40 User manual

Popular Speakers manuals by other brands

argon audio

argon audio IE20 quick start

Denon

Denon SC-N7 owner's manual

Gemline

Gemline Ace 3952 user manual

Focal

Focal ON WALL 300 User manua

HEADRUSH

HEADRUSH Maximus HRSP 5024 manual

SoundLogic

SoundLogic BCCS-6/6395 instruction manual

Peavey

Peavey DTH 218 Specification sheet

Avantree

Avantree Pluto Air user guide

Morel

Morel Integra Series INTEGRA OVATION 4 install guide

Oppo

Oppo SONICA quick start guide

Bose

Bose SoundLink Wireless Music System owner's guide

Rocksteady

Rocksteady Stadium owner's manual

Bowers & Wilkins

Bowers & Wilkins 4 owner's manual

Sonance

Sonance SONOS OUTDOOR Series installation manual

Electro-Voice

Electro-Voice EVID FM4.2 Brochure & specs

Pioneer

Pioneer XW-HTD630 manual

Onn

Onn BWA16AA002 Product guide

HP GL313AA - USB Speakers PC Multimedia quick start guide