HP Cluster Platform Hardware Kits v2010 Assembly Instructions

1

Rail Mounting Kit Installation Instructions

for the ProCurve Series zl Switches

The zl switches can be mounted with the optional Rail Mounting Kit (5070-0145) for shipment in an

HP 10000 series rack. These rails stabilize the switch, so the rack or cabinet can be shipped without

removing the switch. However, the power supplies must be removed from the chassis before shipping.

Note

The power supplies must be removed from the chassis before shipping in a rack.

Even though the illustrations show a Switch 5406zl, the instructions apply to all zl chassis models.

1. Use a posi-drive screwdriver, two included 8-mm M6 screws, and two included M6 cage nuts to

attach each rail to the rack or cabinet as shown in the following illustration. Ensure that the

screws are at the same level in each upright.

Devices installed in a rack or cabinet should be mounted as low as possible, with the heaviest

device at the bottom and progressively lighter devices installed above.

Figure 1. Attaching Rails to a Rack

8 mm

M6 screw

2

2. Use a #1 Phillips (cross-head) screwdriver and two included 8-mm M4 flat head screws to attach

a hold-down bracket to the chassis as shown in the following illustration. Ensure that each hold-

down bracket is positioned at the lower rear corners of the chassis.

Figure 2. Attaching Hold-Down Bracket

8 mm

M4 screws

Hold down

bracket

3

3. Use a #1 Phillips (cross-head) screwdriver to attach the mounting brackets to the switch with

the included 8-mm M4 screws. Each bracket is attached with four screws as shown in figure 3.

Figure 3. Attaching Rack Mounting Brackets

4. Slide the switch onto the rails in the rack until the mounting brackets are flush with the front

of the cabinet.

Figure 4. Notches in Bracket Being Installed

8 mm

M4 screws

Mounting

bracket

4

5. Install the four number 12-24 screws (included in the mounting bracket kit) into the upper and

lower holes in each bracket. Tighten these screws.

Figure 5. Installing screws in brackets

install and tighten the

other 12-24 screws

© Copyright 2006, 2007 Hewlett-Packard

Development Company, LP. All rights reserved.

The information contained herein is subject to

change without notice.

This document contains proprietary information,

which is protected by copyright. No part of this

document may be photocopied, reproduced, or

translated into another language without the

prior written consent of Hewlett-Packard.

Technical information in this document is

subject to change without notice.

Part Number: 5991-8559

August 2007

Printed in Singapore

*5991-8559*

Other manuals for Cluster Platform Hardware Kits v2010

8

This manual suits for next models

1

Table of contents

Other HP Server manuals

HP

HP t5335 - Thin Client Operating and maintenance manual

HP

HP vc4820T - Thin Client User manual

HP

HP Integrity Superdome 2 16-socket User manual

HP

HP D7171A - NetServer - LPr User manual

HP

HP E30 User manual

HP

HP Disk Carrier Blade for bh3710 User manual

HP

HP E8400A C-Size VXI Mainframe Troubleshooting guide

HP

HP ProLiant BL620c Generation 7 User instructions

HP

HP ProLiant Plus User manual

HP

HP t310 Installation instructions

HP

HP D7171A - NetServer - LPr User manual

HP

HP Cluster Platform Hardware Kits v2010 User manual

HP

HP Integrity rx2600 User manual

HP

HP 9000 rp4440 Installation and operation manual

HP

HP ML570 - ProLiant - G2 Operating and safety instructions

HP

HP ProLiant DL120 Gen9 Manual

HP

HP 9000 rp3410 User manual

HP

HP T5125 - Compaq Thin Client Specification sheet

HP

HP LaserJet 9000 User guide

HP

HP ConvergedSystem 300 User manual

HP

HP ProLiant DL380 - G2 Server User manual

HP

HP Integrity rx5670 Manual

HP

HP ProLiant ML350 Gen9 Manual

HP

HP Integrity rx4610 User manual

Popular Server manuals by other brands

Dell

Dell PowerEdge R410 Getting started

PowerNAS

PowerNAS CMA quick start guide

Supero

Supero FatTwin F617R3-FT user manual

MSI

MSI P1-109N-L70 user manual

Dell

Dell PowerEdge XE9640 Installation and service manual

Dell

Dell PS4100 Hardware

EtroVISION

EtroVISION EV3151 user manual

NEC

NEC Express5800/T110j System configuration guide

Compaq

Compaq ProLiant 3000 Maintenance and service guide

Dell

Dell PowerEdge 3YPMN Getting started guide

iRobo

iRobo IPC2U user manual

Nortel

Nortel 1000 Con?guration guide user manual

Asus

Asus AP7500 Hardware reference guide

Avid Technology

Avid Technology AirSpeed 5000 manual

Milestone

Milestone Husky IVO 350T Getting started

Planet

Planet NAS-7410 user manual

Lenovo

Lenovo ThinkSystem SR635 V3 user guide

Dell

Dell PowerEdge HS5610 Installation and service manual