Hotpoint HTDX100GM User manual

HTDX100GM – Hotpoint®6.0 cu. ft. capacity DuraDrum™gas dryer

Dryer Dimensions (in inches)

42-3/4

Side View

Rear View

36 42

25-1/2

2-1/2

25-1/2*

Side View Rear View

4-3/4

25-3/4

23-1/2

11-3/4

HTPWasher/Dryess LC QSart

*24-1/2” from the edge of the side panel to the front.

25-1/2” from front to edge of end caps.

Specification Created 7/10

470158

Exhaust Options:

3-way via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting

knockouts are supplied.

Circuit Requirements:

An individual properly-grounded branch circuit, with a three-prong grounding-type receptacle,

protected by a 15- or 20-amp circuit breaker or a time-delay fuse is required.

Gas Dryer Electric Rating:

120V, 60Hz, 6 Amp

Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply

requires an optional conversion kit. Check installation instructions for correct kit and have a

qualified gas technician install a conversion kit. See dryer ducting information for proper

installation.

Installation Information: For complete information, see installation

instructions packed with product for current dimensional data.

Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a

label on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0" either side

3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

• Closet doors must be louvered or otherwise ventilated and must contain a minimum of

60 sq. in. of open area equally distributed. If this closet contains both a washer and a

dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes,

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces

0" both sides

3" rear

HTDX100GM – Hotpoint®6.0 cu. ft. capacity DuraDrum™gas dryer

Dryer Exhausting Information – Use Metal Duct Only

Vertical and Horizontal Ducting

0 90 ft. 60 ft.

1 60 ft. 45 ft.

6.0 and 5.8 cu. ft. 2 45 ft. 35 ft.

Capacity Models 3 35 ft. 25 ft.

all Electric Dryers 4 25 ft. 15 ft.

0 90 ft. 60 ft.

6.0 and 5.8 cu. ft. 1 60 ft. 45 ft.

Capacity Models 2 45 ft. 35 ft.

all Gas Dryers 3 30 ft. 25 ft.

Portable/StationaryModels

DSKS433EB 0 46 ft. 37 ft.

DSKS333EC 1 38 ft. 30 ft.

DSKP333EC 2 31 ft. 22 ft.

WSM2780H 3 24 ft. 15 ft.

0 56 ft. 42 ft.

1 46 ft. 36 ft.

Unitized Model 2 34 ft. 28 ft.

WSM2700H 3 32 ft. 18 ft.

Unitized Models 0 43 ft. 36 ft.

WSM2420D 1 33 ft. 26 ft.

WSM2480D 2 23 ft. 16 ft.

Number

90°

Turns

Maximum Length of

4"-Dia.Rigid MetalDuct

Exhaust Hood Type

Domestic

Dryer Models

4" Opening

2-1/2"

Opening

Best Performance

2-1/2

For complete information, see installation instructions packed with your dryer.

Ducting Materials:

For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct.

If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used

(Kit WX08X10077). In special installations, it may be necessary to connect the dryer to the

house vent using a flexible metal (foil-type) duct. A UL-listed flexible metal (foil-type) duct may

be used ONLY in installations where rigid metal or flexible metal (semi-rigid) ducting cannot be

used AND where a 4” diameter can be maintained throughout the entire length of the transition

duct. Please see installation instruction packed with your dryer for complete instructions when

using flexible metal (foil type) ducting.

Exhaust Length Calculation:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or

bottom of dryer, add one turn.

2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is

shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated

as a 90° elbow. A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed

house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or

moisture could cause damage. Never terminate the exhaust into a common duct or plenum with

a kitchen exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting,

etc. The wall cap must also be located at least 12" above the ground or any other obstruction

with the opening pointed down.

Specification Created 7/10

470158

HTDX100GM – Hotpoint®6.0 cu. ft. capacity DuraDrum™gas dryer

Features and Benefits

• Auto Dry - Monitors air temperature with an automatic thermostat and ends the cycle

when clothes are properly dried

• Rotary electromechanical controls - Easy-to-use controls make it simple to set cycles

• 3 heat selections - Provide the right temperatures for your clothes-drying needs

• Reverse-a-Door - Door opening can be reversed to meet laundry room needs

• Upfront lint filter - With placement of the lint filter in the front of the dryer, air flow

is optimized through the drum, and access to the filter simplifies cleaning

• Cottons cycle - Heat and time are pre-set to take great care of cotton fabrics

• Up to 90 ft. venting capability - Has long equivalent ducting performance for more

flexible installation

• Model HTDX100GWW – White on white

NVLR223E-G

Start

Push to Start

Cottons

Automatic

Medium Heat

80 Min

Optimum Dry

OFF

Time Dry

Specification Created 7/10

470158

This manual suits for next models

Table of contents

Other Hotpoint Dryer manuals

Hotpoint

Hotpoint TVM570 User manual

Hotpoint

Hotpoint TCEL 87B Experience User manual

Hotpoint

Hotpoint AQUALTIS AQC9 4F7 User manual

Hotpoint

Hotpoint TVF ET 7B User manual

Hotpoint

Hotpoint TCFG 87 Futura User manual

Hotpoint

Hotpoint TVFG 85C Futura User manual

Hotpoint

Hotpoint Aquarius TDC30 Instruction Manual

Hotpoint

Hotpoint TDWSF83BEPUK User manual

Hotpoint

Hotpoint TVFS 83 User manual

Hotpoint

Hotpoint Aquarius VTD20 User manual

Hotpoint

Hotpoint NBXR333GG User instructions

Hotpoint

Hotpoint TFA34 Instruction Manual

Hotpoint

Hotpoint NBXR453EVAA User manual

Hotpoint

Hotpoint DLB3900S User manual

Hotpoint

Hotpoint TVEL User manual

Hotpoint

Hotpoint TVFM 60C Futura User manual

Hotpoint

Hotpoint DLL3880S Installation instructions

Hotpoint

Hotpoint TVFS 73 User manual

Hotpoint

Hotpoint CTD80 User manual

Hotpoint

Hotpoint TCYL 757C User manual

Hotpoint

Hotpoint NWXR473 User manual

Hotpoint

Hotpoint TVAL 73 User manual

Hotpoint

Hotpoint NJSR453EWWW Service manual

Hotpoint

Hotpoint V4D 01 P User manual

Popular Dryer manuals by other brands

Bosch

Bosch WTA79200GB Installation and operating instructions

Amana

Amana W10233410A Use and care guide

Miele

Miele TWH 780 WP operating instructions

Asko

Asko T760 user guide

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Original instructions

Bosch

Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Operation and installation

Electrolux

Electrolux EW2H328R2 user manual

Beko

Beko DS8433RX1M user manual

Dawlance

Dawlance Spinner DS 6000 C owner's manual

Electrolux

Electrolux TP5080TW user manual

AEG

AEG TR838P4OB user manual

Indesit

Indesit IDV 75 instruction manual

Infiniton

Infiniton SD-DG85C manual

BOMANN

BOMANN WT 5019 instruction manual

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Installation

Asko

Asko T793C operating instructions

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer installation instructions