5
APPENDIX A CC INSTALLER SETUP
1. Charge batteries:
Before using the COM900CC COMMUNICATOR®, place the batteries in the AC900
Battery Charger and let them charge until the green, Ready lights go on (approximately
2 hours and 20 minutes).
2. Reset the COM900CC:
With a fully charged battery in the Communicator, reset the unit to system configuration
default settings as follows.
!With the Communicator off, press and hold A + B + C buttons, then press ON.
!Release.
!Press C twice within 5 seconds.
You will hear “Reset” in the headset, then “Power On, Lane X.”
3. Set channel frequency:
Set the Communicator frequency as follows, to be certain it is the same as the audio sys-
tem base station frequency.
!With the Communicator off, press and hold A + C buttons while pressing ON.
!Release.
You will hear “Channel X” in the headset, telling you the frequency of the Communicator.
Refer to the tables on the following page. To change the frequency, press the volume
control up ▲or down ▼until you reach the desired frequency. Press the A button to
save the channel and exit. You will hear “Channel X saved, power on, lane X.”
4. Check system status:
!Press the ON button to turn the Communicator power on. With the Communicator
on, press and hold the ON button again, while you press and hold the A button for
2 seconds.
!Release the ON and A buttons after the status report begins.
You will hear the following system status information in the headset:
“Single lane” or “Dual lane,” “Lane one” or “Lane two” for dual lane configurations,
“Channel X” for the Communicator frequency (refer to Frequency Selection Table on next
page), “Handsfree on” or “Handsfree off,” “VOX on” or “VOX off,” “On channel” or “Off
channel” or “Low channel,” “PLL on” or “PLL off,” and the firmware version.
5. Single/Dual-lane operation:
!To set the Communicator for single-lane operation; with the Communicator off, press and
hold the A button while pressing ON. You will hear “Single lane” then “Power on, lane X.”
!To set the Communicator for dual-lane operation; with the Communicator off, press and
hold the C button while pressing ON. You will hear “Dual lane” then “Power on, lane X.”
6. Power off:
To turn the Communicator power off, press and hold the OFF button for several seconds.
You will hear “Power off” in the headset earpiece just before the power goes off.
