GE GTDS560GF User manual

For answers to your Monogram,® Cafe™Series,

Profile™Series or GE®appliance questions, visit

our website at geappliances.com or call

GE Answer Center®service, 800.626.2000.

GTDS560GF

GE®7.0 cu. ft. stainless steel capacity gas dryer with Steam & HE Sensor Dry

Exhaust Option: When viewed from the front

of the unit, exhaust 3-way via rear, left and

bottom. Dryer is shipped exhausted to the

rear. Alternate exhausting knockouts are

supplied.

Gas: An individual, properly-grounded

branch circuit, with a three-prong grounding-

type receptacle, protected by a 15 or 20

amp circuit breaker or a time-delay fuse is

required.

Gas Dryer Electric Rating: 120V, 60Hz, 6A

Gas (BTU/HR): 22,000. Factory-equipped for

natural gas. Tested for LP gas. LP gas supply

requires a conversion kit. Check installation

instructions for correct kit and have a

qualified gas technician install a conversion

kit. See dryer ducting information for proper

installation.

Note: Dryer wall outlet must be located within

36" of service cord entry and accessible when

dryer is mounted in position.

Installation Information: For complete

information, see installation instructions

packed with your dryer.

Dimensions and Installation Information (in inches) Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label

on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.

• Closet doors must be louvered or otherwise ventilated and must contain a minimum

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes,

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces are: 0" both sides; 3" rear

Dryer Exhausting Information: Use metal duct only, vertical and horizontal ducting.

Specification Revised 4/15

For answers to your Monogram,® Cafe™Series,

Profile™Series or GE®appliance questions, visit

our website at geappliances.com or call

GE Answer Center®service, 800.626.2000.

GTDS560GF

GE®7.0 cu. ft. stainless steel capacity gas dryer with Steam & HE Sensor Dry

25-1/2

Side View

Rear View

36 42

23-1/2

2-1/2

25-1/2*

Side View Rear View

8-1/2

28-1/4

23-1/2

11-1/2

*24-1/2" from the edge of the side panel to the front.

25-1/2" from front to edge of endcaps.

Washer/Dryers SC QSart

5.7 cu. ft. Dryers

Back View

Power

Cord Hole

30-1/2

5.8, 6.0 and 7.0 cu. ft. Dryers

Back View

Power

Cord Hole

4-1/2

Power Cord LocationsDimensions and Installation Information (in inches)

Specification Revised 4/15

For complete information, see installation instructions packed with your dryer.

Ducting Materials:

For best performance, this dryer should be vented with 4" diameter all rigid metal

exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-

rigid) ducting can be used (Kit WX08X10077). In special installations, it may be

necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct.

A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid

metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter

can be maintained throughout the entire length of the transition duct. Please see

installation instruction packed with your dryer for complete instructions when using

flexible metal (foil type) ducting.

Exhaust Length Calculation:

1.Determine the number of 90° turns needed for your installation. If you exhaust to the

side or bottom of dryer, add one turn.

2.The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated

is shown in the table. A turn of 45° or less may be ignored. Two 45° turns within the

duct length should be treated as a 90° elbow. A turn over 45° should be treated as a

90° elbow.

Dryers must be exhausted to the outside.

Caution: For personal safety do not terminate exhaust into a chimney, under any

enclosed house floor (crawl space), or into an attic, since the accumulated lint could

create a fire hazard or moisture could cause damage. Never terminate the exhaust

into a common duct or plenum with a kitchen exhaust, since the combination of lint

and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts,

bird nesting, etc. The wall cap must also be located at least 12" above the ground or

any other obstruction with the opening pointed down.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

GTDS560GF

GE®7.0 cu. ft. stainless steel capacity gas dryer with Steam

& HE Sensor Dry

Dryer exhausting information—use metal

duct only vertical and horizontal ducting

2-1/2

GE Dryer Vent

2-1/2

GE Dryer Vent

Best performance

Maximum length

of 4" dia rigid

metal duct

Exhaust hood type

Domestic dryer models

Number

of 90°

turns

opening

2-1 /2"

opening

GE Frontload Long Vent 7.0

cu. ft. capacity electric dryer

(GFDL)

0200 ft. 175 ft.

1185 ft. 165 ft.

2175 ft. 155 ft.

3165 ft. 145 ft.

4155 ft. 135 ft.

5145 ft. 125 ft.

Long Vent 6.0 - 8.0 cu. ft.

capacity electric & gas dryers

(GTDL and GTV)

0150 ft. 125 ft.

1135 ft. 115 ft.

2125 ft. 105 ft.

3115 ft. 95 ft.

4105 ft. 85 ft.

595 ft. 75 ft.

Long Vent 7.0 cu. ft. capacity

electric & gas (GTD42, GTD45,

GTD65, GTX42 and GTX60)

0120 ft. 90 ft.

1100 ft. 75 ft.

285 ft. 65 ft.

370 ft. 55 ft.

460 ft. 45 ft.

555 ft. 35 ft.

All 6.0 - 8.3 cu. ft. capacity

models electric and gas dryers

(GFDS, GFDR, GFDN, GTDS,

GTDN, GHDN, GHDS, GTDP,

GLDP, GTD, HTDP, HTDX)

090 ft. 60 ft.

160 ft. 45 ft.

245 ft. 35 ft.

335 ft. 25 ft.

425 ft. 15 ft.

DCVH480

090 ft. 60 ft.

160 ft. 45 ft.

245 ft. 35 ft.

335 ft. 25 ft.

All 3.6 cu. ft. (DSKS, DSKP)

electric dryers

046 ft. 37 ft.

137 ft. 30 ft.

230 ft. 22 ft.

323 ft. 15 ft.

Laundry Center GUD27

056 ft. 42 ft.

148 ft. 34 ft.

240 ft. 26 ft.

332 ft. 18 ft.

Laundry Center GUD24

043 ft. 36 ft.

133 ft. 26 ft.

224 ft. 16 ft.

For every extra 90° elbow, reduce the allowable vent system length by 10 ft.

Two 45° elbows will be treated like one 90° elbow.

For the side exhaust installations, add one 90° elbow to the chart.

The total vent system length includes all the straight portions and elbows of

the system (transition duct included).

Specification Revised 4/15

Features and Benefits

• Steam Refresh - Rejuvenate lightly worn clothes by getting rid of wrinkles and

odors with this convenient setting using the power of steam

• Steam Dewrinkle - Stored or wrinkled clothes come out wrinkle-free with the

helpful setting that uses steam to refresh and dry a load of any size

• H E Sensor Dry - Keep your clothes looking and feeling their best. Dual

thermistors continually monitor temperature with a sensor bar that measures

moisture to prevent over-drying

• LED electronic controls with cycle countdown display - Show exactly how

much time is left for each cycle

• eDry option - Save up to 10% on energy costs without sacrificing

performance, thanks to this option that reduces temperatures on

select cycles

• Model GTDS560GFWS –White

GTDS560GF

GE®7.0 cu. ft. stainless steel capacity gas dryer with Steam & HE Sensor Dry

GTDS560EFWS

Specification Revised 4/15

Table of contents

Popular Dryer manuals by other brands

Bosch

Bosch WTA79200GB Installation and operating instructions

Amana

Amana W10233410A Use and care guide

Miele

Miele TWH 780 WP operating instructions

Asko

Asko T760 user guide

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Original instructions

Bosch

Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Operation and installation

Electrolux

Electrolux EW2H328R2 user manual

Beko

Beko DS8433RX1M user manual

Dawlance

Dawlance Spinner DS 6000 C owner's manual

Electrolux

Electrolux TP5080TW user manual

AEG

AEG TR838P4OB user manual

Indesit

Indesit IDV 75 instruction manual

Infiniton

Infiniton SD-DG85C manual

BOMANN

BOMANN WT 5019 instruction manual

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Installation

Asko

Asko T793C operating instructions

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer installation instructions