Fujitsu PRIMEQUEST 500A Series User manual

C122-E001-10EN

Front Cover

INSTALLATION MANUAL

C122-E001-10EN

FOR SAFE OPERATION

This manual contains important information regarding the use and handling of this

product. Read this manual thoroughly. Pay special attention to the section "NOTE

ON SAFETY" Use the product according to the instructions and information

available in this manual. Keep this manual handy for further reference.

Fujitsu makes every effort to prevent users and bystanders from being injured or from

suffering damage to their property. Use the product according to this manual.

ABOUT THIS PRODUCT

This product is designed and manufactured for use in standard applications such as

office work, personal device, household appliance, and general industrial

applications. This product is not intended for use in nuclear-reactor control systems,

aeronautical and space systems, air traffic control systems, mass transportation

control systems, medical devices for life support, missile launch control systems or

other specialized uses in which extremely high levels of reliability are required, the

required levels of safety cannot be guaranteed, or a failure or operational error could

be life-threatening or could cause physical injury (referred to hereafter as "high-risk"

use). You shall not use this product without securing the sufficient safety required for

high-risk use. If you wish to use this product for high-risk use, please consult with

sales representatives in charge before such use.

C122-E001-10EN

RADIO FREQUENCY INTERFERENCE STATEMENT

The following notice is for EU users only.

The following notice is for USA users only.

Laser standards

WARNING: This is a product which meets Class A of EN55022. In a domestic environment this

product may cause radio interference in which case the user may be required to take adequate

measures.

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

This equipment includes Class 1 laser products and complies with FDA Radiation Performance

Standards, 21 CFR 1040.10 and 1040.11, and the International Laser Safety Standards IEC60825-

1: 2001.

C122-E001-10EN

TRADEMARK ACKNOWLEDGEMENTS

zMicrosoft, Windows, MS, Windows NT, and Windows Server are trademarks or

registered trademarks of Microsoft Corporation in the United States and/or other

countries.

zLinux is a trademark or registered trademark of Linus Torvalds in the United States

and other countries.

zRed Hat, RPM, and all Red-Hat-based marks and logos are trademarks or

registered trademarks of Red Hat, Inc. in the United States and other countries.

zSUSE is a trademark of Novell, Inc. in the United States and other countries.

zIntel, Xeon, and Itanium are trademarks or registered trademarks of Intel

Corporation.

zEthernet is a registered trademark of Fuji Xerox Co., Ltd. and Xerox Corporation

in the United States and other countries.

zAll other product names mentioned herein are the trademarks or registered

trademarks of their respective owners.

zSystem and product names in this manual are not always noted with trademark or

registered trademark symbols (™), (®).

TERMS AND CONDITIONS

The product includes software provided by third parties in addition to that provided

by Fujitsu Ltd. You are granted permission to use the third parties' software subject to

the terms and conditions below. If you acquire the source code of the software to

which the following terms and conditions apply, refer to LICENSE1_EN.pdf and

LICENSE2_EN.pdf, which are provided with the 'PRIMEQUEST Manuals'

(C122-E013-C2).

THIS SOFTWARE IS PROVIDED "AS IS" AND FUJITSU LIMITED MAKES NO

WARRANTIES, EITHER EXPRESSED OR IMPLIED, AS TO ANY MATTER

WHATSOEVER REGARDING TO THIS SOFTWARE, INCLUDING, WITHOUT

LIMITATION, WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY

PARTICULAR PURPOSE.

IN NO EVENT SHALL FUJITSU LIMITED BE LIABLE FOR ANY CLAIM

FROM A THIRD PARTY, OR SPECIAL, INDIRECT OR CONSEQUENTIAL

DAMAGES OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF

USE, DATA OR PROFITS, WHETHER IN AN ACTION OF CONTRACT,

NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF OR IN

CONNECTION WITH THE USE, COPYING, MODIFICATION OR

DISTRIBUTION OF THIS SOFTWARE.

Fujitsu Ltd, April 2006

C122-E001-10EN

The contents of this manual shall not be disclosed in any way or reproduced in any

media without the express written permission of Fujitsu Limited.

C122-E001-10EN

Revision History

Edition Date Revised section

(Added/ Deleted/ Altered)

(Note) Details

01 2005-07-11 ⎯ ⎯

02 2005-09-16 All chapters

(correction)

CHAPTER 3 and 4

(correction)

Technical brushup

Addition of description for

Windows version

03 2005-10-31 All chapters (correction) Error corrections

04 2006-02-20 All chapters (correction) Addition of description for

PRIMEQUEST 420

05 2006-04-17 CHAPTER 2 (correction)

CHAPTER 2 (correction)

CHAPTER 4, Appendix E

(correction)

Addition of notes for network

settings

Correction of the procedures

for Linux installation

Addition of notes for PSA

installation

06 2006-08-11 All chapters (correction)

CHAPTER 2 (correction)

APPENDIX A (correction)

APPENDIX D (correction)

Addition of description for

PRIMEQUEST 500 series

Addition of description for

SUSE

Addition of description and

notes for XPAR setting

Addition of description for

software programs supplied

with the PRIMEQUEST

hardware

Correction of description for

the EFI driver setting

Addition of notes on replacing

an FC card

07 2007-03-05 CHAPTER 4, APPENDIX E

(correction)

Correction of description for

Watchdog setting

C122-E001-10EN

Edition Date Revised section

(Added/ Deleted/ Altered)

(Note) Details

08 2007-08-31 Section 4.8 (correction) Addition of description for

Linux dump function kdump

09 2008-03-10 Entire manual (addition) Addition of description for

PRIMEQUEST 580A/540A/

520A

10 2008-04-10 Entire manual (correction) Technical brushup

Note: In this table, the revised section is indicated by its section number in the

current edition.

An asterisk (*) indicates a section in the previous edition.

C122-E001-10EN i

Preface

This manual describes the preparation for PRIMEQUEST installation,

PRIMEQUEST power-on/off sequences, initialization procedures, and software

installation methods. This manual is intended for system administrators.

This section explains

zStructure and Contents of this Manual

zOther Reference Manuals

zAbbreviations

zText Conventions

zSyntax of the Command Line Interface (CLI)

zNotes Regarding Notations Used in This Manual

zConventions for Alert Messages

zEnvironmental Requirements for Using This Product

zReader Feedback

Structure and Contents of this Manual

This manual is organized as described below:

CHAPTER 1 PRIMEQUEST Overview

Provides an overview of the hardware, software, and network connections and

describes the workflow leading up to the initiation of operation.

CHAPTER 2 Setup

Describes how to perform the setup procedures required after installing the main unit.

CHAPTER 3 Operating System Installation

Describes the operating systems that can be installed, types of installation methods,

and operating system installation procedures.

CHAPTER 4 Work Required After Operating System Installation

Describes how to install and set up various software programs after installing the

operating system.

CHAPTER 5 Security Setup

Describes the SNMP and security settings.

ii C122-E001-10EN

Preface

CHAPTER 6 GSWB Initialization

Describes the initial settings required for using the optional GSWB product.

Appendix A Software Programs Supplied with the PRIMEQUEST

Hardware

Describes the software programs supplied with PRIMEQUEST.

Appendix B Installation Procedure

Provides instructions applicable to PRIMEQUEST installation.

Appendix C Power Control

Describes power-on and power-off.

Appendix D Installation in the SAN Boot Environment

Describes how to set up the SAN boot environment.

Appendix E Setting Item List

Provides lists of default values for the MMB (server management unit) and PSA

(PRIMEQUEST Server Agent).

Appendix F Overall View of Management LAN IP Addresses

Describes the IP addresses used for PRIMEQUEST.

Glossary

Explains the terms used in this manual.

Index

Provides keywords and corresponding reference page numbers so that the reader can

easily search for items in this manual as necessary.

This manual suits for next models

Table of contents

Other Fujitsu Server manuals

Fujitsu

Fujitsu PRIMERGY TX120 S3p User manual

Fujitsu

Fujitsu PRIMERGY RX600 S3 User manual

Fujitsu

Fujitsu PRIMERGY TX2560 M1 User manual

Fujitsu

Fujitsu PRIMEQUEST 2000 Series Instruction Manual

Fujitsu

Fujitsu PRIMERGY RX2510 M2 User manual

Fujitsu

Fujitsu PRIMERGY Econel 200 S2 Owner's manual

Fujitsu

Fujitsu Primepower200 User manual

Fujitsu

Fujitsu PRIMERGY TX140 S1 User manual

Fujitsu

Fujitsu SPARC M12-1 User manual

Fujitsu

Fujitsu PRIMERGY RX200 S2 User manual

Fujitsu

Fujitsu SPARC EnterpriseM3000 User manual

Fujitsu

Fujitsu PRIMERGY BX620 S4 User manual

Fujitsu

Fujitsu SPARC Enterprise M3000 User manual

Fujitsu

Fujitsu PRIMERGY RX300 S6 User manual

Fujitsu

Fujitsu PRIMERGY RX600 S3 User manual

Fujitsu

Fujitsu SPARC Enterprise T5440 Server User manual

Fujitsu

Fujitsu PRIMEQUEST 2000 Series Assembly instructions

Fujitsu

Fujitsu BX630 - PRIMERGY - S2 Dual User manual

Fujitsu

Fujitsu PRIMERGY RX2540 M4 User manual

Fujitsu

Fujitsu M10 Series Technical manual

Fujitsu

Fujitsu Primergy RX300 S2 User manual

Fujitsu

Fujitsu PRIMERGY BX900 User manual

Fujitsu

Fujitsu SPARC Enterprise T2000 Service manual

Fujitsu

Fujitsu PRIMERGY BX924 S4 User manual

Popular Server manuals by other brands

HP AlphaServer ES47 Cli reference manual

Dell

Dell PowerEdge R410 Getting started

PowerNAS

PowerNAS CMA quick start guide

Supero

Supero FatTwin F617R3-FT user manual

MSI

MSI P1-109N-L70 user manual

Dell

Dell PowerEdge XE9640 Installation and service manual

Dell

Dell PS4100 Hardware

EtroVISION

EtroVISION EV3151 user manual

NEC

NEC Express5800/T110j System configuration guide

HP ProLiant Gen9 user guide

Compaq

Compaq ProLiant 3000 Maintenance and service guide

Dell

Dell PowerEdge 3YPMN Getting started guide

iRobo

iRobo IPC2U user manual

Nortel

Nortel 1000 Con?guration guide user manual

Asus

Asus AP7500 Hardware reference guide

Avid Technology

Avid Technology AirSpeed 5000 manual

HP Integrity rx2600 overview

Milestone

Milestone Husky IVO 350T Getting started