FTP-642MCL001/002/301/302
3
Power supply
Dimension
Part number FTP-642MCL001/002 FTP-642MCL301/302
Interface Centronics (ESC/POSTM), RS232C
24VDC ±5%, Voltage
Current : average*2( ): Peak
For head 1.61 (2.03) A (at 80 mm/s printing speed, 25% printing ratio)
1.17 (2.03) A (at 50 mm/s printing speed, 25% printing ratio)
1.08 (1.16) A (at 30 mm/s printing speed, 25% printing ratio)
For motor 24VDC ±5%, 1.0 A maximum
24VDC ±5%, 1.0 A maximum
For cutter ----------
For logic 5VDC ±5%, 0.5 A maximum
Mechanism (cutter)
138 (W) ×48 (D) ×20 (H) mm (excluding lever) 147 (W) ×69 (D) ×42 (H) mm (w/cutter)
Interface board 131 (W) ×89 (D) ×24 (H) mm
Weight (Mechanism+Cutter) approximately 125 g approximately 450 g (w/cutter)
Mechanism Pulse durability : 1 ×108pulse/dot (using Fujitsu Takamisawa's standard
driving method)
Expected life Wear resistance : 50 km (at 25% printing ratio)
Cutter ---------- 3 ×105cuts
Operating temperature 0 to +50°C*3
Operating humidity 20 to 85% RH (no condensation)
Storage temperature –20 to +60°C (excluding paper)
Storage humidity 5 to 95% RH (no condensation)
Head temperature By thermistor (applied energy control, abnormal temperature detection)
Detection Paper out/Mark detect By photointerrupter
Head-up By microswitch
For front insertion use (112 mm width) : FTP-040PU001, FTP-040P0701
For rear insertion use (114 mm width) : FTP-040P0020, FTP-040P0702
*Recommended papers
· Oji paper : PD150R, PD160R, PD170R
· NIPPON paper : TF50KS-E,TF60KS-E,TF60KJ-R
· MITSUBISHI paper Mills : P220VBB-1, AFP-235
SpecificationsItem
(Continued)
Environmental
conditions
Recommended thermal sensitive paper
*1: There may be exceptions.
*2: 24 VDC, minimum head resistance.
*3: Guarantee: +5°C ~+40°C.
