Friedrich ZoneAire Compact P08S User manual

Table of Contents

Important Safety Guidelines………….………. 2

Introduction……………………………………………. 3

Unpacking Instructions & Contents .………. 4

Parts ……………............................................ 5

Display Functions …………………………………… 6

Remote Control Functions ………..…..………. 9

Drain Pipe ………………………….……..…..………. 12

Maintenance & Cleaning………………………... 13

Installation …………………………………………….. 14

Troubleshooting…………………………………….. 16

P08S/P10S Owner’s Manual

98081002_02

IMPORTANT

Do not install and use your portable air conditioner unit before carefully reading this instruction guide.

Please retain this manual brochure for product warranty and future reference

IMPORTANT SAFETY GUIDELINES

CAUTION

Operate this unit in an ambient of 89°F or less.

The heating function of the unit should be

operated in an indoor ambient temperature

between 44°F and 73°F.

Clean air filter periodically to enjoy the most

efficient cooling.

When the unit is shut off, please wait at least 3.5

minutes before restarting; this is to prevent the

compressor from being damaged.

This unit is for indoor cooling, heating and

dehumidifying.

When turning on the unit, the fan will operate but

the compressor will start up after the cooling

alarm flashes for three minutes.

In heating function, the heating alarm will flash for

3.5 minutes before the compressor and fan start

up.

If you have fuses , they should be of the time delay

type. Before you install or relocate this unit, be sure

that the amperage rating of the circuit breaker or

time delay fuse does not exceed the amp rating

listed in Table 1.

Table 1.

MODEL

CIRCUIT

RATING OR

TIME DELAY

FUSE

REQUIRED

WALL

RECEPTACLE

AMP VOLT NEMA

NO.

P08S,P10S

125

5-15P

INTRODUCTION

Congratulations on your purchase and welcome to Friedrich!

ZoneAire Compact: PORTABLE AIR CONDITIONER

The Air Conditioner has been designed and manufactured to the highest standards of modern

engineering.

Our product not only provides you a remote control to help user operate all the functions easily and

conveniently but also includes the following benefits:

•3-IN-1 SYSTEM: Offers cooling, dehumidification bonus heat for year-round conditioning

and comfort.

•Innovative design: One side offers cooling, simply turn the unit around and apply the exclusive

“heat clip“ for bonus heat option.

•Super portability with built in hose storage compartment underneath unit.

•Dual, easy-access antimicrobial nylon filters

•4-Speed fan with “Auto” setting for ultimate comfort

•24-hour timer for both cooling and dehumidification

•Unique Sleep Control function – Increases temperature 2 degrees every 4 hours

•LCD remote control

•Moves easily from room to room on easy glide castors.

and

UNPACKING INSTRUCTIONS & CONTENTS

UNPACKING INSTRUCTIONS

1. Place the unit in the correct upright position before unpacking.

2. Cut the two packing straps.

3. Slide the carton in an upward motion and it will release from the base.

4. Grip the carry handles located on either sides of the unit and carefully lift until it slides out of

the foam base.

5. Lift and lean the unit slightly to take out exhaust hose from unit’s bottom as picture.

6. Install the exhaust hose on the unit before operating the unit.

CONTENTS

1. Air conditioner unit

2. Exhaust Hose

3. Remote control

4. Batteries

5. Window Kit

6. Heat Clip Connector

Exhaust Hose

Heat Clip

Window Kit

PARTS

1. Control panel

2. Remote control receiver

3. Hot air-outlet

4. Evaporator’s filter

5. Cool air-inlet

6. Air-outlet’s joint part

7. Cool air-outlet

8. Condenser’ s filter

9. Hot air-inlet

10. Drain hole

DISPLAY FUNCTIONS

KEY

Press to turn unit "ON" or "OFF".

2. MODE

Press this key to select cooling, heating, or dehumidifying.

3. TEMPERATURE REGULATION KEY (UP)

- During cooling function：This key raises the preset temperature by 1°F each time it is pressed

and the maximum limit is 86°F.

- During heating function：This key raises the preset temperature by 1°F each time it is pressed

and the maximum limit is 77°F.

4. TEMPERATURE REGULATION KEY (DOWN)

-During cooling function：This key lowers the preset temperature by 1°F each time it is pressed

and the minimum limit is 63°F.

- During heating function：This key lowers the preset temperature by 1°F each time it is pressed

and the minimum limit is 59°F.

5. L.E.D. DISPLAY

The display indicates the current setting temperature or the timer setting. When the set

temperature or the timer is adjusted, the new setting is shown then the display returns the

current set temperature.

※The display is also used to show error codes should a fault occur, see TROUBLE SHOOTING.

1. ON/OFF

when the unit is not working, hold the function button for 10 seconds to change the temperature

scale /°F.°C

6. FAN SPEED

Press to select either LOW, MEDIUM, HIGH or AUTO fan speed.

If "AUTO" is selected (During cooling function),”HIGH” or "MEDIUM" or “LOW" will be

selected automatically according to the difference between setting temperature and

ambient temperature.

Note: In heating function and dehumidifying function, this key is invalid because the

unit is defined to be high speed in heating mode and low speed in dehumidifying mode.

7. PROGRAMMABLE TIMER

Programmable timer ON/OFF key.

TIMER-ON: The timer-on is used to turn on the unit automatically after the set time is over.

1. Press the "TIMER" key at stand-by status to set the time you desired.

2. Once the set hour has come to an end, the unit will turn on automatically.

3. Press the "POWER" key before the time out; the set time will be canceled and the unit will turn on.

4. You can set the function and fan speed while setting the timer.

TIMER-OFF: The timer-off is used to turn off the unit automatically after the setting time is over.

1. Press the "TIMER" key at operating status to set the time you desired.

2. Once the set hour has come to an end, the unit will turn off automatically.

3. Press the "POWER" key before the time out, the set time will be canceled and the unit will

turn off.

DISPLAY FUNCTIONS

MAINTENANCE AND CLEANING

8. SLEEP CONTROL FUNCTION

1. While in cooling mode, press the SLEEP key to set the temperature. It increases 2°F after an

hour and at most increases 4°F after 2 hours.

2. While in heating mode, press the SLEEP key to set the temperature. It decreases 2°F after

hour and at most decreases 4°F after 2 hours.

3. Press the SLEEP key again to cancel the setting.

9. ALARM

When the water tank is full,"E4" will be displayed on the display panel. To resume operation,

please remove the rubber cap of the drain hose to drain out the water firstly. The E4 warning

will disappear after draining, and then you can restart the unit by pressing the POWER key.

DISPLAY FUNCTIONS

In “Sleep” mode, your unit will automatically go into low fan speed allowing the temperature

to slowly drift up (in cooling) or down (in heating). See below:

REMOTE CONTROL FUNCTIONS

Instruction for the operating keys:

When a remote control signal is transmitted, a transmission icon on the display flashes once,

indicating the signal has been transmitted.

1. Transmission window

2. Liquid crystal display

3. Mode select key:

Select from among the three functions: cooling, heating and dehumidifying. The fast key

function indicates the above operating modes in a cycle when the key is pressed without

being released. However, the transmission icon will not appear until the key is released and

the confirmed mode is transmitted.

4. Setting keys for room temperature:

The set temperature will rise by 1°F when the ▲key is pressed once and the set temperature

will fall by 1°F when the ▼key is pressed once. Both keys have the fast key function and can

make the set temperature rise or fall continuously when the keys are pressed without release.

5. Power key:

When this key is pressed, the memorized modes and other information about temperature,

speed, direction of airflow, sleep, etc., in the remote control will be transmitted to the unit and

it will operate correspondingly. When the key is pressed again, the main unit will stop

immediately.

6. Sleep key

When this key is pressed, the air flow of the unit changes into sleep mode (low speed).

(1) Press “SLEEP” key, set sleep function; press again, and cancel sleep setting.

(2) The temperature will increase 2°F half an hour after setting sleep function, and will

increase at most 4°F every two hours after that.

(3) When the main power supply is cut off, the sleep function setting will be cancelled

automatically.

(4) When you turn off the unit, sleep function setting will be cancelled automatically.

REMOTE CONTROL FUNCTIONS

This manual suits for next models

Table of contents

Other Friedrich Air Conditioner manuals

Friedrich

Friedrich MW09C1H User manual

Friedrich

Friedrich Kuhl SQ06 User manual

Friedrich

Friedrich OHS Series User manual

Friedrich

Friedrich QuietMaster SL28L30 User manual

Friedrich

Friedrich Kuhl KCM21A30A User manual

Friedrich

Friedrich CP06E10 Building instructions

Friedrich

Friedrich Hazardgard SH15L30-C User manual

Friedrich

Friedrich PTAC Series User manual

Friedrich

Friedrich WallMaster WCT08 User manual

Friedrich

Friedrich PDE07R3SG User manual

Friedrich

Friedrich MW09Y3FM User manual

Friedrich

Friedrich ZoneAire P09B User manual

Friedrich

Friedrich HEAT PUMPS Operating instructions

Friedrich

Friedrich CP05N10 User manual

Friedrich

Friedrich M2404ER Building instructions

Friedrich

Friedrich VHA24K25 Series Original operating instructions

Friedrich

Friedrich FPHMR18A3A Building instructions

Friedrich

Friedrich MW09Y3H User manual

Friedrich

Friedrich M18YJ User manual

Friedrich

Friedrich C36YJ User manual

Friedrich

Friedrich Kuhl SS08M10 User manual

Friedrich

Friedrich Kuhl SS10 User manual

Friedrich

Friedrich Kuhl SM21M30 User manual

Friedrich

Friedrich Vert-I-Pak A-Series Original operating instructions

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual