Friedrich KP06 User manual

Room Air Conditioner

Installation and Operation

Manual

KP Line

115 Volts •KP05 • KP06

Registering Your Room Air Conditioner

Model information can be found on the name plate located on the

side of the unit near the control panel. Please complete and mail

the owner registration card furnished with this product or register

on-line at www.friedrich.com (USA only). For your future

convenience, record the model information here.

MODEL NUMBER SERIAL NUMBER PURCHASE DATE

Congratulations!

You have purchased a Friedrich

room air conditioner. The Friedrich unit is

designed to give maximum comfort and

quietness.

Table of Contents

Introduction .................................................................................. 2

Safety Precautions ....................................................................... 3

How to operate your Friedrich ................................................... 5

Features and Installation ............................................................. 7

Installation Instructions ............................................................... 8

Troubleshooting Tips ................................................................. 11

Warranty ...................................................................................... 12

Introduction

Before Operating Your Unit

Make sure the wiring is adequate for your unit.

If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that

the amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in figure 1.

DO NOT use an extension cord.

The cord provided willcarry the proper amount ofelectricalpowerto the unit; an extension cordwillnot.

Make sure that the receptacle is compatible with the wall plug provided.

Thisinsures proper grounding. If you have a two-prongreceptacle you willneed to have the circuit replaced

by a certified electrician with a grounded circuit that meets all national and local codes and ordinances. You

must use the three-prong plug furnished with the air conditioner.

MODEL

KP05

KP06

CIRCUIT

RATING OR

TIME DELAY

FUSE

AMP VOLT

15 125

PLUG FACE

NEMANO.

5-15P ©Figure 1

For the Best Cooling Performance and Energy Efficiency

Keep the filter clean

Make sure that your air conditioner is always in top performing condition by cleaning the filter regularly.

Instructionsfor removing and cleaningthe filter can be found on page 6.

Provide good airflow

Make sure that the airflowto and from the unit is dear. Your air conditioner puts the air out at the top of

the unit, and takes in air at the bottom. Airflow is critical for good operation. It is just as important on the

outside ofthe building that the airflow around the unit exterior is not blocked.

Unit Placement

If your air conditioner can be placed in a windowor a wallthat is shaded by a tree or another building,the

unit will operate even more efficiently. Using drapes or blinds on the sunny side of the dwelling will also

add to your unit's efficiency.

Insulation

Good insulation will be a big help in maintaining desirable comfort levels. Doors should have weather

stripping. Be sureto caulk around doors and windows.

Safety Precautions

To prevent injury and property damage, follow these instructions.

• Incorrect operation due to ignoring instructions can cause harm or damage. The seriousness is classified

by the following indications.

/_X WARNING This symbol indicates the possibility of death or serious injury.

/_ CAUTION This symbol indicates the possibility of injury or damage to

_. properties only.

• Meanings of symbols used in this manual are as shown below.

I I .everooth.1

0,,wa,sOoThis

, Otherwise, it will cause electric

shock or fire due to heat

generation.

, it will cause electric shock or fire

due to heat generation. •Itwill cause electric shock or fire.

• If the powercord isdamaged,it must

bereplacedbythe manufactureror a

Friedrich-certifiedserviceagent.

, it will cause electric shock or fire

due to heat generation.

, It will cause electric shock.

° This could lead to health problems.

, They are sharpand maycause

an injury.

[/k c,,,UT,O.1

. Water may enter the unit and

degrade the insulation. It may

cause an electric shock.

. Since the fan rotates at high

speed during operation, it may

cause an injury.

. it could cause dust to

accumulate on the heat

exchanger.

. This could injure the pets

or plants. . Do not use this air conditioner to

preserve precision devices, food,

pets, plants, and art objects.

It may cause deterioration of

quality, etc.

. It may cause an electric shock.

. It may cause a fire or • Use caution when handlingthe

deformation of the cabinet, case. Grip it firmly anddo not allow

it to slip while holding it.

• Useheavyglovesto handle

___e ._r_ the caseif necessary. Sharp

)) •DO NOT

allowthe

caseto slide

against

yourskin!

How to operate your Friedrich

The controls willlook like the following.

Control and Remote Control Operations

TEMPERATURE SETTING

•Thesebuttonscontrolthe temperature

of theroom.Thetemperaturecanbe set withina rangeof

60°F to86°F, in incrementsof I°F.

MONEY SAVER

The fanstopswhenthecompressorstopscooling.

• Approximatelyevery3 minutesthefan willturnon and sample

theroomairto determineifmorecoolingisneeded.

OPERATION MODE SELECTOR

• Everytimeyoupushthisbutton,itwill rotate betweentheCOOL,

FANand DRYmodes.

(_ ONIOFF TIMER

ON-Whentheairconditionerisoff,itcanbe settoautomatically

comeon in 1to 12 hoursat its previoussetting.Eachtouchwill

setthe timerin hours.

OFF-Whentheair conditionerison, itcanbe set toautomatically

turn off in 1 to 12hours. Eachtouchwill setthetimer in hours.

After thetimer hasbeenon for 30 minutes,thetemperaturewill

automaticallyrise2°F,and afteranother30 minutes,itwill

automaticallyrise2°F again.Thetemperaturewillthenstaythe

sameuntilthetimer goesOFF.

To cancel the timer, pressthe TIMERpad untilthe displaytime

disappears.

(_ POWER

•Toturnthe unitON, pushthe button.Toturnthe unitOFF,push

thebuttonagain.

• This buttontakes priorityoverany otherbuttons.

• Whenyou firstturnit on,the unitison theHighcoolmodeand

thetemp.at72°F

FAN SPEED

•Everytimeyou pushthisbuttonit willrotate betweenthe

followingfanspeeds:

High (F3)--, Low(F1) -_ Medium(F2)--,High(F3)

How to Insert Batteries

1. Remove the cover from the back of the remote

controller

2. Insert two batteries.

• Be sure that the (+) and (-) directions are correct.

• Be sure that both batteries are new.

3. Re-attach the cover.

• Do not use rechargeable

batteries. Such batteries

differ from standard dry

cells in shape, dimensions,

and performance.

• Remove the batteries from

the remote controller if the

air conditioner is not going

to be used for an extended

length of time.

Additional controls and important information.

Air Direction

• ADJUSTING THEAIR DIRECTION USING THE HORIZONTAL AIR-DEFLECTOR CONTROL

Using the control tabs, the air flow can be directed __llm_"

to the left, right, straight ahead, or any combination

of these directions.

Care and Maintenance

TURN THE AIR CONDITIONER OFF AND REMOVE THE PLUG FROM THE POWER OUTLET.

•TO CLEAN FILTER

The air filter will become dirty as it removes

dust from the inside air.

It should be washed at least every 2 weeks.

If the air filter remains full of dust, the air

flow will decrease and the cooling capacity

will be reduced, possibly damaging the unit.

1. Pull the inlet grille forward and pull out the

air filter. (Fig. 1)

2. Wash the air filter in warm water.

Be sure to shake off all the water before

replacing the filter.

Do not force open

or open too far

Fig. 1

•CLEANING THE AIR CONDITIONER

The front grille and Inlet grille may be wiped with a

cloth dampened in a mild detergent and lukewarm

water solution. (Fig. 2)

The cabinet may be washed with mild soap or

detergent and lukewarm water. Fig. 2

To ensure continued peak efficiency, the condenser

coils(outside of unit) should be checked

periodically and cleaned if clogged with soot or

dirt from the atmosphere.

ConsuLta certified Friedrich service agent for more information.

•HOW TO REMOVE THE FRONT GRILLE

1. Pull the inlet grille forward.

2. Removethe screw securing the Front Grille. (Fig. 3)

3. Pushthe grille up from the bottom and pull the top of the

grille away from the caseto lift the top tabs out oftheir

slots. (Fig. 4)

4. Carefully position the grille, bottom first, and snap back into

place.

5. Repositionthe screwthat secures the front grille and replace

the knobs.

Fig. 3

Fig. 4_Lw

Features and Installation

Learning the key components will help you properly install the unit.

Features

t 9

t0 8

1. CABINET

2. HORIZONTAL AIR DEFLECTOR

3. COOL AIR DISCHARGE

4. FRONT GRILLE

5. INLET GRILLE

6. AIR FILTER

7. CONTROL BOARD

8. AIR INTAKE

9. UPPER GUIDE

10. REMOTE CONTROLLER

Installation Instructions

Window Requirements

NOTE:All supporting parts should be secured to firm wood, masonry, or metal.

1. This unit is designed for installation in standard double hung windows with actual opening widths of

22"to 36". The upper and lowersash must open sufficiently to allow a clear vertical opening of 14"

from the bottom of the sash to the window sill.

2.If stormwindow presents interference, fasten a 2" widewood strip (OUTER SILL) to the inner

window sillacross the full width of the sill.The wood strip should bethick enough to raise the height

of the window sill so that the unit can be installed without interference by the storm window frame.

See Fig. 5-2. Top of wood strip should be approximately 3/4" higher than the storm window frame

(STORM WINDOW FRAME)or wood strip (OUTDOORS) to help condensation to drain properlyto

the outside.

3. Installa second wood strip (approximately 6" long by 11/2"wide and same thickness asfirst strip) in

the center of the outer sill flush against the back off the inner sill. This will raisethe L bracket as

shown Fig. 5-2.

4. If the distance between STORMWINDOW FRAMEand WOOD STRIP MOUNTEDON TOPOF

INNER SILL is more than 1",two of wood stripare not necessary.

INNER WOOD STRIP MOUNTED 1" MAX.

SILL ON TOP OF INNER SILL

INNER /

SILL J

WOOD STRIP

FOR L BRACKET

O_UER

ILL

TDOORS

Fig. 5-1

3/4"

CLEARANCE'

STORM

WINDOW

FRAME

OUTER

SILL

INDOORSq INDOORS OUTDOORS

Fig. 5-2

Installation

HARDWARE 1

TYPEA: 1lEA

(SHORTSCREW)

TYPEB:5EA TYPEC:3EA

(WOODSCREW) (L BRACKET)

TYPED: lEA TYPEE:lEA TYPEF:2EA TYPEG:lEA

(SEAL STRIP) (SASH SEAL) (GUIDE PANEL) (SUPPORT BRACKET)

(Adhesivebacked) (Notadhesivebacked)

This manual suits for next models

Table of contents

Other Friedrich Air Conditioner manuals

Friedrich

Friedrich QuietMaster KM18L30 User manual

Friedrich

Friedrich QUIETMASTER 2008 User manual

Friedrich

Friedrich ZQ08B10 Building instructions

Friedrich

Friedrich Twin Temp EM24L34 User manual

Friedrich

Friedrich SH15 User manual

Friedrich

Friedrich MW09C1H User manual

Friedrich

Friedrich CP18C30 User manual

Friedrich

Friedrich Uni-Fit UE10C33 Thru-the-Wall Series Building instructions

Friedrich

Friedrich Room Air Conditioners User manual

Friedrich

Friedrich MR09C1H User manual

Friedrich

Friedrich MR09Y3H User manual

Friedrich

Friedrich ZoneAir P012A User manual

Friedrich

Friedrich CP06E10 User manual

Friedrich

Friedrich Z-Star ZQ05 User manual

Friedrich

Friedrich Kuhl SQ06 User manual

Friedrich

Friedrich QuietMaster KS12 User manual

Friedrich

Friedrich MD36Y3J User manual

Friedrich

Friedrich KStar KQ05 User manual

Friedrich

Friedrich DVKA User manual

Friedrich

Friedrich CHILL CP08 User manual

Friedrich

Friedrich Chill CP12G10B User manual

Friedrich

Friedrich MD12Y3JM User manual

Friedrich

Friedrich ZoneAire P09B User manual

Friedrich

Friedrich 9315342720-02 User manual

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual