FLIR FC-Series Assembly instructions
427-0073-12-28 Rev 110 May 2015
FC-Series Camera
Quick Connect Gui e
For installations that are using the Concealed Cable Mounting Arm, refer to the
installation manual for instructions:
FLIR FC-Series Installation Manual (4 7-0073-1 -1 )
Caution!
Note
Except as described in this guide, do not disassemble the FC-Series camera.
Damage to the camera can occur as the result of careless handling or
electrostatic discharge (ESD).
Prior to making any connections, ensure the power is switched off.
Power: Power Over Ethernet Plus (PoE+) or 14 - 3 Vdc or 18 - 7 Vac
Power terminal blocks: wire size from 16 AWG to 0 AWG
Analog Vi eo Cable: BNC-terminated RG-59/U solid-center coax cable
Accessory I/O Cable: wire size 6 AWG, stranded (1 mm diameter including
insulation)
Items Inclu e in Kit
3 mm hex
2.4 mm slotte
screw river
key
427-0073-12-28 v110 FC-Series Quick Connect.fm Page 1 Thursday, May 7, 2015 11:07 AM
https://www.supplychimp.com/
427-0073-12-28 Rev 110 May 2015
Step 1 Remove cover: Using 3 mm hex key, loosen four captive
screws. Removal of sunshield not necessary.
Step 2 Install cables through sealing gland:
Step 3 If using conventional power cable, strip cable as described
below:
Access captive screws
through slots in sunshiel .
Vi eo coax
Glan nut
Ethernet
Accessory
Power cable Groun
Re-tighten gland nut after
installation is completed.
Fill any unused hole with
orange plug.
(0.8±.20 in)
20.0±5 mm
Remove outer
jacket
(0.2±.04 in)
6.0±1 mm
Strip ends
3 Places
Min diameter = 6.8 mm (0.27 in)
Max diameter = 9.4 mm (0.37 in)
Power Cable
427-0073-12-28 v110 FC-Series Quick Connect.fm Page 2 Thursday, May 7, 2015 11:07 AM
https://www.supplychimp.com/
427-0073-12-28 Rev 110 May 2015
Step 4 Terminate cables:
Caution!
Connection Purpose
1 3-pin Jumper Lens heater on/off
RCA Analog video test point
3 BNC Analog video
4 3-pin Terminal AC/DC Power
5 Ethernet PoE power, communications, IP video stream
6 6-pin terminal J8 General purpose I/O (GPIO)
7 Reserved for future use Do not connect
Table 1-1: Power Connector
1 Chassis
Vac/dc -
3 Vac/dc +
Table 1-2: GPIO Connections - J8
Pin Connection Pin Connection
1 Chassis ground 4 GPIO In
(digital ground)
GPIO Out 5 GPIO In (+5V)
3 GPIO Out 6 Chassis ground
Pins 4 and 5 should not be connected to any voltages or power sources outside
the camera. Damage to the camera may result.
Reserve J3
pin 1
GPIO J8
427-0073-12-28 v110 FC-Series Quick Connect.fm Page 3 Thursday, May 7, 2015 11:07 AM
https://www.supplychimp.com/
427-0073-12-28 Rev 110 May 2015
Step 5 Connect a ground wire between the ground stud on the back
of the camera and the nearest earth-grounding point.
Step 6 Test camera: Power on the camera and test video.
Use a web browser to test IP communications
(default IP: 192.168.250.116; login: user/fliradmin)
Step 7 Tighten Cable seal gland nut to ensure a watertight seal.
Step 8 Replace cover: Alternately tighten the four captive screws in
the cover; torque to 1.8 N-m (16.0 in-lbs).
Ensure the camera is properly grounded. Failure to properly ground the camera
can lead to permanent damage to the camera. Typical to good grounding
practices, the camera chassis ground should be connected to the lowest
resistance path possible. FLIR requires a grounding strap anchored to the
grounding lug and connected to the nearest earth-grounding point.
Before installing the FC-Series camera you should read and understand the
following documents which provide details regarding mechanical dimensions
and installation safety.
• FLIR FC-Series Installation Manual (4 7-0073-1 -1 )
• FLIR FC-Series S Interface Control Document (4 7-00XX-XX-19S)
Documents provided on the documentation CD or from the FLIR website
427-0073-12-28 v110 FC-Series Quick Connect.fm Page 4 Thursday, May 7, 2015 11:07 AM
https://www.supplychimp.com/
Other manuals for FC-Series
3
Table of contents
Other FLIR Security Camera manuals
FLIR
FLIR F-348 User manual
FLIR
FLIR Lorex LNB4163 Series User manual
FLIR
FLIR FXV101 User manual
FLIR
FLIR Quasar Gen II Series CM-6212 H1-I Manual
FLIR
FLIR D-Series C Assembly instructions
FLIR
FLIR Quasar CP-6408-21-I User manual
FLIR
FLIR Nexus User manual
FLIR
FLIR MPX C234BC User manual
FLIR
FLIR A3 F series User manual
FLIR
FLIR FB-Series User manual
FLIR
FLIR N258F5 Series User manual
FLIR
FLIR Raymarine CAM220IP User manual
FLIR
FLIR MPX C347VC2 Series User manual
FLIR
FLIR Quasar Gen III User manual
FLIR
FLIR MPX C357VW4 Series User manual
FLIR
FLIR Saros User manual
FLIR
FLIR Quasar CP-6408-21-I User manual
FLIR
FLIR FX User manual
FLIR
FLIR CF-5212 Manual
FLIR
FLIR MPX C237VC User manual
