DT Research DT311NV User manual
Rugged Tablet
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
Copyright © 2020, DT Research, Inc. All Rights Reserved. BOG021820 DT311NV ENG
INTRODUCTION
Thank you for acquiring the DT311NV, part of DT Research’s line of Rugged tablets.
Featuring a slim yet robust enclosure, the DT311NV with 11.6” and dual mode
switchable NVIS or high-brightness touchscreen is powered by the Intel® processor,
oering opmal combinaons of performance and power savings. The DT311NV is
available with Microso® Windows® operang system and features web browser,
client/ server compung soware, media player, accessories, and applicaons
support.
PACKAGE CONTENTS
• One DT311NV with Baery Pack and Handstrap
• AC-DC Power Adapter with Power Cord
• Basic Operaon Guide
* If your DT311NV contains camera or barcode scanner, please refer to the Tablet
Modules Basic Operaon Guide for detailed operaon.
DT311NV
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in
a residenal installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in
conjuncon with any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
Button Functions
BUTTON ACTION BUTTON ACTION
Power Buon Control Center Buon
Windows Key Buon NVIS/ Normal Mode Toggle
Programmable Buons Brightness Control Buons
Baery Latch *Push the switch up
to unlock the latch, then slide the latch
le to remove the baery.
Input/ Output Ports
Headphone Jack
LAN Port
USB 3.0 Port
USB Type-C Port
(also as power input)
Smart Card Reader
1 2
3
5
4
6
7
A
B
C
E
D
2
Sleep Mode LED
5
7
1
E
A
C
D
B
2 3 4 6
Baery/Power LED
3
PRECAUTIONS
• Always exercise care when operang and handling the DT311NV.
• Do NOT apply excessive pressure to the display screen.
• We recommend using the Digital Pen (oponal) to keep the screen clean.
• Avoid prolonged exposure of the display panel to any strong heat source.
Wherever possible, the DT311NV should face away from direct light to reduce
glare.
• If the AC-DC power adapter is used to recharge or power the tablet, do NOT
use any AC-DC adapter other than the one provided or acquired from the
manufacturer or its partners.
• In the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power o the DT311NV and disconnect all power sources. Report
the problem to your device provider immediately.
• Never aempt to disassemble the DT311NV, as this will void the warranty.
BASIC FEATURES
The DT311NV rugged tablet integrates a dual mode switchable NVIS or high-
brightness touchscreen, USB ports, and embedded networking elements such as
wireless LAN and Bluetooth or oponal 4G LTE/ AWS.
A DT311NV typically integrates an 802.11ac wireless LAN (WLAN) adapter that may
connect to other wireless devices or access points. If your DT311NV does not come
with such a network adapter, please consult your device provider to establish the
desired network connecvity.
NOTE:
To obtain protecon consistent with any IP rang for the device, the I/O (audio,
power, USB, card reader, etc.) port doors must be closed. If the IP protecon is
compromised by mishandling or misuse, such as by leaving port doors open or
improperly closed, any resulng product damage will not be covered under any
DT Research warranty.
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed aer a launch sequence of several seconds. The wireless
LAN connecon may take 10-15 seconds to be established.
Configuring the Rugged Tablet
The DT311NV may be congured using the ulies and methods dictated by
the soware operang system. The DT311NV should be congurable for various
properes such as user proles, network features, and several system elements.
NVIS Mode and Screen Brightness Control
• When power buon is pressed to power on the unit, power LED will ash orange
once to indicate the unit is boong. Unit will boot into NVIS mode with zero nit
brightness by default and display will be dark. You can press the “Brightness Up”
and “Brightness Down” buons to set NVIS mode display to desired brightness
(up to 20 nits).
• To toggle between NVIS and high-brightness display mode, press the “NVIS/
Normal Mode Toggle” buon. When changed from NVIS mode to high-brightness
mode, display brightness percentage will be same as the brightness level set in
NVIS mode before toggling.
• Use brightness control buons to set desired brightness level. When changed
from normal display mode to NVIS mode, display brightness will be set to 0 nit
(display is dark) and you need to use brightness control buons to change display
to desired brightness.
• Brightness up, Brightness down, NVIS/Normal toggle, Windows Key and Control
Center funcons are xed and not user programmable.
• Two programmable buons on le side can be programmed through Buon
Manager.
5
OPERATION
Powering ON and OFF
To acvate the DT311NV, push and quickly release the Power Buon. The display will
come on in a few seconds. To put the DT311NV in Standby mode, push and quickly
release the Power Buon. To turn the DT311NV o for extended storage, power
o safely using any soware funcon that “shuts down computer” provided in the
soware operang system.
NOTE:
The baery pack shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT311NV when seng up for the rst me to fully
charge the baery pack, or use the oponal baery charger kit.
NOTE:
When the baery pack is charging, the blue Baery LED should blink slowly.
If plugging in the AC-DC adapter does not trigger this blinking acvity and
the LED stays dark, the baery pack(s) may have been drained substanally.
Try unplugging/ replugging the AC-DC adapter to the DT311NY a few mes to
acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby” mode while not in use. Pushing briey on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (“hold 4+ seconds” feature) to turn o the
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
4
7
USING THE RUGGED TABLET
Peripherals Support
Through its USB 3.0 port, the DT311NV supports a wide range of USB-based
peripherals. These peripherals are applicable for soware installaon, applicaons
storage, data storage, and system soware recovery and updates.
For More Support
Users can download the Tablet Modules Basic Operaon Guides from the DT Research
website.
If the DT311NV comes with a Mobile broadband module, please contact your
product and/or service provider for the SIM Card installaon procedures.
To Hold the Tablet
Le hand: grip the le back side of the tablet
with your le hand four index ngers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.
Right hand: grip the right back side of the tablet
with your right hand four index ngers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.
6
Wireless Networking
Wireless LAN
The DT311NV is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
• Through the support of typical WLAN adapters, the DT311NV should be able to
detect all 802.11 access points in the vicinity to select the access point of choice
for connecon.
• The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT311NV and the
access points have to match. The SSID is case-sensive and it is recommended to
enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for secure access.
• When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
• Refer to the access point operang manuals for seng up the 802.11 access
points.
Bluetooth
The Bluetooth conguraon applicaon is enabled from the System Tray or from the
Windows Mobility Center. Follow the instrucons and opons provided within the
applicaon to congure and invoke Bluetooth connecvity with the corresponding
peripherals.
Other DT Research Tablet manuals
DT Research
DT Research DT395BV Assembly instructions
DT Research
DT Research DT372 Assembly instructions
DT Research
DT Research 340Q Assembly instructions
DT Research
DT Research DT302RP Assembly instructions
DT Research
DT Research DT395BV Assembly instructions
DT Research
DT Research DT395BT Assembly instructions
DT Research
DT Research DT301T Assembly instructions
DT Research
DT Research DT380CR Assembly instructions
DT Research
DT Research DT302P Assembly instructions
DT Research
DT Research DT311Y Assembly instructions
DT Research
DT Research DT311T Assembly instructions
DT Research
DT Research DT307SC Assembly instructions
DT Research
DT Research 306Q Assembly instructions
DT Research
DT Research DT301T-TR Assembly instructions
DT Research
DT Research DT390i Assembly instructions
DT Research
DT Research DT315CT Assembly instructions
DT Research
DT Research DT382GL Assembly instructions
DT Research
DT Research WebDT 312 Assembly instructions
DT Research
DT Research DT311H Assembly instructions
DT Research
DT Research 502T Assembly instructions
Popular Tablet manuals by other brands
Laser
Laser MID-1060 Quick operation guide
MUNBYN
MUNBYN IRT09J Easy setup guide
Motorola
Motorola MC3090R - Win CE 5.0 Professional 520 MHz quick start guide
Dell
Dell Latitude ST Setup and features information
Lenovo
Lenovo IdeaTab S6000L Hardware Maintenance Manual
Venturer
Venturer WT9L11 quick start guide
