Dimplex BAR20-AU User manual

INSTRUCTION MANUAL

For domestic household use only.

Bari 2kW Optiflame Portable

Electric Fire

Model: BAR20-AU

08/54594/0 Issue 3

OCN 11905

IMPORTANT

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND

RETAINED FOR FUTURE REFERENCE.

CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/

OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY

Please read the operating instructions carefully before using your product for

the first time and keep them in a safe place.

• When using electrical appliances, basic precautions should always be followed

to reduce the risk of fire, electrical shock and injury to persons, including the

following:

• If the appliance is damaged, check with the supplier before installation and

operation.

- Do not use outdoors.

- Do not use in the immediate surroundings of a bath, shower or a

swimming pool.

- Do not use this heater if it has been dropped.

- Do not use if there are visible signs of damage to the heater.

- Use this heater on a horizontal and stable surface, or fix it to the

wall, as applicable.

• Do not locate the appliance immediately below a fixed socket outlet or

connection box.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the

appliance.

• Do not use this appliance in series with a thermal control, a program controller,

a timer or any other device that switches on the heat automatically, since a

fire risk exists when the appliance is accidentally covered or dis-placed.

• In the event of a fault, unplug the appliance.

• Unplug the appliance when not required for long periods.

• This product is only intended for INDOOR RESIDENTIAL applications only.

• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.

• DO NOT route cord under furniture or appliances. Take care to position the

cord away from traffic areas and where it will not be a tripping hazard.

• This appliance must not be used in a bathroom.

• Although this appliance complies with safety standards, we do not recommend

its use on deep pile carpets or on long hair type of rugs

• The appliance must be positioned so that the plug is accessible.

• If the supply cord is damaged it must be replaced by the manufacturer or

service agent or a similarly qualified person in order to avoid a hazard.

• Keep the supply cord away from the front of the appliance.

• Do not use this heater in small rooms when they are occupied by persons

not capable of leaving the room on their own, unless constant supervision is

provided.

• In order to avoid overheating, DO NOT COVER the appliance. Do not place

material or garments on the appliance, or obstruct the air circulation around

the appliance, for instance by curtains or furniture, as this could cause

overheating and a fire risk.

• This Heater carries the warning symbol indicating that it must not

be covered.

• In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,

this appliance must not be supplied through an external switching device,

such as a timer, or connected to a circuit that is regularly switched on and off

by the utility.

• CAUTION Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vulnerable people are

present.

• Children shall not turn on/off the appliance.

• Ensure that furniture, curtains or other combustible material are positioned

no closer than 1 metre from the appliance.

• Unplug the appliance when not required for long periods.

Exposed to the

weather outdoors

Near water If the power cable

wires are frayed or cut

Where small children

may be left unattended

No extension leads or

power boards

Where there is risk

of fire or close to

a naked flame

Where the power

cable may be

damaged

On a slope or

uneven surface

Where it may be

damaged by

chemicals

If there is a risk

of water falling on

the unit

Where there is a risk

of interference by

foreign objects

This product is not

made for DIY repair

Model no. BAR20-AU

Colour/Finish Black

Heat Output

2kW

Heat Settings

Thermostat Control Y

Remote Control Y

Warranty 2 years

Dimensions (w x d x h) 440 x 315 x 550

Specifications

For greater precision, please always refer to the rating label placed on the product.

Operation

WARNING: FALLING OR TIPPING APPLIANCES CAN CAUSE INJURY OR DEATH

OF YOUNG CHILDREN, PLEASE ENSURE CHILDREN DO NOT CLIMB, HANG OR

STAND ON THIS PRODUCT.

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance automatically in the event

of a fault. If this occurs switch off the appliance or disconnect the mains plug from

the socket. After a short cooling down phase, the appliance is ready for use again.

If the fault should occur again, see your local dealer.

WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal

cut-out, this appliance must not be supplied through an external switching device,

such as a timer, or connected to a circuit that is regularly switched on and off by

the utility.

Setup & Product Dimensions

General

Unpack the heater carefully and retain the packaging for possible future use, in the

event of moving or returning the fire to your supplier.

These models are designed to be free standing and are normally positioned against

a wall.

The fire incorporates a flame effect, which can be used with or without heating, so that

the comforting effect may be enjoyed at any time of the year. Using the flame effect on

its own only requires little electricity. A choice of 1kW or 2kW heat output is provided

by the fan heater, which is located at the bottom of the unit.

Before connecting the heater check that the supply voltage is the same as that stated

on the heater.

Please note: Used in an environment where background noise is very low, it may be

possible to hear a sound which is related to the operation of the flame effect. This is

normal and should not be a cause for concern.

CAUTION: Except for installation and cleaning described in this manual, an

authorized service representative should perform any other servicing.

WARNING – THIS APPLIANCE MUST BE EARTHED

This heater must be used on an AC ~ supply only and the voltage marked on the heater

must correspond to the supply voltage.

Before switching on, please read the safety warnings and operating instructions.

Light Emitting Diode

This fire is fitted with LED (Light Emitting Diode) bulbs in place of traditional

incandescent bulbs. These generate the same light levels as traditional bulbs, but use

a fraction of the energy consumed. These LED lamps are maintenance free and should

not require replacing during the life of the product.

Operation

Controls

The switches provide a choice of heat settings, The appliance is in standby mode

when the mains lead is plugged in. This is indicated by the red neon behind the flame

effect screen. The two selector switches are in the ON position when the side with

the markings on (i.e. I, or II) is pushed

1. Selector switch 1 (I) - Controls the electricity supply to the appliance and flame

effect. Press for ‘ON' & ‘Standby’. If both selector switches 2 and 3 are in the

OFF position, the product works on flame effect only.

2. Selector Switch 2 (I) - Provides 1kW heat output.

3. Selector Switch 3 (II) - Provides 2kW output with switch 2 also pressed.

Thermostat (T)

In order to maintain a certain room temperature, set the controller to ‘max.’. Operate

the appliance at full power until the required room temperature is reached. Set back

the thermostatic controller until the appliance switches off with an audible “click”.

This temperature will be kept almost constant by the thermostatic control switching

on and off automatically. Please note that the appliance can only be switched on

when the thermostat setting is higher then the room temperature.

123

Over time, dust can accumulate which can effect performance. It is recommended to

clean the unit at least once a month.

CAUTION: ALWAYS Turn the unit OFF and disconnect the appliance from the power

supply before undergoing any cleaning and maintenance.

For general cleaning use a soft clean duster – never use abrasive cleaners. The glass

viewing screen should be cleaned carefully with a soft cloth.

DO NOT use proprietary glass cleaners.

To remove any accumulation of dust or fluff the soft brush attachment of a vacuum

cleaner should occasionally be used to clean the outlet grille of the fan heater.

WARNING: do not operate the product without the grille and outer glass in position

as this may effect the operation of the heater.

IMPORTANT

The control panel and other parts must not come into contact with water or any

other liquids.

Cleaning

Recycling: Do not dispose of electrical appliances as unsorted municipal

waste. Use separate collection facilities. Contact your local government

for information regarding the collection systems available. If electrical

appliances are disposed of in landfills or dumps, hazardous substances

can leak into the ground water, polluting the food chain and damaging

health and well-being.

Warranty

Please refer to the warranty card in the box for warranty information. For any

troubleshooting advice, please contact the relative Customer Care Centre below.

Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd

8 Lakeview Drive, 38 Harris Road, East Tamaki,

Scoresby 3179, Victoria Auckland 2013

Australia New Zealand

Ph: 1300 556 816 Ph: 0800 666 2824

Other manuals for BAR20-AU

Table of contents

Other Dimplex Indoor Fireplace manuals

Dimplex

Dimplex DWF1203 User manual

Dimplex

Dimplex DF3003 User manual

Dimplex

Dimplex TANGO TNG20 User manual

Dimplex

Dimplex FABER ALBANY ECO ABN15 ECO User manual

Dimplex

Dimplex ORVIETO MCFP15O User manual

Dimplex

Dimplex DLW1500B12 User manual

Dimplex

Dimplex BF8000ST User manual

Dimplex

Dimplex DWF120330B User manual

Dimplex

Dimplex EF3003 User manual

Dimplex

Dimplex BF33STP/DXP User manual

Dimplex

Dimplex DFOP25 User manual

Dimplex

Dimplex CAS1000M User manual

Dimplex

Dimplex Barletta User manual

Dimplex

Dimplex DCF7850 User manual

Dimplex

Dimplex DF2608-EU User manual

Dimplex

Dimplex MULTIFIRE DF3215 User manual

Dimplex

Dimplex Opti-myst User manual

Dimplex

Dimplex Siena Fire SNA20 User manual

Dimplex

Dimplex PF2325 User manual

Dimplex

Dimplex DCF7850 User manual

Dimplex

Dimplex PF2325 User manual

Dimplex

Dimplex BFSL33 User manual

Dimplex

Dimplex OPTIMYST CAS400L Technical manual

Dimplex

Dimplex BF392SD User manual

Popular Indoor Fireplace manuals by other brands

Brigantia

Brigantia 35-DVRS31N-2 User's installation, operation and maintenance manual

Nordpeis

Nordpeis Bergen Installation and user manual

Superior

Superior BCT2536TMN Installation and operation instructions

Quadra-Fire

Quadra-Fire 5100I-GD-B owner's manual

Renaissance

Renaissance RUMFORD 1000 user manual

Lacunza

Lacunza IV-800 Instruction book

Baxi

Baxi 940 Installer and owner guide

Dru

Dru Maestro 60/2 Tall RCH installation manual

Diamond Fireglass

Diamond Fireglass SS-O22 General assembly, installation, and operation instructions

HearthStone

HearthStone Windsor Bay 8830 Owner's manual and installation guide

Napoleon

Napoleon ASCENT B42 quick start guide

Enviro

Enviro E33GI owner's manual

Smeg

Smeg L30 FABE Installation & user's instructions

KEDDY

KEDDY K700 Installation instructions care and firing instructions

Godin

Godin 3451 manual

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Installation and operation instructions

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 operating manual

Desa

Desa CCFPDFT Owner's operating & installation manual