Dell DX6004S User manual
Dell DX6004S Systems
Getting Started With Your
System
Mise en route du système
Introdução ao Uso do Sistema
Introducción al sistema
Dell DX6004S Systems
Getting Started With Your
System
Regulatory Model: E02S Series
Regulatory Type: E02S001
Notes, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use of
your computer.
CAUTION: A CAUTION indicates potential damage to hardware or loss of data if
instructions are not followed.
WARNING: A WARNING indicates a potential for property damage,
personal injury, or death.
____________________
Information in this publication is subject to change without notice.
© 2010 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.
is strictly forbidden.
Trademarks used in this text: Dell™, the DELL logo, and PowerVault™ are trademarks of Dell Inc.,
Intel®and Xeon®are registered trademarks of Intel Corporation in the U.S. and other countries.
Other trademarks and trade names may be used in this publication to refer to either the entities claiming
the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and
trade names other than its own.
Regulatory Model: E02S Series
Regulatory Type: E02S001
August 2010 P/N 9V097 Rev. A00
Getting Started With Your System 3
Installation and Configuration
WARNING: Before performing the following procedure, review the safety
instructions that came with the system.
Unpacking the System
Unpack your system and identify each item.
Installing the Rails and System in a Rack
Assemble the rails and install the system in the rack following the safety
instructions and the rack installation instructions provided with your system.
4Getting Started With Your System
Connecting the Power Cable(s)
Connect the system’s power cable(s) to the system.
Securing the Power Cables
Bend the system power cables into a loop as shown in the illustration and
secure the cables to the brackets using the provided strap. Plug the other end
of the power cables into a grounded electrical outlet or a separate
power source such as an uninterrupted power supply (UPS) or
a power distribution unit (PDU).
Getting Started With Your System 5
Turning On the System
Press the power button on the system. The power indicators should light.
Installing the Optional Bezel
Install the bezel (optional).
6Getting Started With Your System
Other Information You May Need
WARNING: See the safety and regulatory information that shipped with
your system. Warranty information may be included within this document or
as a separate document.
• The rack documentation included with your rack solution describes how to
install your system into a rack.
•The
Hardware Owner’s Manual
provides information about system
features and describes how to troubleshoot the system and install or
replace system components. This document is available online at
support.dell.com/manuals
.
• Any media that ships with your system that provides documentation
and tools for configuring and managing your system, including those
pertaining to the operating system, system management software,
system updates, and system components that you purchased
with your system.
NOTE: Always check for updates on support.dell.com/manuals and read the
updates first because they often supersede information in other documents.
Obtaining Technical Assistance
If you do not understand a procedure in this guide or if the system does not
perform as expected, see your Hardware Owner’s Manual. Dell offers
comprehensive hardware training and certification. See www.dell.com/training
for more information. This service may not be offered in all locations.
Getting Started With Your System 7
NOM Information (Mexico Only)
The following information is provided on the device described in this
document in compliance with the requirements of the official Mexican
standards (NOM):
Technical Specifications
Importer:
Model number: E07S
Supply voltage: 100–240 V CA
Frequency: 50/60 Hz
Current consumption: 5.2–2.6 A
Processor
Processor type Intel Xeon processor 3400 series
Expansion Bus
Bus type PCI Express Generation 2
Expansion slots One x16 half-length slot
One x8 half-length slot
NOTE: Both the slots support x8 routing.
Memory
Architecture 1066 MHz and 1333 MHz registered parity and
non registered DDR-III memory modules
Memory module sockets Six 240-pin
Memory module capacities 1 GB, 2 GB, 4 GB, and 8 GB (RDIMMs only)
Minimum RAM 1 GB
Maximum RAM 32 GB
8Getting Started With Your System
Drives
Hard drives Up to four 3.5" hot-swappable SAS or
SATA drives
Optical drive One optional internal slimline SATA
DVD-ROM or DVD+/-RW drive
NOTE: DVD devices are data only.
Optional external USB DVD-ROM
Connectors
Back
NIC
Two RJ-45 (for integrated 1-GB NICs)
Serial
9-pin, DTE, 16550-compatible
USB
Two 4-pin, USB 2.0-compliant
Video
15-pin VGA
Front
Video
15-pin VGA
USB
Two 4-pin, USB 2.0-compliant
Internal
USB
Two 4-pin, USB 2.0-compliant
Video
Video type Matrox G200, integrated in BMC
Video memory 8 MB graphics memory
Power
AC power supply (per power supply)
Wattage
350 W (non-redundant power supply)
400 W (redundant power supply)
Voltage
100–240 VAC, 50/60 Hz
Other manuals for DX6004S
1
Table of contents
Languages:
Other Dell Server manuals
Dell
Dell PowerEdge T710 Instruction Manual
Dell
Dell DR6300 User manual
Dell
Dell PowerApp 220 User manual
Dell
Dell PowerEdge R750xa Manual
Dell
Dell PowerEdge T605 User manual
Dell
Dell PowerEdge R810 User manual
Dell
Dell PowerEdge R210 User manual
Dell
Dell PowerEdge FC830 User manual
Dell
Dell EMC XC Core XC650 Manual
Dell
Dell PowerEdge SC1435 User manual
Dell
Dell PowerEdge PDU Managed LED User manual
Dell
Dell POWEREDGE E11S User manual
Dell
Dell DR4000 Restore Manager Service manual
Dell
Dell PowerEdge R210 II Quick start guide
Dell
Dell PowerEdge C6100 User manual
Dell
Dell Poweredge metered User manual
Dell
Dell PowerEdge C5125 User manual
Dell
Dell EMC PowerEdge T340 Manual
Dell
Dell PowerEdge R220 Quick start guide
Dell
Dell W4X15 User manual
