CYP CH-507TXWPBD User manual

CH-507TXWPBD & RXWPBD

HDMI over Single CAT5e/CAT6

Operation Manual

DISCLAIMERS

The information in this manual has been carefully checked and

is believed to be accurate. Cypress Technology assumes no

responsibility for any infringements of patents or other rights of third

parties which may result from its use.

Cypress Technology assumes no responsibility for any inaccuracies

that may be contained in this document. Cypress also makes no

commitment to update or to keep current the information contained

in this document.

Cypress Technology reserves the right to make improvements to this

document and/or product at any time and without notice.

No part of this document may be reproduced, transmitted,

transcribed, stored in a retrieval system, or any of its part translated

into any language or computer le, in any form or by any means—

electronic, mechanical, magnetic, optical, chemical, manual, or

otherwise—without express written permission and consent from

Cypress Technology.

TRADEMARK ACKNOWLEDGMENTS

All products or service names mentioned in this document may be

trademarks of the companies with which they are associated.

SAFETY PRECAUTIONS

Please read all instructions before attempting to unpack, install or

operate this equipment and before connecting the power supply.

Please keep the following in mind as you unpack and install this

equipment:

• Always follow basic safety precautions to reduce the risk of re,

electrical shock and injury to persons.

• To prevent re or shock hazard, do not expose the unit to rain,

moisture or install this product near water.

• Never spill liquid of any kind on or into this product.

• Never push an object of any kind into this product through any

openings or empty slots in the unit, as you may damage parts

inside the unit.

• Do not attach the power supply cabling to building surfaces.

• Use only the supplied power supply unit (PSU). Do not use the PSU

if it is damaged.

• Do not allow anything to rest on the power cabling or allow any

weight to be placed upon it or any person walk on it.

• To protect the unit from overheating, do not block any vents or

openings in the unit housing that provide ventilation and allow for

sufcient space for air to circulate around the unit.

REVISION HISTORY

VERSION NO. DATE DD/MM/YY SUMMARY OF CHANGE

RDV1 25/04/13 Preliminary Release

RDV2 25/07/19 Update Format and Cable

Distance

CONTENTS

1. Introduction............................................ 1

2. Applications........................................... 1

3. Package Contents ................................ 1

4. System Requirements............................ 1

5. Features.................................................. 2

6. Operation Controls and Functions....... 3

6.1 Transmitter.........................................3

6.2 Receiver ............................................4

7. D-Sub 9 Pin Denitions........................... 5

8. Connection Diagram ............................ 6

Option 1: Point to Point..........................6

Option 2: Matrix System.........................7

9. Specications ........................................ 8

9.1 Cable Specications .......................9

10. Acronyms ........................................... 10

1. INTRODUCTION

The HDMI over single CAT5e/6/7 wall-plate transmitter and receiver

setcan transmit and receive uncompressed audio/video over a single

run of CAT5e/6/7 cable up to 100m/328ft at 1080p and 70m/229ft at

4K with bi-directional PoC & IR functions,LAN of a data transmission

rate of 100Mbps & RS-232 features. A true HDBaseT 5Play solution to

make your home or ofce more efcient and easy with control.

2. APPLICATIONS

• Household entertainment sharing and control

• Lecture room display and control

• Showroom display and control

• Meeting room presentation and control

• Classroom display and control

3. PACKAGE CONTENTS

• HDMI over Single CAT5e/CAT6 Transmitter x 1

• HDMI over Single CAT5e/CAT6 Receiver x 1

• IR Blaster x 1

• IR Receiver x 1

• 24V DC Power Adaptor x 1

• Operation Manual

4. SYSTEM REQUIREMENTS

Input HDMI source equipment such as DVD/Blu-ray player and

HDMIequipped output display (TV or monitor)with HDMI input jack.

5. FEATURES

• HDMI 1.x and DVI 1.0 compliant

• HDCP compliant

• Supports HDMI 3D and 4K x 2K features

• Supports HDCP repeater and CEC bypass

• Supports distance up to 100m/328ft at 1080p and 70m/229ft at 4K

through CAT5e/6/7 cable

• HDMI input resolutions up to 4K@60Hz (YUV 4:2:0, 8-bit) or 4K@30Hz

( YUV 4:4:4, 8-bit)

• Supports pass-through of audio formats including LPCM 2.0/5.1/7.1,

and Bitstream over HDMI

• 5Play™ convergence: HDMI, bi-directional PoC, (bi-directional IR &

RS232) & LAN

• Wall plate design and Installation Friendly

Note: This system was tested with CAT6/23AWG and CAT5e/24AWG

cable, so if using cables of another type, results may vary.

In order to send and receive HDMI contain of 4k x 2k,

equivalencesource, display and HDMI cable specication is required

to ensureproper output.

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter

HDMI INLAN

POWER

LINK

IR 2

EXTENDER

IR 1

BLASTER

DC 24V

RS-232

1 2

3 4 5 6 7 8

1IR 2 EXTENDER: This slot is to connect with the IR receiver cable

included in the package for IR signal receiving.

2DC 24V: Connect the power adaptor included in the package

and then connect to AC power to activate the device.

3IR 1 BLASTER: This slot is to connect with the IR blaster cable

included in the package for IR signal transmitting.

4RS-232 IN: This slot is to connect with D-Sub 9-pin cable from

PC/loptop device RS-232 commands sending.

5LAN: Connect to an active network for LAN serving and Telnet/

Web GUI control.

When the transmitter or any compatible LAN equipped receivers

are connected to a network, this allows the network access

(including internet access if available) to be shared between the

transmitter and all connected receivers. Connect any Ethernet

equipped device e.g. a Smart TV or games console to the LAN

port of a receiver for that device to share the network/internet

access.

6HDMI IN: This slot is to connect with HDMI source equipment such

as DVD/Blu-ray player with HDMI source signal.

7Power LED: This LED will illuminate when the device is connected to

a power supply.

8LINK LED: This LED will illuminate when the both CAT5e/6/7 input

and output signal is connected.

6.2 Receiver

HDMI OUTLAN

POWER

LINK

IR 1

EXTENDER

IR 2

BLASTER

DC 24V

RS-232

OUT

1 2

3 4 5 6 7 8

1IR 1 EXTENDER: This slot is to connect with the IR receiver cable

included in the package for IR signal receiving.

2DC 24V: Connect the power adaptor included in the package

and then connect to AC power to activate the device.

3IR 2 BLASTER: This slot is to connect with the IR blaster cable

included in the package for IR signal transmitting.

4RS-232 OUT: This slot is to connect with D-Sub 9-pin cable from

device equipment for receiving RS-232 commands.

5LAN: Connect to an active network for LAN serving and Telnet/

Web GUI control.

When the transmitter or any compatible LAN equipped receivers

are connected to a network, this allows the network access

(including internet access if available) to be shared between the

transmitter and all connected receivers. Connect any Ethernet

equipped device e.g. a Smart TV or games console to the LAN

port of a receiver for that device to share the network/internet

access.

6HDMI OUT: This slot is to connect with HDMI TV/monitor for display

HDMI input source signal.

7Power LED: This LED will illuminate when the device is connected to

a power supply.

8LINK LED: This LED will illuminate when the both CAT5e/6/7

input and output signal is connected.

7. D-SUB 9 PIN DEFINITIONS

Pin Dene TX/RX

1 N/C

2TxD/RxD

3RxD/TxD

4 N/C

5 GND

6 N/C

7 N/C

8 N/C

9 N/C

This manual suits for next models

Table of contents

Popular Receiver manuals by other brands

Garmin

Garmin GA 23 Owner's manual and reference guide

Aiphone

Aiphone PS-12F instructions

IMES

IMES TCS-01CA-PMI Original Operating Instruction

BWI Eagle

BWI Eagle AIR-EAGLE SR Product information bulletin

AMIMON

AMIMON AMN12310 WHDI datasheet

Dual

Dual DMCPA79BT Installation & owner's manual

Sound Associates

Sound Associates SA652P Operation manual

Sherwood

Sherwood NewCastle R-772 Service manual

Audio

Audio A10-RX Series user guide

AllSee

AllSee PushShare PSRV1.1 user manual

DEMAG

DEMAG DRC-DR D2 operating instructions

Teleco

Teleco TVRCL868A02 manual

Bosch

Bosch RF3222E installation instructions

Kramer

Kramer 631R user manual

Xpress

Xpress xmc10 installation guide

JVC

JVC KD-MR1BTS instruction manual

Omega Engineering

Omega Engineering UWTC-REC3 user guide

e-survey

e-survey E300 Pro user manual