Cooper Lighting BCHE User manual

WARNING: If the lens has a Factory-applied trim color,these solvents will also remove this paint.

Replacement of the entire lens is recommended in this case.

1961.0817.1274

CHARLESTON GRAPHICS, INC.

BC, BW,BWVE, BCVE,

BCHE, BWHE, SERIES LUMINAIRES

INCANDESCENT AND COMPACT

FLUORESCENT

6/93 IMI-313

INSTALLATION INSTRUCTIONS

IMPORTANT:Read carefully before installing fixture.

Retain for future reference.

General: Upon receipt of fixture thoroughly inspect for

any freight damage, which should be brought to the

attention of the delivering carrier. Compare the catalog

description listed on the packing slip with the fixture

label on the housing to assure you have received the

correct merchandise.

Safety: This fixture must be wired in accordance with

the National Electrical Code and applicable local codes

and ordinances. Proper grounding is required to insure

personal safety. Carefully observe grounding procedure

under installation section. All work should be done by a

qualified electrician.

WARNING: Make certain power is OFF before starting installation or attempting any maintenance.

CLEANING: The reflector and lens may be cleaned with any non-abrasive cloth

and mild detergent (i.e. 409 Cleaner). Cleaning should be done on the lens at room

temperature, and out of direct sunlight. To remove paint, lipstick, marker, etc., the

following solvents may be used:

RECOMMENDED: a solution of three (3) parts alcohol, one (1) part TOLUOL.

OR: four (4) parts alcohol, one part Methylethylketone (MEK).

Also safe, but less effective: Naphtha, Butyl Cellosolve, Kerosene.

NEVER USE: Gasoline,Benzene,Acetone,Carbon Tetrachloride or highly

alkaline cleaners. Never clean Luminaire while energized, or while lens is

hot.

1. Remove lens, using a torx screwdriver (for screws with center-pin).

2. Remove the four 5/10” knock-outs.

3. Determine correct fasteners to use for the mounting surface. Fasteners should be 1/4” normal.

4. The mounting gasket may be used as a template to lay out the fastener locations.

5. Make wiring connections.

Place two of the mounting screws through the mounting plate, and position the mounting gasket into position

on the back (wall-side) of the plate.

7. Position mounting plate on wall in one of the “UP” orientations, according to the embossed arrows on the

mounting plate. Check position of internal reflector, if equipped (see Note).

8. Start mounting fasteners but do not tighten.

9. Check the gasket position. At least 1

/4of gasket should extend beyond the mounting plate, all the way around.

10. Tighten all four mounting fasteners.

11. Install lamp. Screw base lamps should be tightened, then loosened one to two turns, then re-tightened. This

will properly seat the lamp for best mechanical and electrical connection.

12. Replace lens, tighten screws.

NOTE: For optional Internal Reflectors

If the fixture has a reflector attached to the mounting plate, it should be positioned above the lamp. If the lens

has a portion “Painted Out” to form an “Eyelid”, this portion should be positioned toward the ceiling, and over

the internal reflector.

These instructions do not claim to cover all details or variations in the equipment, procedure, or process

described, nor to provide directions for meeting every possible contingency during installation, operation or

maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s

purpose, please contact your nearest representative.

1961.0817.1274

CHARLESTON GRAPHICS, INC.

Photoelectric Control

A Photoelectric Control may be added by first obtaining the following accessories from your Cooper Lighting

Distributor:

Surface Conduit Box CAT#SCB

“Photocell Kit” CAT#PB-120V OR #PB-277V

Follow the instructions provided with the kit, installing the photocell in an unused conduit entry location which

positioned the Photocell in a horizontal orientation.

This manual suits for next models

Table of contents

Other Cooper Lighting Light Fixture manuals

Cooper Lighting

Cooper Lighting Metalux UT Series User manual

Cooper Lighting

Cooper Lighting Halo L741 User manual

Cooper Lighting

Cooper Lighting COMBOLIGHT Recessed Single-Lamp Fixture User manual

Cooper Lighting

Cooper Lighting Downlight Metal Halide ED17P User manual

Cooper Lighting

Cooper Lighting Halo L1763 User manual

Cooper Lighting

Cooper Lighting COMBOLIGHT LV3060IS User manual

Cooper Lighting

Cooper Lighting METALUX SM-ASY User manual

Cooper Lighting

Cooper Lighting Quiet Ceiling Trimless QCT901 User manual

Cooper Lighting

Cooper Lighting Combolight Quantum Series PAR30MH 39W PT User manual

Cooper Lighting

Cooper Lighting Neo-Ray Omni 66-DIP User manual

Cooper Lighting

Cooper Lighting HALO H2570 User manual

Cooper Lighting

Cooper Lighting Halo Cascade I H2574 User manual

Cooper Lighting

Cooper Lighting Metalux WB SERIES User manual

Cooper Lighting

Cooper Lighting Neo-Ray 201-IW User manual

Cooper Lighting

Cooper Lighting 79PF Series User manual

Cooper Lighting

Cooper Lighting Cirque 6-ADW User manual

Cooper Lighting

Cooper Lighting Combolight Trimless V90229-1N User manual

Cooper Lighting

Cooper Lighting T4 E11 User manual

Cooper Lighting

Cooper Lighting all-pro mst27920les User manual

Cooper Lighting

Cooper Lighting G Series User manual

Cooper Lighting

Cooper Lighting SURE-LITES EUS Series User manual

Cooper Lighting

Cooper Lighting Neo-Ray 93-DIP User manual

Cooper Lighting

Cooper Lighting Halo L761 User manual

Cooper Lighting

Cooper Lighting Combolight MLU Series MLU212 User manual

Popular Light Fixture manuals by other brands

Emos

Emos CLASSIC ZY1431T manual

Westinghouse

Westinghouse Outdoor Lighting Fixture owner's manual

Hedler

Hedler C 12 silent Operation manual

Blizzard Lighting

Blizzard Lighting Puck: CSI manual 

Energetic Lighting

Energetic Lighting ELYSL-5004 Series installation instructions

Lightmaxx

Lightmaxx Shaft 5R user manual

Triarch

Triarch 31083 Assembly instructions

Philips

Philips 32614 Series user manual

IKEA

IKEA TIVED Assembly instructions

Lightolier

Lightolier LP200 specification

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH user manual

Martin

Martin MAC 250 Krypton user manual

Stageline

Stageline ODW-2410RGBW instruction manual

Light Sky

Light Sky Tornado Series user manual

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U specification

Lightolier

Lightolier Lytespan 83ED17S specification

Lightolier

Lightolier Calculite CS8226 specification

ArtFox

ArtFox Beam 15R extreme manual