Ref: TR800-433B2 20160922.docx Bosch Compatible 433MHz Alarm Panel Receiver
PCB: Rev 1.0, S/W: Ver 1.14 Page 1
1.0 Receiver Installation
1. Allow minimum 1m between alarm panel and TR800-433B2.
2. Install the supplied antennas to terminals ANT1 and ANT2
2.0 Connection to Bosch panels
Figure 1
1. Connect the receiver as per the panel type in Figure 1.
2. Position the receiver at least 1m from panel.
3. Set DIP Switch 2 for the panel type.
4. Enable the receiver in alarm programming (except CC488).
Figure 2
Learning fobs to on-board relays.
Learning keyfobs to on-board relays is not required for
alarm operation and has no effect on it.
1. Press the LEARN SW (see Figure 2) until the LED
goes off (approx 1 sec) and Release.
LED should be off.
2. Select the relay to be programmed by pressing the
LEARN SW once for each output.
E.g: Press twice for Relay 2.
Led flashes each time the button is pressed.
3. Having selected the relay, press the desired button
on the Keyfob to be learned to the relay.
4. Repeat for each button required.
5. Relay's pulse by default. Set DIP Switch 3 ON for
latching control.
NOTE: -
A maximum of 12 Keyfob’s per receiver.
The TR800 will exit learn mode after 25 secs or
Keyfob is successfully learned
4.0 Deleting Keyfobs
To Delete all Keyfobs push and hold the LEARN SW for
20 secs. You will see the following: -
1. After 5 secs, LED does a double flash
2. After 15 secs, LED does a quick angry flash to warn
that deleting data is imminent
3. After 20secs, LED is on solid and all keyfobs have
been deleted
4. Release LEARN SW
5.0 Wireless Devices
All wireless devices must be learned into the
Bosch Alarm as per the relevant installation
manual. Only panels that support wireless zones
can have wireless zones added, such as Solution
Ultima.
6.0 Install Mode
To enter Install Mode press LEARN SW and hold for 5
secs until LED double flashes. Install reduces the
sensitivity of the TR800 for testing wireless devices,
ensuring better performance after install.
Exit Install Mode, press the LEARN SW button
Cat: TR800-433B2
Radio Receiver for use with BOSCH 433MHz Intruder Alarms
