Chamberlain TRICODE TCG2 User manual

TRICODE® TCG2 DUAL

CHANNEL RECEIVER

USED FOR TCG1 AND TCG2

The TriCode®digital receivers are designed for use with automatic

garage/gate operators and access control systems. All TriCode®

products may be matched with Linear/Delta-3TM, Multi-CodeTM and

StanleyTM radio products which may already be installed.

The TriCode®radio format provides a potential of 1024 different

digital codes. For Linear/Delta-3TM compatible products 256

different digital codes are available. The codes are set using a

10-position DIP switch system.

U.S. Patent 6,915,146

SPECIFICATIONS

Output Rating: 5 Amps 28Vac/Vdc Max.

Power: 12Vdc or 18 to 34Vac/Vdc, @ 30ma

RF Frequency: 300 or 310 MHz

Accessory Transmitters: TC1, TC2 and TC4

Antenna Extension Kit: TCEXT

NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of

this receiver and/or transmitter are prohibited, except for changing the code setting or replacing

the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.

To prevent possible SERIOUS INJURY or DEATH from electrocution:

• Be sure power is NOT connected BEFORE installing the receiver.

To prevent possible SERIOUS INJURY or DEATH from a moving

gate or garage door:

• ALWAYS keep transmitters out of reach of children. NEVER permit

children to operate or play with remote control transmitters.

• Activate gate or door ONLY when it can be seen clearly, is properly

adjusted, and there are no obstructions to door travel.

• ALWAYS keep gate or garage door in sight until completely closed.

NEVER permit anyone to cross path of moving gate or door.

WARNING

CAUTION WARNING

WARNING

POWER & OUTPUT RELAY SWITCH SETTINGS

24V AC/DC CH1 N/O CH2 N/O

12V 24V

CH1

MODE

CST MNT CH2

MODE

CST MNT

RELAY

CH1-MODE

RELAY

CH2-MODE

JUMPER

(P3)

Mounting Holes

LINEAR

MULTI

STAN

12V 24V

CST MNT CST MNT

CH1

MODE

CH2

MODE

123 456 78 910

Figure 1

Power Supply Selection Setting

The TriCode®receiver is factory set for 24 volt power input if

12 volt is required.

Remove front cover of receiver by turning screws

counterclockwise a 1/4 of a turn until each releases. Set jumper

(P3) to either 12 or 24 volt setting depending on your power

input (Figure 1).

Setting Output Relay Mode

The TriCode®receiver is factory set for momentary relay output

“MNT”.

• Momentary mode: The output relay will be on for .5 seconds

before turning off.

• Constant pressure mode: Output relay is continuously on

while receiving matching/valid ID code from transmitter. The

output relay will turn off immediately once receiver does not

receive a matching/valid ID code from the transmitter.

If constant pressure mode is desired, move mode jumper

from “MNT” to “CST” (Figure 1).

NOTE: The relay output is an isolated normally open contact.

NOTE: To avoid the possibility of duplicating codes in adjacent

systems, all transmitters and receivers should be re-coded prior

to operation. Unless using maximum number of codes the

following four codes should not be used:

· All DIP Switches ON

· All DIP Switches OFF

· DIP Switches alternating ON/OFF

· DIP Switches alternating OFF/ON

Receivers should be installed at least 5' apart to avoid cross-talk.

After completing installation, operate transmitter outside of

building to make certain the chosen DIP switch setting does not

operate with nearby garage door operators and/or security

systems. If so, select another DIP switch setting and check the

coded signal again. Repeat as necessary.

RECEIVER MOUNTING

Mount receiver to wall using #6 hardware (not provided).

Hardware used will depend on mounting application. Refer to

Figure 1 for receiver mounting hole locations.

ANTENNA MOUNTING

Screw on antenna clockwise and slide rubber boot down to meet

O-ring.

CONFIGURATION & DIP SWITCH SETTINGS

24Vac/Vdc CH1 N/O CH2 N/O

Delta-3/Linear

Multi-Code

Stanley

DIP

Switches

Configuration

Switch

Channel 2 DIP Switch

Channel 1 DIP Switch

LINEAR

MULTI

STAN

CH1

MODE

CH2

MODE

12V 24V

CST MNT CST MNT

12345678910

1234 5 6 78910

Figure 4

Figure 2

Multi/ Stanley

(1 Thru 10)

Linear/ Delta-3

(1 Thru 8)

1 2 3 4 5 6 7 8 9 10

DIP

Switch

Delta-3/ Linear

Multi-Code

Stanley

310 MHz

300 MHz

310 MHz

Configuration

Switch

Setting DIP Switch

The TriCode®receiver DIP switch CH1 is factory set OFF (1-10)

and CH2 is factory set ON (1-10).

Locate the 10 position DIP Switch. If this is a new installation

using TriCode®transmitters, randomly set switches matching

those of the transmitters. Never use factory setting. If receiver is

used with Linear/Delta-3TM, Multi-CodeTM or StanleyTM transmitters,

match the receiver DIP Switch to the above transmitters. Some

transmitters may use toggle switches and it may be difficult to

determine ‘ON’ and ‘OFF’. If so, try reversing the setting on the

TriCode®DIP Switch (Figures 3 and 4).

NOTE: In 'LINEAR/DELTA-3TM' mode (8-bits system) the last 2

bits (DIP #9 & 10) settings are ignored. They can be left in either

‘ON’ or ‘OFF’ settings.

Setting the Configuration Switch

The TriCode®receiver is factory set for Linear/Delta-3TM.

Locate the configuration switch and set it to the desired RF mode

of operation (Figures 2 and 4). Modes are as follows:

Linear/Delta-3TM: works with all “Linear/Delta-3TM” transmitters

transmitted at 310 MHz using 8-bits ID system.

MultiTM: works with all “Multi-CodeTM” transmitters transmitted at

300 MHz using 10-bits ID system.

StanleyTM: works with all “StanleyTM radio” transmitters

transmitted at 310 MHz using 10-bits ID system.

Figure 3

Power Supply Connections

A prewired gasket pigtail is included for your convenience (see Figure 5 for outgoing wires).

NOTE: For internal wire connections refer to Figure 6.

24V AC/DC CH1 N/O CH2 N/O

Red

Black

White/Green Stripe

White/Yellow Stripe

Blue/Brown Stripe

Blue/Orange Stripe

LINEAR

MULTI

STAN

12345678910

CST MNT

CH1

MODE

CST MNT CH2

MODE

12345678910

12V 24V

Figure 5

POWER CONNECTIONS

Red

Black

White/Green

White/Yellow

Blue/Brown

Blue/Orange

24V

AC/DC

Ch1

N/O

Ch2

N/O

Power

Supply

12V/24V

Figure 6

Table of contents

Other Chamberlain Receiver manuals

Chamberlain

Chamberlain LiftMaster Star250 User manual

Chamberlain

Chamberlain 45ACT Use and care manual

Chamberlain

Chamberlain 050DCTWFLK User manual

Chamberlain

Chamberlain LiftMaster Star250 User manual

Chamberlain

Chamberlain 365LM User manual

Chamberlain

Chamberlain TriCode TCR2 User manual

Chamberlain

Chamberlain 050DCTB Use and care manual

Chamberlain

Chamberlain 955CB User manual

Chamberlain

Chamberlain 850LMC User manual

Chamberlain

Chamberlain CHAMBERLAIN 635LM User manual

Chamberlain

Chamberlain LiftMaster 312HMC User manual

Chamberlain

Chamberlain LiftMaster Professional CPWR3 User manual

Chamberlain

Chamberlain LiftMaster Professional 365LM User manual

Chamberlain

Chamberlain 1025 User manual

Chamberlain

Chamberlain 050ACTWF User manual

Chamberlain

Chamberlain 8003EV User manual

Chamberlain

Chamberlain 860EV User manual

Chamberlain

Chamberlain LiftMaster 423LM User manual

Chamberlain

Chamberlain PPWR User manual

Chamberlain

Chamberlain STAR1000 User manual

Chamberlain

Chamberlain PPWR User manual

Chamberlain

Chamberlain 860LM User manual

Chamberlain

Chamberlain 955D User manual

Chamberlain

Chamberlain Star1000EV User manual

Popular Receiver manuals by other brands

Garmin

Garmin GA 23 Owner's manual and reference guide

Aiphone

Aiphone PS-12F instructions

IMES

IMES TCS-01CA-PMI Original Operating Instruction

BWI Eagle

BWI Eagle AIR-EAGLE SR Product information bulletin

AMIMON

AMIMON AMN12310 WHDI datasheet

Dual

Dual DMCPA79BT Installation & owner's manual

Sound Associates

Sound Associates SA652P Operation manual

Sherwood

Sherwood NewCastle R-772 Service manual

Audio

Audio A10-RX Series user guide

AllSee

AllSee PushShare PSRV1.1 user manual

DEMAG

DEMAG DRC-DR D2 operating instructions

Teleco

Teleco TVRCL868A02 manual

Bosch

Bosch RF3222E installation instructions

Kramer

Kramer 631R user manual

Xpress

Xpress xmc10 installation guide

JVC

JVC KD-MR1BTS instruction manual

Omega Engineering

Omega Engineering UWTC-REC3 user guide

e-survey

e-survey E300 Pro user manual