CDA HVG980 Quick start guide
www.cda.eu
HVG980
Five Burner Gas Hob
Installation, use and maintenance
2
Contents:
3 Important
5 Important Notes
6 Using Your Hob
7 Switching the appliance on (and operating the lock)
8 Igniting the burners
8 Ecient use of your hob
9 Care and maintenance
11 Troubleshooting
12 What to do if you smell gas
15 Mains Electricity Connection
16 Technical Information
17 Gas Supply Requirements
18 Ventilation
18 Natural Gas to LPG Conversion
19 LPG to Natural Gas Conversion
20 Fitting the hob
21 How to install the hob
22 Installation diagrams
23 Energy Eciency Information
3
Important
The CDA Group Ltd cannot be held responsible for injuries or
losses caused by incorrect use or installation of this product.
Please note that CDA reserve the right to invalidate the guarantee
supplied with this product following incorrect installation or misuse
of the appliance or use in a commercial environment.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have
had supervision or instructions on how to use the appliance by
someone who is responsible for their safety.
Under no circumstances should any external covers be removed
for servicing or maintenance except by suitably qualified
personnel.
Appliance information:
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault
with your appliance and to register your appliance for guarantee
purposes.
Appliance Model
Serial Number
4
EU Declarations of Conformity
This appliance has been manufactured to the strictest standards
and complies with all applicable legislation, including Electrical
safety (LVD) 2014/35/EU and Electromagnetic interference
compatibility (EMC) 2014/30/EU. Parts intended to come into
contact with food conform to 1935/2004/EC.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a
special local authority waste collection centre or to a dealer
providing appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both
energy and resources. As a reminder of the need to dispose of
household appliances separately, the product is marked with a
crossed-out wheeled dustbin.
5
Important Notes
Please note:
• Gas hobs become hot and remain hot during and immediately after
use. We strongly advise that you do not touch the hob, nor any of
its components, until it has been allowed to cool. If wiping away a
spillage, please take every care not to burn yourself.
• Keep children away from the appliance when in use.
• After use, ensure the control knobs are in the o position.
• Never use the hob top for storage.
• Pan handles should never stand out beyond the edge of the
worktop. This will help to ensure children cannot reach them.
• Ensure that the appliance is correctly adjusted for the type of gas
available before installation.
• The use of a gas appliance produces heat and humidity in the
room in which it is installed. Ensure that the room is well ventilated,
either by the use of natural ventilation outlets (e.g. windows) or an
externally ducted extractor.
• Do not lean over the hob when it is in use.
• Follow the cleaning instructions carefully.
• Ensure the base of any saucepan is clean and dry before placing it
on the hob.
• This hob (Class 3) has been designed for use only as a cooking
appliance. Any other use (e.g. heating rooms) should be
considered incorrect and therefore dangerous.
• The appliance is not intended to be operated by any means of an
external timer or separate remote-control system.
This appliance is class GB II2H3+
6
Using your hob
Burners
1. Medium burner 2.0kW
2. Large burner 3.0kW
3. Medium burner 2.0kW
4. Auxiliary burner 1.0kW
5. Ultra large burner 4.0kW
Control knobs
6. Front left
7. Back left
8. Central
9. Back right
10. Front right
Fig.1 6789
Fig.2
23
14
5
10
C
7
Gas burners
Gas flow to the burners is controlled by the control knobs (6, 7, 8, 9
and 10 in Fig. 1). There are 3 positions shown on the control panel
(Fig. 2). Turning the control knob to the positions shown below
achieves the following:
Closed (switches gas valve and burner o)
Maximum position (highest heat level) & ignition
position
Minimum position (lowest heat level)
When switching a burner on, the knobs should always be turned in
an anticlockwise (left) direction from the closed/o position.
Switching the appliance on
Upon first connection to the power supply, or after a power cut or
other interruption in the mains supply, the safety key lock function is
activated. Touching either sensor when the lock is active will cause
the display to flash.
Using the lock and switching the appliance on
•Touch and hold the key sensor on the control panel (C in Fig.
1) for approximately 6 seconds until the indicator next to the on/
o sensor illuminates. The burners are now ready to use.
•Touch and hold the on/o sensor on the control panel for
approximately 2 seconds to switch the hob on and o.
•Touch and hold the key sensor for approximately 6 seconds
to activate the lock when no burners are in use.
8
Igniting the gas burners
This hob’s burners are fitted with automatic reignition. In the event of
a burner being extinguished whilst running, the hob will relight said
burner.
To ignite the burners
Simply twist the desired burner’s control knob anticlockwise (left) to
the desired heat level position (anywhere between large and small
flame symbols). The automatic ignition should light the burner.
Please note:
•The ignition should not operate (clicking constantly) for more
than 15 seconds at a time. If it does, please switch the hob o
and try again. However, wait for one minute before attempting
to reignite the burner. If the burner does not ignite, repeat the
ignition process with the control knob at the minimum position.
•If a burner continues to not ignite, please follow the trouble-
shooting section on page 11.
Control panel indicators
The control panel has a cluster of indicators that serve as an
indication of which zones are active and also act as residual heat
indicators. After a burner has been used for a certain time, the red
indicator for that zone will stay lit for some time after use to alert the
user that the zone is still hot to the touch.
Ecient use of your hob
The hob is equipped with burners of dierent sizes, designed to
accommodate most sizes of pan. For best results, only use pans
9
with flat bottoms and choose an appropriate burner depending
on the size of the pan. The most ecient use of the hob is shown
below, where the pan and burner are correctly chosen.
•Use pan lids where possible to minimize the energy usage of
your appliance.
•Ensure that the pans do not overlap the edges of the pan
stands, nor cover the control panel.
The table below shows the sizes of pan that should be used with
each burner:
Care and maintenance
The hob has a glass and a stainless steel surface. Due to this you
should use a non-abrasive cleaner. Any abrasive cleaner (including
Cif) will scratch the surfaces and could erase the control panel
markings. Stainless steel can be eectively cleaned by simply using
a dilute solution of water and washing up liquid, and drying to a shine
with a clean cloth.
•Over time with use, the stainless steel surface may discolour;
this is normal and does not constitute a fault with this appliance.
Proprietary stainless steel cleaners are available.
Fig. 3
Auxiliary
Medium
Large
Ultra large
Burner Minimum Maximum
90mm
160mm
220mm
240mm
150mm
220mm
260mm
280mm
10
• The cast iron parts of hobs (pan stands and burner caps on this
model) are not suitable for cleaning in dishwashers. They should
be washed by hand and dried thoroughly with a clean, dry cloth.
•A glass cleaning guide is below:
Type of residue Clean with Cleaning advice
Light Cleaning sponge
and soft cloth
Wipe over the zone to be cleaned
with a sponge and hot water, and
then wipe o with a soft dry cloth.
Accumulated
baked-on stains/
dirt, sugar spills or
melted plastics
Cleaning sponge
or glass scraper
and soft cloth
Wipe over the zone to be cleaned
with a sponge and hot water, using a
ceramic scraper to remove any large
marks or stains and then wipe o
with a soft dry cloth.
Rings and hard
water residues
White vinegar and
soft cloth
Pour a small amount of warm white
vinegar onto the stain, leave it to
stand, and then wipe o with a soft
dry cloth.
Shiny metallic
streaks
Cleaning agent for
tempered glass
Use specialist tempered glass clean-
er (preferably one with silicone for its
protective properties)
9 fast frying steaks
IMPORTANT:
•Steam cleaners must not be used when cleaning this appliance.
•Ensure that all parts are correctly replaced after cleaning and
before attempting to use the hob.
•After removing the pan stands, ensure the rubber feet on the
undersides are in place and not contaminated with dirt/grit before
replacing the pan stands.
•If water enters the ignition candle area, this can cause them to
click constantly. This is not necessarily a fault. Switch the mains
power supply o and wait for the water to dry up.
Table of contents
Other CDA Hob manuals
CDA
CDA HCG501 Reference manual
CDA
CDA HN6112FR User manual
CDA
CDA INDUCTION HOB HVN61/81 Instructions for use
CDA
CDA hn9625 Reference manual
CDA
CDA HCN510 Reference manual
CDA
CDA HCG 731 Series Instructions for use
CDA
CDA HNG7410FR Quick start guide
CDA
CDA HN6412FR Quick start guide
CDA
CDA hn9610 Reference manual
CDA
CDA HN9850FR Installation and operating instructions
CDA
CDA HVG680 Installation and operating instructions
CDA
CDA GAS HOBS HCG301 Instructions for use
CDA
CDA HVN61 Reference manual
CDA
CDA hc7620 Reference manual
CDA
CDA HG3610BL Service manual
CDA
CDA HC9606FR Specification sheet
CDA
CDA CD 62 Operation instructions
CDA
CDA HG7501 Series Service manual
CDA
CDA MATRIX MHC101FR Reference manual
CDA
CDA HCC662 for Reference manual
