Candy CATL 7080 WKI User manual

FUZZY LOGIC CONTROL

FULLY AUTOMATIC WASHING MACHINE

Model: CATL 7080 WKI

CATL 7088 LVSI

INSTRUCTION MANUAL

-------------------------------------------

Please read instructions carefully before using

.IMPORTANT SAFEGUARDS………… 。。……………… … ..

1. This product belongs to Class I appliances. Please pay attention to electricity

safety when using: This machine uses a single-phase two-pole grounded power

outlet, the outlet must be reliably grounded, and the grounding terminal should not

be connected with gas pipelines, water pipes and other utilities.

2. If the washing machine is connected to the power supply via a socket board or a

portable power unit, the socket board or the portable power unit must be placed in

a place that is not wet and cannot be easily splashed by water.

3. Do not use a socket with other electrical appliances, do not use when the plug

and socket are loose.

4. If there is any dust on the mounting surface of the power plug and the insert,

carefully wipe it with a dry cloth.

5. When the washing machine is in normal use, the power cord plug should be

easily accessible by hand. When power is cut off, moved, unused or cleaned, be

sure to unplug the power plug and turn off the water tap. Note: Please do not plug

or unplug the power cord with wet hands.

6. Do not excessively bend, stretch, twist, strap, or overload the power cord.

7. The connection mode of this unit's power cord is Y connection. If the power cord

or power plug is damaged, it must be replaced by our special service point or

full-time personnel of our after-sales service department to avoid danger.

8. The washing machine cannot be installed in the bathroom and other wet places,

absolutely cannot use water to wash, do not put wet clothes on the control board

of the washing machine.

9. Please avoid direct sunlight to the washing machine, do not be near heat

sources such as heating.

10. Do not place the machine on a carpet. Do not place the machine with a drain

function on a place where there is no floor drain.

11. This product needs to be connected to water. New water pipes must be used

as much as possible. Old water pipes cannot be reused.

12. The machine applies water pressure 0.03MPa ~ 0.85MPa.

13. Make sure that the faucet and inlet pipe fittings are reliably installed and that

the inlet pipe fittings and the inlet pipe are securely plugged into place.

14. Do not put any hot, heavy items (such as pots with hot water, etc.) on the

washing machine.

15. Unattended children or physically handicapped persons must not use this

machine.

16. Never put kerosene, gasoline, banana water, alcohol or other flammable

substances or laundry with such substances in or near the laundry tub.

17. Do not wash waterproof clothing or easy-to-float clothing such as raincoats,

bicycle covers, down products, elastic cotton products, etc. to avoid abnormal

vibration or damage to clothing during washing or dehydration.

18. Do not open the door cover when the washing machine is in the process of

dehydration.

19. When the washing machine is working, do not put your hand into the drum of

the washing machine in operation. Even if the rotation speed is very slow, it is

dangerous. Take special care not to let children climb the washing machine to

avoid danger.

20. Never disassemble, repair, or modify this unit by yourself.

21. User manual must have such below warning.

a). This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning use

of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the

appliance.

b). If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

c). The new hose-sets supplied with the appliance are to be used and that old

hose-sets should not be reused.

PARTSDESCRIPTIONANDLOADINGLIST

1、Parts description

1.Toplid 9.Housing

2.Washingpowderbox 10.Adjustmentfoot

3.Filter 11.Inletvalves

4. Bleaching agents injection port 12. Rear control panel

5.Impeller 13.Powercord

5.Toploader 14.Rearcoverplate

6.Controlpanel 15.Base

7. Key board 16. Drain connection

8. Housing handle



2、Loading list（Follow export sales actual requirement）

No. Packing list Quantity Remarks

1 Automatic washing machine 1

2 Inlet pipe 1

3 Bottom lid board 1

4 User manual 1

5 Drain pipe parts 1 Some models have been

installed randomly

6 Self-tapping screws 2

USINGADVICE

1. Low-bubble detergent is recommended during the use of this machine.

2. It is recommended to use the washing machine in an environment of 0°C to

40°C. Too low or high ambient temperature may cause the unit to malfunction.

3. If the washing machine is stored in an environment below 0°C, it must be left in

the room temperature environment for about 4 hours before it can be used to

prevent the machine from icing and damaging the machine.

4. The washing and dehydration capacity of a washing machine refers to the

maximum weight of a standard laundry in a washable, dehydrated and dry state,

which is different from the actual laundry. The thickness, size, and type of the

washing cloth will affect the actual washing capacity. The loading amount of the

washing should be properly inverted in the washing process.

5. The amount of washing below 1.0kg should not choose high-grade water level,

so as not to splash during the washing process.

INSTALLATIONMETHOD

1、Installation notes:

a. Choose to place the washing machine in a dry place without direct sunlight.

b. There should be a floor drain at the place where the washing machine is placed,

and the water flow is unobstructed. At the same time, the floor drain should be

flush with or slightly lower than the place where the washing machine is placed, so

as to prevent the damage caused by the water leakage of the washing machine.

c. The washing machine should be placed on a flat, solid floor and keep a distance

of more than 5cm from the wall to prevent noise from colliding with the wall during

dehydration.

d. Do not place the washing machine on a sloping, uneven surface; do not place

the washing machine on an unstable stand or on the floor. When using it, remove

the bottom foam and plastic pin holder to avoid damaging the washing machine.

e. The washing machine should be placed as smoothly as possible. If necessary,

adjust the supporting feet (adjustment feet) on the front of the washing machine to

keep the washing machine level.

2、Install the bottom cover:

a.The bottom cover is placed between the top of the washing machine box and

the foam. Take it out when unpacking.

b. Place the washing machine gently on the side of the soft object (be careful not

to touch the housing).

c. Insert the bottom cover along the mounting slot on the base until it is seated.

d. Fasten the bottom cover to the base with screws (in the accessory bag).

e. Gently lift the washing machine and let it rest.

3、Connection of the inlet/drain hose

1) Connection between water inlet and tap (Please select according to the

actual water inlet pipe)

Common water inlet pipe

（1）Check the level of the

washin

machine visuall

（2）、If you have a spirit level, set the

bubble in the spirit level.

Double thread water inlet

a. To ensure that there is a sealing pad in the joint of the water inlet and the

installation is smooth.

b. According to the diagram, the water inlet is aligned with the tap and the nut

on the water inlet is tightened.

Sealing gasket

2) Connection between water inlet and Washing machine

a. Before connecting, please check whether the

sealing gasket in the water inlet nut has fallen

off or not.

b. Put water inlet nut on inlet valve joint.

c. Tighten the water inlet nut.

4、Connection of the drain hose (some model drains have been installed

before leaving the factory)

1. Press down the fix ring,

and hitch it over the drain

hose.

2. Press down the fix ring,

and then push it to the

drain outlet. Clasping the

fix ring to make sure they

are connected well.

3. Draw the drain hose to the

outlet. Do not let the height

of the drain hose exceed

90cm from the bottom of

the machine.

BEFOREWASHINGINSTRUCTIONS

1. Check before washing:

Is the inlet pipe connected? Is the faucet valve open?

Is the power cable plugged in? Is the power outlet grounded reliably?

Is the washing machine stable?

Is the drain put down? And no entanglement?

Gasket

Inlet valve joint

Nut

This manual suits for next models

Table of contents

Popular Washer manuals by other brands

Tricity Bendix

Tricity Bendix AW 1000 W Operating & installation instructions

Panasonic

Panasonic NA-F60L5WRB operating instructions

GE WSLP1500 Dimensions and installation information

Electrolux

Electrolux EWF1284EDW Service manual

Bosch

Bosch WAN2829BSN User manual and installation instructions

LG TV2516DV3B owner's manual

LG TH2517DSAV owner's manual

VESTEL

VESTEL CMH-XL 7510 TE user manual

AEG

AEG 74335 User information

Johnson

Johnson JWF721A user manual

Beko

Beko WTE7604XLW0 owner's manual

Danby

Danby DTT100A1WDB Owner's use and care guide

Amica

Amica WA 14 Ex operating instructions

Daewoo

Daewoo DWD-F1222 instruction manual

Bosch

Bosch WAS28461AU instruction manual

Miele

Miele PW 6080 Vario manual

Finlux

Finlux FLX108CF220 user manual

Whirlpool

Whirlpool 3LBR5132AN0 Use and care guide