Bellini BRA603SX User manual

啊哈

Installation and User manual

Content

Safety instructions---------------------------------- 2

Product description--------------------------------- 4

Operation mode-------------------------------------- 5

Installation--------------------------------------------- 6

Start using the range hood------------------------ 10

Maintenance and cleaning-------------------------11

Warranty------------------------------------------------ 12

Slim Line Range Hood

BRA603SX

BRA903SX

BRA603SX-F

BRA903SX-F

BRA603SW

BRA903SW

BRA603SW-F

BRA903SW-F

For warranty service call 1300 373 199(Australia)

or 0508 123108(New Zealand) to connect you to

the nearest authorised service centre

20150318 issue 2

Safety Instructions

This manual explains the proper installation and use of your range hood, please read it

carefully before using even if you are familiar with the product. The manual should be kept

in a safe place for future reference.

Never to do:

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

and mental capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning use of the

appliance by a person responsible for their safety.

Never carry out flamable cooking under the

appliance

The exhaust from the range hood must not be

discharged into any heating flue, which may carry

combustion products from other sources.

Do not leave lit gas burners exposed due to the risk

of fire.

This range hood is not recommended for

barbecues.

Always to do:

Packaging materials (eg; polystyrene and

plastic items) must be kept out of reach of

babies or young children at all times due to

risk of suffocation.

Young children should be supervised to

ensure that they do not play with the

appliance.

Ensure the range hood is switched off before

carrying out maintenance, to avoid any

possibility of electric shock.

Grease filters must be removed every four

weeks (maximum) for cleaning to reduce the

risk of fire.

There must be adequate ventilation of the

room when the range hood is used at the

same time as appliances burning gas or other

fuels.

Always cover lit gas burners with pots or pans

when range hood is in use.

Always switch off gas burners before you

remove pots or pans.

If the supply cord is damaged, the cord must

be replaced by the manufacturer, its service

agent or similarly qualified persons in order to

avoid a hazard

Plug must be accessible after installation.

Safety Instructions

Never to do:

This range hood cannot be installed for outdoor use.

It is prohibited to fit the range hood over a solid fuel

stove

This appliance must not be connected to a chimney

or vent flue which is in use.

This appliance is not to be vented into the roof

cavity, must exit into open air.

Exhaust air must not be discharged into a wall

cavity, unless the cavity is designed for the purpose.

This appliance should not be connected to ducting

which ventilates rooms with fire places.

Always to do:

Attention should be given to ensure that any

applicable regulations concerning discharge

of exhaust air are fulfilled.

This appliance should be installed and

maintained by a suitably qualified and

competent person in accordance with the

relevant safety regulations.

Before connecting the appliance to the mains

supply, ensure that the voltage and frequency

details on the rating plate are consistent with

the source of supply.

Product Description

Component list:

1. Outlet(diameter 120mm)

2. Main body

3. Grease mesh filters*

*2pcs for 60cm, 3 pcs for 90cm range hood

Technical data:

Model

Description

Motor

Width

Others

BRA603SX

60cm slim line stainless

steel range hood

2x100W

600mm

Power supply: 220 –240v, 50Hz

Lights: 2x40W incandescence

Length of power cord: 1.5m

Air outlet diameter: 120mm

BRA603SX-F

BRA603SW

60cm slim line painted

white range hood

BRA603SW-F

BRA903SX

90cm slim line stainless

steel range hood

2x100W

900mm

BRA903SX-F

BRA903SW

90cm slim line painted

white range hood

BRA903SW-F

Accessories

Description

Picture

QTY

Installation & User Manual

Outlet( diameter 120mm)

Dry wall anchors plugs

Screw (ST4x30mm)

Screw (M4*35mm)

Nut (M4)

washer

Outlet cover

Operation Mode

Your range hood can be operated in two optional modes, choose the mode suitable for your kitchen before

installation. Air ([WUDFWLRQ

Air Recirculation

You can shift between above 2 modes by turning the shifter

Air ([WUDFWLRQ Mode

Air Recirculation Mode

For air ex 󰾡 󰾡mode, a

ducting kit is required, the

air is drawn in and cleaned

by the grease filters and

directed outside.

Ducting must be vented to

outside atmosphere.

Your range hood can duct

from back(A) or top(B).

For air recirculation

mode, charcoal filter

is a must to

eliminate cooking

smells.

The air is drawn in

and cleaned first by

the grease filters

and then charcoal

filter. The cleaned air

is then re-circulated

back into kitchen

through holes above

front panel.

traction

Installation

Dimensions:

*Width data please refer to page 4

Installation:

Warning:

Check that the installation complies with the standards of local building, gas and electrical authorities. Before

connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating

plate inside the range hood.

When installing the range hood, make sure you adhere to the minimum and maximum distances from the range

hood base to the cooktop hob surface.

Hints for exhaust duct installation

The following rules must be strictly followed to obtain optimal air extraction

Keep exhaust duct short and straight

Do not reduce the size or restrict exhaust duct

When using flexible duct always install the duct pulled taut to minimize pressure loss

Failure to observe these basic instructions will reduce the performance and increase noise levels of the

range hood

Ensure the exhaust ducting selected for installation complies with relevant standards and is fire retardant.

We provide two options to install your range hood, against wall (method A) or into cabinet (method B), choose

what kind of method you want and then follow up corresponding instruction.

A: Install against wall

1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal

line where the hood base will be.

NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of

600mm & 650mm to a gas cook top and a maximum height of 750mm.

*If the instructions of the hob specify a greater distance than the minimum above, then that shall be the minimum height for installation

2. Drill 4 holes of 8mm diameter on the wall according to below drawing.

Hood base

Horizontal line

Vertical centre line

Top of hob

Minimum:

Electric 600mm

Gas 650mm

Maximum:

750mm

Where the range hood will be

Hood base

Horizontal line

Vertical centre line

92mm

543mm (60cm hood), 840mm(90cm hood)

42mm

3. Hammer dry wall anchor plugs into holes. Insert 2pcs Screw(ST4x30mm) into the 2 holes at the top and

fasten, hang the range hood onto the two screws, screw another 2pcs Screw(ST4x30mm) into the 2 holes at

the bottom inside the range hood.

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in

electrical hazards

Fit the outlet and flexible exhaust pipe* on top of range hood body**

Secure Flexible Exhaust Pipe to outlet with zip tie or duct tape ( Not supplied )

*Flexible exhaust pipe is not included in this packaging

** if you choose air recirculation mode, no need to install the exhaust pipe

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in

electrical hazards

60cm range hood 90cm range hood

B: Install into cabinet

1. According to below drawing to determine where want to place the range hood, and drill 4 holes with 4mm

diameter at the hanging board of your cabinet.

2. Fit the outlet on top of range hood body.

3. Install the range hood onto the bottom of cabinet board, insert 4pcs Screw(M4x35mm) with the nuts and

washers into the holes and fasten.

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in

electrical hazards

60cm range hood 90cm range hood

Installation of charcoal filters

When you choose front recirculation mode, charcoal filter is a must to be installed. Charcoal filter is optional

accessory. To install charcoal filter, you will need to fit outlet cover firstly, remove grease mesh filters and fit

charcoal filter on.

240mm

225mm

410mm

545mm(60cm hood), 842mm(90cm hood)

Start Using Your Range Hood

Push button

0 Off button

It’s used for turning off the fan.

Low Speed button

It’s used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not

make much steam.

Medium Speed button

Airflow speed is ideally for ventilation in standard cooking operation.

High Speed button

When high density of smoke or steam produced, press high-speed button for highest effective

ventilation.

Light button

Turn on or off the light

This manual suits for next models

Table of contents

Other Bellini Ventilation Hood manuals

Bellini

Bellini BR603GCX-1 User manual

Bellini

Bellini CRHR6W01 User manual

Bellini

Bellini BRA603GCX Installation instructions

Bellini

Bellini BR603AX-F Installation instructions

Bellini

Bellini BDR603TFG User manual

Bellini

Bellini BDRA603TBX Installation instructions

Bellini

Bellini BR603AX User manual

Bellini

Bellini BR903IPX User manual

Bellini

Bellini BR603GCX User manual

Bellini

Bellini BRA603SX2 Installation instructions

Bellini

Bellini BRA603CPX2 Installation instructions

Bellini

Bellini BBQR123X User manual

Bellini

Bellini BR603SPX-F User manual

Bellini

Bellini CRHR6W01 User manual

Bellini

Bellini BRA903SLX Installation instructions

Bellini

Bellini BRA603CPX Installation instructions

Bellini

Bellini BDRA603TBX2 Installation instructions

Bellini

Bellini BR903AX Installation instructions

Bellini

Bellini BBQRA123X Installation instructions

Bellini

Bellini CRHR6W02 Installation instructions

Bellini

Bellini BRA603SX-F Installation instructions

Bellini

Bellini BRA52UX Instruction Manual

Bellini

Bellini BRA62SWP User manual

Bellini

Bellini BRA52UX-F User manual

Popular Ventilation Hood manuals by other brands

emmeti

emmeti RECUPA MED A-140 Installation and use manual

Nibe

Nibe F135 user manual

Kuppersberg

Kuppersberg INTRO 60 Technical Passport

Zephyr

Zephyr Spruce AK9834BS Use, care and installation guide

Hisense

Hisense MH6INBG manual

Miele

Miele DA 1255 Operating and installation instructions

Broan

Broan 46000 Specification sheet

GE Profile PV977 Owner's Manual & Installation Instructions

FALMEC

FALMEC FFRIA24W5FS Instruction booklet

Whirlpool

Whirlpool RH2600XL-1 SERIES installation instructions

Küppersbusch

Küppersbusch DX ISLA instruction manual

ETNA

ETNA AV360RVS Instructions for use

JUNO

JUNO JDF603E6 installation manual

Miele

Miele DA 6708 D Operating and installation instructions

Tricity Bendix

Tricity Bendix LE 150 Installation & operating instructions

AEG

AEG X68163BV1 user manual

AEG

AEG 125 D operating instructions

Smeg

Smeg KSEV97X instruction manual