Argo Softy User manual

V 10/16

PORTABLE AIR CONDITIONER (LOCAL)

OPERATING INSTRUCTIONS

Read the instructions carefully before operating the appliance or carrying out maintenance work.

Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or

damage. Store these instructions in a safe place for future reference.

V 10/16

GENERAL OPERATING AND SAFETY INSTRUCTIONS

This appliance is a portable air conditioner designed for domestic

use.

Only use this air conditioner as described in this manual.

Ensure that the required voltage and frequency (220-240 V/50 Hz)

match the available power source.

This appliance can be used by children aged from 8 years and

above and people with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have been

given supervision or instruction concerning use of the appliance in a

safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children

without supervision.

Ensure that the electricity system is able to deliver the operating

current required by the air conditioner, in addition to that normally

absorbed by other appliances (electrical appliances, lighting system,

etc.). Please refer to the maximum power input data shown on the

air conditioner's data plate.

Connection to the electricity grid must take place in accordance with

current installation standards.

Ensure that the automatic switches and system protection valves

are able to withstand a start-up current of 6A (normally for less than

1 second).

The power socket must always include an efficient earth connection.

Make sure that the plug is properly inserted into the socket. Do not

use multiple adapters. Do not touch the plug with wet hands. Make

sure that the plug is clean.

Do not use the plug for starting/stopping the air conditioner: use the

ON/OFF button on the remote control or control panel instead.

Do not install the air conditioner in rooms potentially subject to water

sprays (e.g. laundries).

V 10/16

This air conditioner can be used by children of 8 years or older and

by persons with reduced physical, sensory and mental abilities, or

lacking the necessary experience and knowledge, provided they are

supervised or instructed on its use by a person responsible for their

safety, so that they are fully aware of the attendant risks.

Before moving or cleaning the appliance, ensure that it is unplugged

from the socket.

Do not move the air conditioner while it is operating; first turn the

appliance off, then check and remove any condensate which may

have formed.

To turn the appliance off, set the remote control to OFF and remove

the plug from the socket. Pull on the plug only. Do not pull the cord.

Do not use the appliance if the cord or plug are damaged.

Contact a service centre to replace a damaged power cord, so as to

avoid any safety risks.

PRECAUTION!

Do not insert any objects into the air conditioner: this is very

dangerous as the fan turns at high speed.

Ensure that air circulates freely around the unit. Do not cover

the air intake and delivery grilles with drapes or any other

means.

WARNING!

The air conditioner must be positioned at least 50 cm from the wall

or any other obstacles, on a flat and stable surface so as to avoid

water leaks.

The air conditioner is fitted with a system to protect the

compressor from overload. This means that the compressor

only starts 3 minutes after its previous stoppage.

Please wait at least 3 minutes before starting the unit. This

helps prevent the compressor from being damaged.

V 10/16

WARNING!

In the event of an anomaly, switch the appliance off and unplug

from the socket. Do not dismantle or attempt to repair or modify

the product. In the event of a malfunction, contact the service

centre directly.

WARNING!

Do not expose the air conditioner to direct sunlight, as the

colour of the materials may change; moreover, the appliance

may overheat causing the protection mechanism to intervene

and switch the appliance off.

Do not use insecticides, oils, detergents or spray paints near

the appliance; do not use aggressive chemical detergents to

clean the casing: this may damage the finish and colour.

Close all open windows to maximise air conditioning

efficiency.

The manufacturer will not be held liable if safety and accident

prevention rules are not observed.

V 10/16

DESCRIPTION OF THE APPLIANCE

FRONT VIEW

REAR VIEW

Min/max operating limits (internal temperature)

Cooling: 16 °C DB / 35 °C DB

Heating (Softy plus): 5 °C DB / 27 °C DB

Dehumidification: 16 °C DB / 35 °C DB

Cooling mode room temperature adjustment range: 16 °C DB / 32 °C DB

1) CONTROL PANEL AND BUTTONS FOR

OPERATION WITHOUT REMOTE CONTROL

2) FIN AND AIR FLOW OUTLET

3) SIGNAL RECEIVER

4) FRONT

5) HANDLES

6) AIR INTAKE

7) HANDLES

8) DRAINAGE HOLE (DEHUMIDIFICATION)

9) AIR INTAKE

10) DRAINAGE HOLE (ONLY FOR MODELS WITH

HEAT PUMP)

11) POWER CORD OUTLET

12) DRAINAGE HOLE (COOLING)

13) UPPER FILTER (BEHIND GRILLE)

14) UPPER AIR INTAKE

15) LOWER FILTER (BEHIND GRILLE)

16) LOWER AIR INTAKE

17) WHEELS

18) REMOTE CONTROL

9) A

(18)

V 10/16

APPLIANCE START-UP

Open the packaging and pull out the box. Remove the product and the other elements supplied (illustrated in the box

below).

LCD remote control.

Type-AAA

batteries for

remote

control.

Round fitting (1) for positioning between

the air discharge outlet and the flexible

pipe.

Flexible pipe.

End fitting for window (2).

Window unit kit with plug.

Round fitting for window

unit, for positioning

between the end of the

tube and the window unit

itself.

Drainage tube (continuous

drainage).

Position the product vertically on a flat and stable surface, as close as possible to a window and at least 50 cm from

walls or other nearby obstacles.

USE WITH END FITTING FOR WINDOW

1. Connect the round fitting (1) to the flexible pipe,

extend the tube until it reaches the outside and

connect to the rear of the air conditioner.

2. Slide the flat fitting downwards into the grooves (A)

and secure it with the hook on top (B).

V 10/16

3. Connect the end part of the flexible pipe to the round

fitting for the window (2).

The drainage tube can be compressed to minimum 45

mm and extended to maximum 1500 mm. It is

advisable to keep the tube compressed to the

minimum.

4. Open the windows and lock one of the two leaves

with the handle.

Place the end fitting against the fixed leaf of the

window and

draw the other leaf against it.

5. Avoid tight bends and folds in the flexible pipe.

USE WITH WINDOW UNIT KIT

1. Make a hole having a diameter of roughly 133

mm on the glass window.

2. Insert the window unit into the window.

3. Insert the round fitting into the retractable flexible

pipe and insert the latter with its round fitting into

the window unit without the plug.

4. Insert the round fitting onto the flexible pipe.

5. Insert the flexible pipe thus mounted into the rear of the

air conditioner.

If the air conditioner is not used for prolonged periods, disconnect the pipe and plug the window unit.

Connect the power cord to a suitable electric socket (220–240 V). Insert the supplied batteries into the remote control

and make sure the poles match. Select the desired operating mode from the remote control.

V 10/16

HOW TO USE THE APPLIANCE

This appliance can be used for SOFTY cooling, heating (only model SOFTY PLUS), dehumidification and ventilation.

When switching between modes, the fan continues to turn but the compressor stops: the compressor will re-start after 3

minutes. This delay protects the compressor from potential damage.

THE DISCHARGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the

appliance is used in dehumidification mode only, in which case the appliance should be left to discharge directly

into the room for maximum efficiency (see the “Dehumidification Mode” paragraph).

Clean the air filters under the easily removable rear grille regularly to keep the air conditioner working efficiently.

OPERATING MODES

1. COOLING MODE (COOL)

The “Cool” LED on the control panel will turn on.

The temperature can be adjusted to between 16 °C and 32 °C.

In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the temperature

setting and retains this setting when it is switched on again.

In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

For more silent operation, run the fan at low speed.

2. HEATING MODE (HEAT) (Softy plus)

The “Heat” LED on the control panel will turn on.

The temperature can be adjusted to between 16 °C and 32 °C.

In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the temperature

setting and retains this setting when it is switched on again.

In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

For more silent operation, run the fan at low speed.

3. DEHUMIDIFICATION MODE (DRY)

Press the MODE button to select the dehumidification mode.

The temperature is controlled by the electronic board and cannot be adjusted.

In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings and

retains them when it is switched on again.

The fan speed is set to low and cannot be adjusted.

Cooling, Heating, Ventilation

Dehumidification

V 10/16

NOTE

The air conditioner does not cool the room when operating as a dehumidifier.

When the appliance is used as a dehumidifier, the flexible pipe must not be connected.

For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into

the environment.

The dehumidification mode is recommended during autumn and winter.

If used during summer, it is best to leave the flexible pipe attached so that the hot air is discharged towards

the outside rather than into the room.

During dehumidification, continuous drainage should be implemented (see the next chapter, “HOW TO ELIMINATE

CONDENSATE”).

4. VENTILATION MODE (FAN ONLY)

Press the MODE button until the Fan icon appears.

In this mode, the fan speed can be adjusted.

The temperature cannot be adjusted.

HOW TO ELIMINATE CONDENSATE

Cooling & Heating (Softy plus)

This appliance automatically vaporises condensate in the cooling and heating mode.

Ensure that when the unit is operating in cooling and heating mode, the rubber caps

closing the drainage holes on the rear of the appliance are properly positioned.

When the air conditioner operates in cooling and heating mode, there is no need for

continuous condensate drainage; only in specific weather conditions with very high air

humidity levels may water deposit inside the unit. When the internal container is full,

the display visualises message “P1” and the appliance stops functioning.

To empty the container, switch the air conditioner off and unplug it. Remove the cap

form the rear drainage hole and direct it over a normal drain.

Ensure that the tube is not twisted or bent. The tube must slope downwards. Re-close

the drainage hole with the cap and resume use of the air conditioner.

Dehumidification

WARNING!

When using the air conditioner in dehumidification mode, it is advisable to always

arrange for continuous drainage, so as to maximise dehumidification efficiency.

Connect one end of the PVC pipe provided to the rear discharge hole and place the

other end above a drain.

V 10/16

REMOTE CONTROL OPERATION

Insert the batteries into the remote control and make sure the poles

match.

Only use type-AAA 1.5 V batteries.

Remove the batteries if the remote control is not used for a month

or longer.

Do not attempt to recharge the batteries. Replace all batteries at the

same time.

Do not throw the batteries into fire: they may explode.

FOR OPTIMAL REMOTE CONTROL OPERATION, POINT THE TRANSMITTER HEAD TOWARDS THE

RECEIVER ON THE AIR CONDITIONER.

1. ON/OFF BUTTON

2. TEMPERATURE AND TIMER BUTTONS

3. MODE BUTTON

4. SCREEN BUTTON (LCD ON/OFF)

5. SLEEP BUTTON

6. SPEED BUTTON

7. SWING BUTTON

8. FEELING BUTTON

9. TIMER BUTTON

INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE

2006/66/EC

Please replace batteries when flat: at the end of their useful life, batteries must not be disposed of with unsorted waste. They must

be taken to designated recycling centres or returned to a retailer providing this service. Separate disposal of batteries prevents

potential negative effects on the environment and human health due to inadequate disposal, and also allows for recovering and

recycling their constituent materials, resulting in significant savings in terms of energy and resources. The separate disposal

obligation is underlined by the crossed-out dustbin symbol appearing on the battery. Illegal disposal of the product by the user is

subject to administrative penalties as per current regulations.

Transmitter

head

Operation

display

This manual suits for next models

Table of contents

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual