ACME Thunder User manual

CONTENTS

1. Safety Instruction........................................................................................... 2

2. Technical Specifications ................................................................................. 4

3. Installation and Connection........................................................................... 5

4. Control Panel ................................................................................................. 8

5. How To Set The Unit ...................................................................................... 9

5.1 Main Function.......................................................................................... 9

5.2 Home Position Adjustment .................................................................... 15

6. Control By Universal DMX Controller........................................................... 18

6.1 DMX512 Connection.............................................................................. 18

6.2 Address Setting...................................................................................... 19

6.3 DMX512 Configuration .......................................................................... 20

7. Error Information......................................................................................... 24

8. Troubleshooting........................................................................................... 26

9. Fixture Cleaning ........................................................................................... 26

1. Safety Instruction

WARNING

Please keep this User Guide for future consultation. If you sell the unit to another user, be sure

that they also receive this instruction manual.

Important:

Damages caused by the disregard of this user manual are not subject to warranty. The dealer

will not accept liability for any resulting defects or problems.

Unpack and check carefully that there is no transportation damage before using the unit.

This product is suitable for wet locations. Do not immerse in water.

DO install and operate by qualified operator.

DO NOT allow children to operate the fixture.

Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head

only.

The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent

surfaces.

Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.

Before operating, ensure that the voltage and frequency of power supply match the power

requirements of the unit.

It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.

Minimum ambient temperature TA: 0℃. Maximum ambient temperature TA: 40℃.

DO NOT connect the device to any dimmer pack.

Make sure there are no flammable materials close to the unit while operating to avoid fire

hazard.

Examine the power wires carefully; replace them immediately if there is any damage.

Unit’s surface temperature may reach up to 75℃. DO NOT touch the housing bare-handed

during its operation.

Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut

Please read the instruction carefully which includes important information

about the installation, usage and maintenance.

off the mains power immediately.

DO NOT operate in dirty or dusty environment, do clean fixtures regularly.

DO NOT touch any wire during operation as there might be a hazard of electric shock.

Avoid power wires together twist other cables.

The minimum distance between light output and the illuminated surface must be more than

0.5 meters.

In the event of serious operating problem, stop using the unit immediately.

Never turn on and off the unit time after time.

The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.

DO NOT open the unit as there are no user serviceable parts inside.

Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to

damage or malfunction. Please contact the nearest authorized technical assistance center if

needed.

Disconnect the mains power if the fixture is has not been used for a long time.

DO use the original packing materials before transporting it again.

DO NOT look directly at the light while the LED is on.

DO NOT start on the unit without LED enclosure or when housing is damaged.

2. Technical Specifications

Power Voltage:

AC 100~240V, 50/60Hz

Power Consumption:

515W

Light Source:

1188x0.8W RGBW LED

Beam Angle:

110°

Spot Angle:

152°

Dimmer/Strobe:

Smooth dimming from 0-100%; outstanding strobe effect with variable speed

Control:

DMX Channel: 4(8 bit)/8(16 bit)/8/9(16 bit)/16 Channels

Control Mode: DMX512, RDM

Firmware Upgrade via DMX link

Construction:

Display: OLED display

Data In/Out: 3-pin IP XLR (5-pin IP XLR is optional)

Power In/Out: Waterproof Power Connector in/out

Protection Rating: IPX4

Features:

Variable CTO

High brightness, smooth color mixing, powerful wash effect

3 x led zones can be controlled individually

Equipped with a special patented plug structure, can be easily combined with each other or with

other THUNDER series

Dimension/Weight:

503x183x318mm, 10.5kgs

19.8"x7.2"x12.5"in, 23.1lbs

Photometric Diagram:

3. Installation and Connection

The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is

firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure to

which you are attaching the unit is secure and is able to support a weight of 10 times of the unit’s

weight. Also always use a safety cable that can hold 12 times of the weight of the unit when

installing the fixture.

The equipment must be fixed by professionals. And it must be fixed at a place where is out of the

touch of people and has no one pass by or under it. The installation height of the equipment is

between 0 and 30 meters.

Installation mode of the hanging bracket:Installation mode of a single angle-adjustable

equipment’s hanging bracket:

Installation mode of the bolt: Assembly method between two equipment:

Installation mode of the big hanging bracket (operational):

Assembly method between multiple equipment:

Warning: no more than 7 equipment can be spliced vertically

4. Control Panel

1. Display: To show the various menus and the selected function

2. Button:

MENU To enter into move backward or leave the menu

UP To go backward to move up in the menu

DOWN To go forward to move down in the menu

ENTER To perform the desired functions

3. DMX IN:

For DMX512 operation, use 3-pin XLR cable to link the units together (5-pin XLR is optional)

4. DMX OUT:

For DMX512 operation, use 3-pin XLR cable to link the next unit (5-pin XLR is optional)

5. POWER IN: Used to connect to supply power

6. POWER OUT: Used to connect to the next fixture

5. How To Set The Unit

5.1 Main Function

Turn on the unit, press the MENU button into menu mode, and press the UP/DOWN button until

the required function is shown on the monitor. Select the function by the ENTER button. Use the

UP/DOWN button to choose the submenu, press the ENTER button to store and automatically

return to the last menu. Press the MENU button or let the unit idle 30 seconds to exit menu mode.

The main functions are shown below:

Table of contents

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions