Abus PPIC91000 User manual
2
English
Introduction
Dear customer,
Thank you for purchasing this product.
ABUS Security-Center hereby declares that the base station and camera PPIC91000 and
PPIC91520 comply with the RED Directive 2014/53/EU. These devices also comply with the
requirements of the following EU directives: EMC Directive 2014/30/EU and RoHS Directive
2011/65/EU. The full text of the EU declaration of conformity is available at the following web
addresses: www.abus.com/product/PPIC91000
www.abus.com/product/PPIC91520
In order to maintain this condition and to ensure safe operation, you as the user must observe these
operating instructions!
Please read the complete operating instructions carefully before putting the product into operation, and
pay attention to all operating instructions and safety information.
All company names and product descriptions are trademarks of the corresponding owner. All
rights reserved.
3
English
Data storage is subject to national data privacy guidelines.
The use of surveillance equipment may be forbidden or regulated by law in some countries. Before
using this equipment, ensure that all of your surveillance activities are legal.
Note on data protection
The operator is responsible for the legally compliant use of the product in accordance with GDPR.
Warning as required by Section 201 StGB (German Criminal Code):
Whoever, without being authorised to do so, makes an audio recording of the privately spoken
words of another, and uses or makes a recording thus produced available to a third party, shall
incur a penalty of imprisonment or a fine.
The same penalty shall be incurred by whoever, without being authorised to do so, uses a listening
device to intercept the privately spoken words of another which they are not intended to hear, or
publicly communicates, verbatim or the essential content of, the privately spoken words of another
which were recorded or intercepted.
Disclaimer
These operating instructions have been produced with the greatest of care. However, if you notice
any omissions or inaccuracies, please let us know in writing at the above address.
ABUS Security-Center GmbH does not accept any liability for technical and typographical errors, and
reserves the right to make changes to the product and user guides at any time and without prior
warning.
ABUS Security-Center GmbH is not liable or responsible for direct or indirect damage resulting from
the equipment, performance and use of this product. No guarantee is made for the contents of this
document.
4
English
Contents
1. Scope of delivery............................................................................................................................... 6
2. Description of hardware ................................................................................................................... 7
2.1. Battery Camera Pro ..................................................................................................................... 7
2.2. Bracket......................................................................................................................................... 9
2.3. Base station................................................................................................................................ 10
3. Mounting/installation ...................................................................................................................... 12
3.1. Camera alignment and coverage............................................................................................... 12
3.2. Installing the camera without a wall bracket .............................................................................. 14
3.3. Installing the camera with a wall bracket ................................................................................... 15
3.4. Notes on the recognition of persons .......................................................................................... 16
3.5. Installing the camera and base station ...................................................................................... 18
3.6. Placement of base station without drilling.................................................................................. 21
3.7. Mounting the base station on the wall........................................................................................ 22
4. App2Cam Plus: First access .......................................................................................................... 24
4.1. System requirements ................................................................................................................. 24
4.2. Downloading the app ................................................................................................................. 24
4.3. Setting up the camera................................................................................................................ 25
4.3.1. LAN setup............................................................................................................................. 25
4.3.2. Adding a base station that has already been set up............................................................ 27
4.3.3. Assigning a new camera to a base station .......................................................................... 27
4.4. App2Cam Plus: Overview .......................................................................................................... 28
4.4.1. Camera overview ................................................................................................................. 29
4.4.2. Recording menu/Recordings/Storage.................................................................................. 29
4.4.3. Info / App settings................................................................................................................. 30
4.5. App2Cam Plus: Live view .......................................................................................................... 31
4.5.1. Live view functions............................................................................................................... 31
4.5.2. Camera indicators ................................................................................................................ 32
4.5.3. Stream indicators ................................................................................................................. 32
4.6. App2Cam Plus: Recordings....................................................................................................... 33
4.6.1. Recording menu................................................................................................................... 33
4.6.2. Recording menu functions ..............................................Fehler! Textmarke nicht definiert.
4.7. Playback..................................................................................................................................... 34
4.7.1. Playback functions ............................................................................................................... 34
4.7.2. Download and share recording (download/forward)............................................................ 35
4.7.3. Opening camera settings ..................................................................................................... 35
4.7.4. Camera information.............................................................................................................. 35
4.7.5. Camera settings ................................................................................................................... 36
4.7.6. Base station settings............................................................................................................ 37
4.7.6.1 Security settings ............................................................................................................ 37
4.7.6.2 Schedule settings .......................................................................................................... 38
4.7.6.3 Storage settings............................................................................................................. 39
4.7.6.4 Notification settings........................................................................................................ 40
5
English
4.7.6.5 Device settings .............................................................................................................. 42
4.7.6.7 Device information......................................................................................................... 43
4.7.6.8 Add camera ................................................................................................................... 43
4.7.6.9 Restart base station....................................................................................................... 43
4.7.8. Camera settings (camera 1-4) ............................................................................................. 44
5. Update firmware .............................................................................................................................. 46
5.1. Update via server....................................................................................................................... 46
6. Overview of voice commands........................................................................................................ 47
7. Battery FAQs.................................................................................................................................... 48
8. Troubleshooting tips....................................................................................................................... 49
9. Open Source licence notes ............................................................................................................ 50
6
English
1. Scope of delivery
1
2
3
4
5
6
7
8
9
10
11
7
English
PPIC91000
•Battery Camera Pro (1)
•Antenna for Battery Camera Pro (2)
•Base station (3)
•Power supply unit for base station (12 V
DC, 1 A) (4)
•Wall bracket (5)
•Drill template for camera (6)
•Network cable (1.5 m) (7)
•USB-A to USB-C cable (8)
•Reset tool (9)
•2x mounting material (10)
•Drill template for base station (11)
•USB Stick (12)
PPIC91520
•Battery Camera Pro (1)
•Antenna for Battery Camera Pro (2)
•Drill template for camera (6)
•USB-A to USB-C cable (8)
•Reset tool (9)
•Mounting material (10)
2. Description of hardware
2.1. Battery Camera Pro
Front
Lens
Microphone
PIR sensor
White light
LED
Loudspeaker
8
English
•The charging status LED flashes during the charging process. The LED is permanently
lit in red when fully charged and in wired operation, as well as during recording and
access to the live view in the app,.
•Any bracket with ¼" thread is supported.
Attention!
When operating permanently with the USB-C cable, the camera can only be used indoors
as protection against splashing water/rain is no longer provided with the cover open. This
will invalidate the camera's ability weatherproof capability.
Rear
ON/OFF and PAIRING button
1/4" thread for bracket
Cover
Status LED
USB-C port
Antenna
connection* (RP-SMA)
*Wireless frequency: 2.4 GHz (802.11 b/g/n), max. transmission power 20 dBm
Switching on the camera:
Press and hold the On/Off button for 3 seconds
until the camera issues a signal tone and the red
status LED lights up.
Switching off the camera:
Press and hold the button for 5 seconds.
9
English
Charging the camera
The camera battery is fully charged at the factory. Due to transport and storage, the battery charge level
may be reduced at the time of purchase or start-up. Tip: Fully charge the camera before using it.
Connect the enclosed USB-C cable to the corresponding port on the back of the camera. Use a
commercially available mains plug (as for charging a mobile phone) with 5 V DC and 2 A to charge the
camera. If the battery is empty, the camera will be fully charged again in approx. 4 hours. During
charging, the red LED on the back of the camera flashes. As soon as the charging process is completed,
the LED lights up red continuously. The charge status is displayed in the app within the live view during
operation. The battery charge lasts up to 6 months and depends on several factors, such as triggering
frequency, live image access and external environmental influences. You can find more information
under menu item 7. Battery FAQs.
2.2. Bracket
Ball joint with thread
Fixing ring
Cover
Back panel
Drill template
10
English
2.3. Base station
A commercially available USB stick (max. 128 GB storage capacity; not included in the
scope of delivery) is required for camera recordings. If you are using a used USB stick:
back up existing data if necessary and format the USB stick after start-up via the storage
setting of the base station.
Front / Back
USB interface for storage medium (USB stick)
Power supply (12V DC / 1A)
LAN interface
Reset button
Power LED
Pairing LED
Loudspeaker
Other manuals for PPIC91000
2
This manual suits for next models
1
Table of contents
Other Abus Security Camera manuals
Abus
Abus HDCC62550 User manual
Abus
Abus Ecoline TV7100 User manual
Abus
Abus PPIC32020 User manual
Abus
Abus TVIP61550 User manual
Abus
Abus TVIP44511 User manual
Abus
Abus TVCC40020 User manual
Abus
Abus TVAC16011A User manual
Abus
Abus TVCC50011 User manual
Abus
Abus IPCB42501 User manual
Abus
Abus PPDF18000 User manual
Abus
Abus eyseo TVCC40530 User manual
Abus
Abus eyseo TV7144 User manual
Abus
Abus TVHD51000 User manual
Abus
Abus eyseo User manual
Abus
Abus TVCC74000 User manual
Abus
Abus TVIP52501 User manual
Abus
Abus HDCC61510 User manual
Abus
Abus IPCS84531 User manual
Abus
Abus TVCC34010 User manual
Abus
Abus TVVR36020 User manual
