
Please follow the below instructions carefully to pair the scanner with
your iPad.
Step. 1
Press and hold the trigger for 2 seconds to power on the scanner and use
the barcodes in Setting up the scanner to enable HID and Smart phone
modes if necessary. Steady blue LED ashing indicates the scanner is
wireless ready.
Step. 2
On your iPad, go to Settings -> General -> Bluetooth to enable Bluetooth
function on your iPad.
Step. 3
Once enabled you will see the scanner listed (shown as "ZBBT") on your
iPad as picture below. Select "ZBBT" to connect to the scanner.
Connect scanner with iPad or iPhone
Connecting with iPad
In this case, for example,
scan 3, 2, 7, 6, then scan
Enter in ASCII table.
Step. 4
You will be prompt to enter a paring "PIN code" as shown in the
following screen.
Step. 5
Use the ASCII Code 39 Table to scan the pin code using the scanner
and scan "Enter" to conrm the entry. You should hear 2 short beeps
indicating the scanner is connected. Please complete the scanning
within 30 seconds.
Step. 6
Once connected, you will see ZBBT listed as "Connected" on your
iPad's Device list. You are now ready to scan!
Note
The procedure to pair scanner with iPhone is identical to iPad. Simply
follow the above procedure carefully and replace iPad with iPhone as
appropriate.
Cancel
“ZBBT” would like to
pair with your iPad.
Enter the passkey “3276” on
“ZBBT”. followed by the
retum or enter key.
Press and hold trigger
Blue flashing 0.5 second interval
Select
Select