Whispbar K477W User manual
K477W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 2 x 2 x 2
x 1 x 1
Revision No: 5C 1
Fitting Kit K477W
MAX kgs (lbs)
W/P WHD
Nissan
Murano , 5dr SUV 08-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Murano , 5dr SUV 08-+ US 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit EN
K477W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
3
Fitting Kit EN
K477W
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
4
Fitting Kit EN
K477W
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = 647A
B = 648A
5
Fitting Kit EN
K477W
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
6
Fitting Kit EN
K477W
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-241
B = 11-04-250
C = 11-04-251
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
7
Fitting Kit EN
K477W
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Clamps directly to edge of roof under the
doors
●Please check the rear of this manual for
information relating specifically to your
vehicle.
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
8
Fitting Kit EN
K477W
●Tighten locking screw on both legs evenly.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
9
Fitting Kit EN
K477W
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Table of contents
Other Whispbar Automobile Accessories manuals
Whispbar
Whispbar K126W User manual
Whispbar
Whispbar K186W User manual
Whispbar
Whispbar K655W User manual
Whispbar
Whispbar K129W User manual
Whispbar
Whispbar K1020 User manual
Whispbar
Whispbar K395W User manual
Whispbar
Whispbar K529W User manual
Whispbar
Whispbar K604W User manual
Whispbar
Whispbar K746W User manual
Whispbar
Whispbar K372W User manual
Whispbar
Whispbar K422W User manual
Whispbar
Whispbar K447 Install guide
Whispbar
Whispbar K046W User manual
Whispbar
Whispbar K390W User manual
Whispbar
Whispbar K870W User manual
Whispbar
Whispbar S6W User manual
Whispbar
Whispbar K390 User manual
Whispbar
Whispbar K312W User manual
Whispbar
Whispbar K330W User manual
Whispbar
Whispbar K514W User manual
