Vitek Virtuoso Series 5 User manual

FEATURES:

•5 or 8 MegaPixel [4K] Network Camera (2592x1944px / 3840x2160px @ 30/25fps)

• 1/2.8” 5.69 / 8.29 MegaPixel Sony STARVIS CMOS® Sensor,

•ONVIF Compliant with Zero Configuration, ONVIF Event Mapping

•Cross Web Browsing (IE, Edge, Safari, Firefox, Chrome)

•Adaptive web-based resizing (Layout / Display Device Resolution Dependent)

•Quad Streaming: H.265, H.264 & MJPEG

• HTML5 Playback

•MicroSD Memory Card Slot Supporting Local Recording up to 128GB (H.264)

•ICR Dual Filter Switch

•CS mount supported (Option: C-mount adaptor)

• 120dB Dynamic Range with DOL (Digital Overlap) WDR @30/25fps

•Improved Noise Reduction with XD-DNR

•LDC (Lens Distortion Compensation)

•Smart Stream, RoI (Region of Interest)

- Enables Smart Processing of Video Data According to Users’ Needs

-Enables High Quality Video on RoI and Lower Quality Video on non-RoI

-Lowers Overall Bandwidth and Reduces Storage Burden

• Motion Detection, Privacy Masking, Defog, D-Zoom (~10x), Mirror/Flip,

Sens-up (Slow shutter), Hue, Contrast, Brightness / Saturation, Sharpness

•IP68 (VTD-MV8NZ311P, VTD-MV5NZ212P, VTC-IR8NZ4311P),

IP67 (VTC-IR5NZ3212P)

•Circuit Protection Protects Against Faulty Connection in Power Polarity

•Isolated Power Supply Protects Against Ground Loop Problems

•12VDC, 24VAC and PoE Operation (Power over Ethernet, EEE Std. 802.3af)

Virtuoso Series

Virtuoso Series 5 and 8

MegaPixel Network Cameras

QUICK START GUIDE

*Lens Sold Separately

VTD-MV8NZ311P

VTD-MV5NZ212P

VTC-IR5NZ3212P

VTC-IR8NZ4311P

VTC-CB5N

VITEK

Table of Contents

Safety Precautions.............................................. 3-4

Overview: VTC-IR5NZ3212P.............................. 5-9

Overview: VTC-IR8NZ4311P............................. 10-18

Overview: VTD-MV5NZ212P, VTD-MV8NZ311P................ 19-26

Overview: VTC-CB5N....................................... 27-29

OPERATING INSTRUCTIONS......................... 30-38

Menu Table / Network Menu Setup....... 30-32

Live View............................................... 33

Information............................................ 34

Users..................................................... 35

Date and Time...................................... 36-37

Network................................................ 38

Firmware Upgrade............................... 39

Detailed Specications..................................... 40-44

Accessories....................................................... 45

Warranty Information........................................ 46

2 3

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFERSERVICING TO QUALIFIEDSERVICE PERSONNEL.

To prevent electric shocks and risk of fire hazards, do NOT expose this unit to rain

or use other than with the specified power source.

Warning :

This equipment has been tested and found tocomply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely tocause harmful

interference in which case the user will be required tocorrect the interference at

his own expense.

Caution :

Any changes or modifications in construction of this device which are not expressly

approved by the party responsible for compliance could void the user's authority

to operate the equipment.

Mains power quality should be that of atypical commercial environment. If the user

of the model requires continued operation during power mains interruptions, it is

recommended that the model be powered from an uninterruptible power supply

(UPS) or a battery.

The symbol is intended to alert the user to the presence of important

operating and maintenance(servicing) instructions in the literature

accompanying the unit.

The symbol is intended to alert the user tothe presence of uninsulated

"dangerous voltage" within the product's enclosure that may be of

sufficient magnitude to constitute a risk of electric shock to persons.

Safety Precautions

NOTICE

• The images used in this instruction manual are processed to help comprehension

and may differ from actual video of the camera.

• Avoid installing in areas where there shock or vibration which results in problems.

• Pay attention to safety when laying the connection cable and observe that the cable

is not subjected to heavy loads, kinks or damage and no moisture can get in.

• Never open the device such as boards or lens.

The warranty becomes void if repairs are undertaken by unauthorized persons.

• Maintenance and repair have to be carried out only by authorized service centers.

• Use only a mild detergent to clean the housing body only but never for the clear

bubble dome.

• The camera should never be operated beyond the technical specifications.

This can lead to destruction.

• The camera should never be operated in water.

4 5

MEGA-PIXEL NETWORK CAMERA

Composition - VTC-IR5NZ3212P

Dimensions - VTC-IR5NZ3212P

unit : inches / (mm)

Wiring Connector

(1pc)

Torque Wrench:

.12” 3mm (1pc)

Mounting Screw:

4 x 1.58” 40mm (3pcs)

Plastic Anchor:

6 x 1.181” 30mm (3pcs)

Mounting Template

Quick Start Guide

Camera

3.43 (87)

3.73 (94.8)

3.17 (80.5)

9.29 (236)

9.72 (247)

Ø3.64 (92.4)

Part Names - VTC-IR5NZ3212P

DUAL WINDOW

SUNSHIELD BOLT

SUNSHIELD

FRONT CASE

BRACKET

REAR CASE

Cover Open

Micro

SD Card Slot

IP Reset

Button

• Extreme care should be taken NOT to scratch the surface of window while

installing or adjusting the camera.

• Care should be taken so the cable is NOT damaged, kinked or exposed in

a hazardous area.

• Do not expose the camera directly to a strong light source such as the sun or

a spotlight.

CAUTION

POWER

CABLE

6 7

Installation Instructions

Mounting Screw

4x 1.58” (40mm)

1. Position the mounting template at the installation location and drill the ceiling

or wall if needed.

2. Route the cable and connect according to instructions below.

3. Place the camera bracket on the pre-drilled position and attach it using

mounting screws (4x40mm).

4. Set the camera’s viewing angle.

5. Put the sunshield on the camera unit and tighten the sunshield-bolt.

Pan & Tilt adjustments

1) Pan limit:

Pan is limited to +/- 90°.

2) Tilt limit:

Tilt is limited to 0°(2°) min ~ 90° max.

for wall (ceiling) installation respectively

with reference to the wall (ceiling) when

the inclination of camera module is 0°,

that is, the image is aligned horizontally.

90° 90°

• Unlock the screw on the camera bracket using the torque wrench

supplied.

• Set the camera’s viewing angle then lock the screw on the bracket.

Installation Instructions

• Make sure the power is removed before installation.

• After all connections are properly finished, follow the order for applying power.

a) Plug the network cable into RJ-45 Ethernet Port.

If PoE is the only power, there is no need to connect power terminal.

b) When DC12V or AC24V local power is necessary, connect the low voltage

(DC12V or AC24V) first, then plug the AC adapter toAC outlets to avoid an

improper reset from a power spike and damage from the voltage surge with

no load.

When PoE and local dual power are connected at the same time,

local power has priority.

Adjustment of viewing angle

with one-touch 3-Axis bracket

Torque

wrench Lock/Unlock

Screw

3) Inclination limit

(Horizontal image alignment):

Inclination limited to +/-90° max.

90°

±90°

•on the wall • on the ceiling

8 9

Installation Instructions

MEGA-PIXEL NETWORK CAMERA

Power Supply Connections

This camera can work with either 24AC or 12VDC, dual voltage power and PoE

(IEEE Std. 802.3af). Primary and secondary grounds are completely isolated

to avoid possible ground loop problems.

Ethernet

POWER

(AC24V/DC12V)

AC(-) :

AC24V/GND

AC(+) :

AC24V/DC12V

(+)

(-)

Composition VTC-IR8NZ4311P

Dimension VTC-IR8NZ4311P

unit : inches / mm

Torque Wrench:

.12” (3mm) (1pc)

Cable tie (2pcs)

Hinge pin (1pc)

Mounting

Template

Quick

Start

Guide

Camera unit

Mounting Screw:

4 x 1.18” (30mm) (4pcs)

Plastic Anchor:

6 x 1.18” (30mm) (4pcs)

Grommet (2pcs)

Cable Plate

with Screw

RJ45 Easy Cap

for Grommets

7.34 (186.5)

2.03 (51.50)

11.81 (300)

1.22 (31.00)

3.39 (86.15)

4.35 (110.50)

3.39 (86.15)

3.53 (89.60)

4.30 (109.19)

5.14 (130.50)

10 11

This manual suits for next models

Table of contents

Other Vitek Security Camera manuals

Vitek

Vitek Alpha VTD-A4F/I User manual

Vitek

Vitek VTD-MVH2910DN User manual

Vitek

Vitek VTD-C410 User manual

Vitek

Vitek Transcendent VTC-TNT8RFEA-2 User manual

Vitek

Vitek VTD-TTD30R2V User manual

Vitek

Vitek TRANSCENDENT VTD-T4D6HR5MD User manual

Vitek

Vitek VT-TPTZ10HR-5N User manual

Vitek

Vitek Transcendent Series User manual

Vitek

Vitek VTD-TNMD4RFS User manual

Vitek

Vitek VTD-A4F/IW User manual

Vitek

Vitek Virtuoso Series User manual

Vitek

Vitek VTD-TND4RFS User manual

Vitek

Vitek VTC-BHOCR2812 User manual

Vitek

Vitek VTC-EL52H User manual

Vitek

Vitek VTC-LED307BB User manual

Vitek

Vitek VTC-LED307BB User manual

Vitek

Vitek VTD-MVH2910/L35 User manual

Vitek

Vitek VT-PTZ220N User manual

Vitek

Vitek VTC-TNT5RMEA User manual

Vitek

Vitek Alpha VTD-A2812/I User manual

Vitek

Vitek TRANSCENDENT VTC-THT10R2F User manual

Vitek

Vitek VT-PTZ36W Manual

Vitek

Vitek VT-TPTZ10HR-2A4 User manual

Vitek

Vitek VTC-TNT5RFEB-2 User manual

Popular Security Camera manuals by other brands

Okina USA

Okina USA SIR36-870VF650LP user manual

Divio

Divio NDR155PA user manual

Canon

Canon VB-C500D Specifications

Easy Access

Easy Access EasyGuard user manual

Vivotek

Vivotek FD9389-EHV-v2 Quick installation guide

TUYA

TUYA COSMO W2 manual

Eusso

Eusso UNC7500-IR Advanced installation guide

urmet domus

urmet domus 1096/204 user manual

VC VC20 series operating manual

Axis

Axis Q1614 installation guide

ieGeek

ieGeek DD201 manual

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Installation and user guide

Vicon

Vicon V662-D-1 Installation and operation guide

Grundig

Grundig GCH-K0274P owner's manual

Lorex

Lorex VANTAGE LBC7032 quick start guide

4xem

4xem WPT Specifications

Samsung

Samsung SCV-3082 Specifications

Lumens

Lumens VC-A50PNW installation guide