V-tech Marble Rush User manual
Marble Rush™
LaunchPad Set™
We aim to reduce our environmental impact and have reduced
the amount of paper used for our printed manuals. The full
version of the manual is available online through the following
link or by scanning the QR code.
TM & © 2021 VTech Holdings Limited. All rights reserved.
Printed in China.
91-003989-005 US
Quick Start Guide
vtechkids.com/guides
2
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel car il comporte des informations
importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a coin or screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
3
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to
be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
WWARNING:
CHOKING HAZARD -Toy contains small parts and small balls.
Not for children under 3yrs.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4
12
6
7
8
11
12
13
14
15
16
17
10
9
3
4
5
LABEL APPLICATION
Please securely stick the labels to the playset as indicated below:
5
1
6
2
78 8
4 5
10
13
3
11
14 15 16
9
1712
B-02
M-02
T-04
B-04
T-03
M-01
M-05
M-06
T-01
M-07
M-11
T-02
M-04
M-14
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be used for an extended period
of time.
4. Do not drop the unit on hard surfaces or expose the unit to moisture or
water.
6
TROUBLESHOOTING
If for some reason the unit stops working , please follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a brand new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling out our
Contact Us form located under the Customer Support link. Creating
and developing VTech products is accompanied by a responsibility that
we take very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that we
stand behind our products and encourage you to contact us with any
problems and/or suggestions you might have. A service representative
will be happy to help you.
Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
7
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5422
Product Name: Marble Rush™ LaunchPad Set™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200,
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
Marble RushTM/MC Launchpad Set
Manuel d'utilisation
91-003989-002 CA
2
INTRODUCTION
Félicitation! Tu viens d'acquérir le Marble RushTM/MC Launchpad Set de
VTechMD!
Prépare-toi pour une course de billes incroyable! Construis un parcours et
lance les billes pour les voir en mouvement continu et rivaliser avec tes amis
et ta famille dans des super défis animés par des sons et lumières.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
Il est conseillé de sauvegarder ce manuel d'utilisation car il comporte des
informations importantes.
WARNING:
All packing materials such as tape, plastic sheets, packaging locks, removable
tags, cable ties, cords and packaging screws are not part of this toy, and should
be discarded for your child’s safety.
NOTE: Please save this user's manual as it contains important information.
ALIMENTATION
Installation des piles
1. Avant d'insérer les piles, s'assurer que le
jouet est éteint.
2. Ouvrir le compartiment à piles situé au dos
de la fusée à l'aide d'une pièce ou d'un
tournevis.
3. Si des piles sont présentes dans le jouet,
retirer ces piles en tirant sur l’une des
extrémités.
3
4. Insérer 2 piles LR6/AA en respectant le schéma qui se trouve dans le
compartiment à piles. Pour de meilleures performances, il est recommandé
d'utiliser des piles alcalines ou des piles rechargeables Ni-MH pleinement
rechargées.
5. Refermer soigneusement le couvercle du compartiment et s'assurer que
la vis est bien serrée.
ATTENTION
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en magasin
mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les polarités
+ et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-carbone et
rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en court-circuit
(en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES :
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour les
recharger.
• Les accumulateurs ne doivent être chargés que sous la surveillance d’un
adulte.
• Ne pas tenter de recharger des piles non rechargeables.
Other manuals for Marble Rush
2
This manual suits for next models
1
Table of contents
Languages:
Other V-tech Toy manuals
V-tech
V-tech Alphabert s Magic Readport User manual
V-tech
V-tech Alphabet Picture Desk User manual
V-tech
V-tech Launch & Chase Police Tower User manual
V-tech
V-tech Write & Learn Notepad User manual
V-tech
V-tech V.Smile: Disney s The Little Mermaid Ariel s Majestic... User manual
V-tech
V-tech Magical Lights Unicorn Assembly Instructions
V-tech
V-tech Roll & Surprise Animal Train User manual
V-tech
V-tech Lil Smart Top User manual
V-tech
V-tech V.Smile Smart Keyboard User manual
V-tech
V-tech Light Up Carousel User manual
V-tech
V-tech Animal Rhymes Storytime User manual
V-tech
V-tech SWITCH & GO Scorpion Dune Buggy User manual
V-tech
V-tech Zoo Jamz Tiger Rock Guitar User manual
V-tech
V-tech Happy Lights Bear User manual
V-tech
V-tech Switch & Go Dino - Blister the Velociraptor User manual
V-tech
V-tech 3-in-1 Smart Wheels User manual
V-tech
V-tech MobiGo Disney Pixar Cars 2 User manual
V-tech
V-tech Go!Go! Smart Wheels Park & Learn Deluxe... User manual
V-tech
V-tech Bugsby Reading System User manual
V-tech
V-tech Drop & Go Dump Truck User manual
